Instrukcja obsługi Metra Electronics DODGE 99-6540

Streszczenie treści zawartej na stronie nr. 1

KIT FEATURES
5 6
A
Shaft and
DIN unit
B
"A"
provisions
99-6540
C
D
INSTALLATION
KIT COMPONENTS
INSTRUCTIONS
Radio Housing
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
APPLICATIONS
Locate the factory wiring harness in the
Locate the upper dash tab in the sub-dash and
dash. Metra recommends using the bend the tab down. ("A")
CAR PAGE
proper mating adaptor and making
connections as shown. (Isolate and
DODGE
Faceplate
individually tape off the end

Streszczenie treści zawartej na stronie nr. 2

3 ALL VEHICLES 1 1½" 3/8" Disconnect the negative battery terminal to prevent an accidental short circuit. Open the glove Using the dimensions above, cut and remove the rear portion of the factory pocket from the box and remove (2) Phillips screws securing the right edge of the dash trim bezel. Remove (5) radio trim bezel. screws from the bottom of the dash trim bezel. Pull out on the upper edge of the bezel and remove. 2 4 2-SHAFT HEAD UNITS: Slide the aftermarket head unit into the kit a