Streszczenie treści zawartej na stronie nr. 1
WS-7058U
Wireless 433 MHz
Wireless Weather Center
Instruction Manual
Streszczenie treści zawartej na stronie nr. 2
TABLE OF CONTENTS Topic Page Inventory of Contents/Additional Equipment: 3 Quick Set-Up Guide: 3 Detailed Set-Up Guide Battery Installation: 4-5 LCD Screens: 5 Program Mode Function Buttons: 6 LCD Contrast: 6 12/24-hour Time Display: 6 Time Setting: 6-7 Time Zone Setting: 7 Date Setting: 7 Selecting °F or °C and Inches or Millimeters: 7-8 Setting Forecast Sensitivity: 8 Displaying Relative/Absolute hPa/inHg: 8-9 M
Streszczenie treści zawartej na stronie nr. 3
INVENTORY OF CONTENTS Figure 1 1. WS-7058U—Wireless Weather Center, with table stand (Figure 1). 2. TX4U—Remote Thermo-Hygro (temperature- humidity) Sensor: Figure 2 includes a mounting bracket/receptor, rain cover, two mounting screws, and adhesive tape (Figure 2). Figure 3 3. TX5U—Rainfall Sensor: includes a base, rainfall collector, and two mounting screws (Figure 3). 4. Instruction manual and warranty card. ADDITIONAL EQUIPMENT (not included) 1. Seven fresh 1.5V AA bat
Streszczenie treści zawartej na stronie nr. 4
DETAILED SET-UP GUIDE I. BATTERY INSTALLATION Batteries will fit tightly. To avoid start-up problems, make sure that the batteries do not spring free. A. REMOTE THERMO-HYGRO SENSOR Mounting Bracket/Receptor Battery Cover Rain Cover Thermo-Hygro Sensor 1. Pull the cylindrical rain cover off the sensor. 2. Remove the battery cover (located on the backside of the sensor, above the mounting post and bracket). Press the arrow and slide the battery cover off. 3. Observing th
Streszczenie treści zawartej na stronie nr. 5
C. WEATHER CENTER 1. Remove the battery cover. To do this, place a solid Hanging Hole object in the space provided at the lower- central position of the battery cover (the cover has white writing on it) Battery Cover then push up and pull out on the battery cover. 2. Observe the correct polarity, and install three Removable Table AA batteries. Stand 3. Replace the battery cover. THE LCD SCREEN Immediately after the batteries have been installed, the LCD (Liquid Crystal
Streszczenie treści zawartej na stronie nr. 6
PROGRAM MODE The Program Mode is laid out in a manner that allows you to program each function separately, or you can follow the instructions entirely to program the Weather Center. Complete programming is usually done for the initial set-up, and will require you to skip step 1 of each programming section (from section III to XI). The programming mode can be exited at any time by either pressing the OUTDOOR button, or waiting for the 20-second time-out to take effect. I. FUNCTION BU
Streszczenie treści zawartej na stronie nr. 7
4. Press the SET button to confirm, and advance to set the minutes. 5. The minute digit will flash in LCD 1. Press the + button to advance the minutes (holding the + button down will advance the minutes in increments of five). 6. Press the SET button to confirm, and to advance to the Time Zone setting. V. TIME ZONE SETTING This is a feature available on the WS-7058U, it is designed for use in Germany. You may ignore this feature. 1. Press the SET button five times to enter this
Streszczenie treści zawartej na stronie nr. 8
4. Press the SET button to confirm, and to advance to set the Weather Forecast Sensitivity. VIII. WEATHER FORECAST SENSITIVITY SETTING Note: A higher hPa (Hekto Pascal) setting decreases the forecasting sensitivity of the unit, this feature is available for persons living in areas where air pressure changes are significant (not necessarily related to a change of weather). A lower hPa setting is available for areas with a more constant air pressure. This designates that it takes 2 hP
Streszczenie treści zawartej na stronie nr. 9
displayed, the next setting mode will be to Manually set the Relative Air Pressure. X. MANUALLY SETTING THE RELATIVE AIR PRESSURE 1. Press the SET button twelve times to enter the Manual Setting of the Relative Air Pressure mode. 2. The air pressure digits in LCD 5 will flash. Press the + button to adjust the Relative Air Pressure to an appropriate one. Check the local weather service. 3. Press the SET button to confirm, and to advance to select the Bar Graph Display. XI. SELEC
Streszczenie treści zawartej na stronie nr. 10
1. Press the INDOOR button. The Current Indoor temperature in LCD 2 shifts to a display of the minimum recorded indoor temperature, with a “MIN” between the temperature and humidity. The recorded time simultaneously displays. Press the INDOOR button to display the recorded date in LCD 1. 2. Press the INDOOR button a third time. The minimum temperature in LCD 2 shifts to the recorded maximum temperature, with the recorded time in LCD 1. Press the INDOOR button a fourth time to view t
Streszczenie treści zawartej na stronie nr. 11
