Streszczenie treści zawartej na stronie nr. 1
R
User Guide
Model VP-12S1
TM
DLP Projector
Streszczenie treści zawartej na stronie nr. 2
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning symbol in the triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation mark in the triangle is intended to alert the u
Streszczenie treści zawartej na stronie nr. 3
IMPORTANT SAFETY INSTRUCTIONS READ BEFORE OPERATING EQUIPMENT This product was designed and manufactured to meet strict quality 12. Power-Cord Protection: Protect the power code from being and safety standards. There are, however, some installation and walked on or pinched particularly at plugs, convenience operational precautions which you should be particularly aware of. receptacles, and the point where they exit from the apparatus. 1. Read these Instructions: All the safety and operating 13.
Streszczenie treści zawartej na stronie nr. 4
ENGLISH TABLE OF CONTENTS FEATURES ................................................................................................................... 1 PROJECTOR LAYOUT AND FUNCTIONAL OVERVIEW ........................................... 2 INTRODUCTION Front and Top .................................................................................................... 2 Right Side and Rear .......................................................................................... 3 Bottom ..........
Streszczenie treści zawartej na stronie nr. 5
INTRODUCTION FEATURES 7 7 Optics Electronics & Software • Texas Instruments Digital Light Processing Technology • Full Digital device TM • High Definition Panel (1280 x 720), DMD HD • 3 Faroudja Chips Inside (Decoder, Doubler, and Enhancer) • 16 : 9 Aspect Ratio • 3-2 pull down • Newly developed custom optics by Minolta • 10-Bit Digital Gamma Processing • 1200 : 1 Contrast Ratio • Horizontal Keystone Correction • 700 ANSI Lumens Brightness • 480p, 720p,1080i adapted • Brightness Uniformity : 90
Streszczenie treści zawartej na stronie nr. 6
6 2 M O O Z ENGLISH A T L O N I M y b s c PROJECTOR LAYOUT AND FUNCTIONAL OVERVIEW Front and Top !3 !1 o i q !0 !6 !5 !4 w q VP-12S1 r e r uty !2 q IR sensor (front and rear) o POWER ON indicator Lights up when the power is turned on. Flashes while the w Projection Lens projector goes into standby mode for about one minute. e Ventilation holes !0 STANDBY indicator Lights up when the power is turned off. Notes: • Do not place anything near the ventilation holes to avoid !1 MENU key overheat insid
Streszczenie treści zawartej na stronie nr. 7
INTRODUCTION Right Side and Rear ⁄7 VP-12S1 v zc x bn ⁄5 ⁄6 ⁄3 , ⁄0 ⁄4 m ⁄2 . ⁄1 z COMPONENT VIDEO IN m AUX AUDIO OUT (DIGITAL) Y, PB/CB, PR/CR connectors. Connect the COAXIAL input from an audio equipment. Connect the COMPONENT VIDEO output from video Audio out terminal of DV-IN signal. equipment or an A/V processor/receiver with a component video output. , REMOTE CONTROL IN/OUT By connecting this projector to another Marantz audio x S-VIDEO IN component using a supplied System Control cable, y
Streszczenie treści zawartej na stronie nr. 8
ENGLISH ⁄1 TRIG.2(TRIGGER 2) Select ON or OFF at each aspect mode, such as Full, Normal, Zoom, and Through to control screen aspect ratio with powered up/down dual aspect ratio screen. Note: Do not use TRIG.1 and TRIG.2, as the power source. ⁄2 LIGHT ON/OFF Select ON : The connector panel lights up. ⁄3 RS232C Connect the RS232C of equipment for external control. ⁄4 AC IN Connect the supplied AC power code. ⁄5 Lamp cover ⁄6 Lamp cover securing screw ⁄7 Ventilation holes Notes: • Do not place anyt
Streszczenie treści zawartej na stronie nr. 9
INTRODUCTION Bottom w q q q Adjustment lever w Ventilation holes Notes: Lift the projector and turn the adjustment lever right or left. • Do not place anything near the ventilation holes to avoid The adjustable feet will extend from the projector. Then, overheat inside the unit. release the lever, the adjustable feet is locked. • Do not place your hand or objects near the ventilation holes; the air is coming out. Height Adjustment How to use adjustable feet and adjustment lever. (1) Release the