A. WEATHER ICONS There are 3 possible weather icons that will be displayed at various times in LCD 3: Sunny Sun with Clouds Clouds with Rain Sunny—indicates that the weather is expected to improve (not that the weather will be sunny). Sun with Clouds—indicates that the weather is expected to be fair (not that the weather will be sunny with clouds). Clouds with Rain—indicates that the weather is expected to get worse (not that the weather will be rainy). The weather icons change whe
Streszczenie treści zawartej na stronie nr. 12
D. COMFORT LEVEL INDICATOR The comfort level indicator appears in the center portion of LCD 2 (between the Indoor temperature and the Indoor humidity) as either a “happy-face” or as a “sad-face”. The indicator will display a “happy- face” when the temperature is between 68 °F and 79 °F (20 °C and 25.9 °C), and the humidity is between 45% and 64%. A “sad-face” will be displayed when the temperature and humidity are outside the mentioned ranges. If the humidity is below 45% the word
Streszczenie treści zawartej na stronie nr. 13
pressure (in LCD 5) to evaluate what past air pressures have been. Air pressure trends can be determined by simply glancing at the bar graph. If the bars are rising (higher on the right than the left) then the air pressure has a rising trend, and the weather should improve. If the bars are dropping (lower on the right than the left) then the air pressure has a falling trend, and the weather should worsen. A. RAINFALL HISTORY The bar graph will also display the rainfall history; this
Streszczenie treści zawartej na stronie nr. 14
To toggle through the 3 different quantities: 1. Press the RAIN button, the rain icon will appear. 2. Press the RAIN button again, “1h” appears. 3. Press the RAIN button a third time, no icon will be visible. VI. RESETTING RAINFALL INFORMATION A. RAINFALL QUANTITY TOTALS Resetting the Rainfall Quantity Totals will clear the numeric data held under “TOTAL,” resetting to 0.00 (appearing in LCD 5). From any selected normal display mode: 1. Press and hold the RAIN button for 3
Streszczenie treści zawartej na stronie nr. 15
7. Use the + button to change the first digit to a 3 and press the SET button to enter the normal mode. The Weather Center will enter into normal operating mode. Do not press any buttons while the Weather Center searches for transmisssion signals. 8. Follow Program Mode for set-up proceedures. C. HARD RESET OF EEPROM WEATHER CENTER MEMORY Note: This is to be used if there are problems with transmission, or if the rainfall history bar graph needs to be cleared. 1. Remove the batteri
Streszczenie treści zawartej na stronie nr. 16
Note: When setting up multiple sensors it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the sensors, and in numeric sequence. Second install batteries into the Weather Center. Transmission problems will arise if this is not done correctly and if the total time for set-up exceeds 6 minutes A. SET-UP OF MULTIPLE SENSORS Note: The first sensor signal that the Weather Center receives is nd automatically assigned as
Streszczenie treści zawartej na stronie nr. 17
Place all units in their desired location, and wait approximately 15 minutes before permanently mounting to ensure that there is proper reception. The Weather Center should display an outdoor temperature in LCD 6 within 5 minutes of setting up. If the Weather Center loses the signal from the sensor, it will display the last temperature reading for 15 minutes. After 15 minutes of not receiving any signals, LCD 6 will display “- -.-”. LCD 5 should show “0.0” within 6 minutes of receiving
Streszczenie treści zawartej na stronie nr. 18
3. Remove the protective strip from the other side of the tape, and situate the mounting bracket. Firmly press the mounting bracket onto the mounting surface. 4. Fit the mounting post into the receptor of the mounting bracket. II) THE TX5U—RAINFALL SENSOR The Rainfall Sensor can be mounted in two ways: • Simply placing it in a desired location, or • Mounting it to a surface with the provided screws. Ensure that the Rainfall Sensor is completely horizontal and stable. 2) Rotate
Streszczenie treści zawartej na stronie nr. 19
III) THE WS-7058U—WEATHER CENTER The Weather Center can be mounted in 2 ways: • With the included table stand, or • By mounting to a wall. A) TABLE STAND 1) Insert the larger, front tab of the table stand into the receptacle underneath the Weather Center (if held upright). 2) Push up on the back of the table stand until the two tabs on the back snap into place. 3) Place the Weather Center in an appropriate location, where transmission signals can be received. 4) To remove the t
Streszczenie treści zawartej na stronie nr. 20
MAINTENANCE AND CARE • Extreme temperatures, vibrations, and shock should be avoided to prevent damage to the units. • Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents—they may mark and damage the displays and casings. • Do not submerge in water. • Immediately remove all low powered batteries to avoid leakage and damage. Replace with new batteries only, and of recommended size. • Opening the casings invalidates the warranty. Do not try to repa