Streszczenie treści zawartej na stronie nr. 10
ENGLISH l RGB key Remote Controller Select the RGB IN signal. ¡0 THEATER key Select the Theater picture mode. When the key is pressed, the mode toggles Theater1, Theater2, Theater3 and Theater Default. ¡1 STANDARD key Select the STANDARD picture mode. s a When the key is pressed, the mode toggles Standard1, Standard 2, Standard 3, and Standard Default. d ¡2 DYNAMIC key Select the Dynamic picture mode. When the key is pressed, the mode toggles Dynamic1, h f Dynamic2, Dynamic3 and Dynamic Default
Streszczenie treści zawartej na stronie nr. 11
INTRODUCTION Preparing the Remote Controller CAUTION 1. Open the cover. – The available battery types are limited: manganese dry cell and alkaline dry cell. – Do not mix different battery types. – Do not mix old and new batteries. – Only batteries of the same type are to be used. – Remove exhausted batteries from the Remote Controller. – Do not attempt to recharge non-rechargeable batteries. – Do not use rechargeable batteries. – Batteries are to be inserted with the correct polarity. – The supp
Streszczenie treści zawartej na stronie nr. 12
ENGLISH INSTALLATION Recommended Setting 7 Table Top Side view Adjust the vertical and horizontal positions of the projector. Horizontal center of the screen Flat view 7 Ceiling Installation Ceiling Throw distance Note : Lens shift position is at Full up. CAUTION – For ceiling installation, consult with Marantz authorized dealer. – Do not look into the lens when the projector is turned on. It could damage your eyesight. 8 VP-12S1
Streszczenie treści zawartej na stronie nr. 13
SET UP PROCEDURES Distance between the projector and the screen (throw distance) Screen size (Diagonal) VP-12S1 Throw distance 16:9 screen 4:3 screen Screen Size Throw distance Throw distance (Diagonal) Minimum Maximum Minimum Maximum 7 11 1 3 50 /16 inch 58 /16 inch 46 /4 inch 53 /4 inch 40 inch 1,281 mm 1,491 mm 1,172 mm 1,365 mm 9 1 9 76 /16 inch 89 inch 70 /8 inch 81 /16 inch 60 inch 1,945 mm 2,260 mm 1,782 mm 2,071 mm 3 1 3 5 102 /4 inch 119 /4 inch 94 /16 inch 109 /16 inch 80 inch 2,609 mm
Streszczenie treści zawartej na stronie nr. 14
ENGLISH Image Position Adjustment You can adjust the image position with the Lens Shift knob. 7 Turn the Lens Shift knob to clockwise : The image goes up. • Maximum range to throw up : Bottom of the image correspond to the center of the Projection Lens. Clockwise Up 7 Turn the Lens Shift knob to counterclockwise : The image goes down. • Maximum range to throw down : Top of the image correspond to the center of the Projection Lens. Counterclockwise Down 10
Streszczenie treści zawartej na stronie nr. 15
SET UP PROCEDURES Advanced Setting When the projecting image is a trapezoid, correct it in Keystone-V and/or Keystone-H in the Display Menu. Picture Adjust Keystone V 50 Setting Keystone H 50 Display Auto Adjust Config Picture Shift V 50 Trigger 2 Size V 50 Memory Picture Shift H 50 Size H 50 Phase 50 7 7 Keystone-V(Electronic vertical keystone correction) Keystone-H(Electronic horizontal keystone correction) Note : Electronic horizontal keystone correction works properly when the lens shift pos
Streszczenie treści zawartej na stronie nr. 16
ENGLISH The Screen Images in a Wide screen (16:9) • Press the ZOOM key, the NORMAL key or the FULL key on the remote controller for the 4:3 aspect ratio video source. • Press the FULL key on the remote controller for 16:9 aspect ratio video source, such as 1080i, 1035i, and 720p video systems. • Press the FULL key on the remote controller for the squeezed video source. 7 Original Source Image 16 : 9 video source 4 : 3 video source 7 Full mode The 16:9 squeezed image is displayed with the corre
Streszczenie treści zawartej na stronie nr. 17
SET UP PROCEDURES The Screen Images in a 4:3 screen • Press the ZOOM key, the NORMAL key or the FULL key on the remote controller for the 4:3 aspect ratio video source. • Press the FULL key on the remote controller for 16:9 aspect ratio video source, such as 1080i, 1035i, and 720p video systems. • Press the FULL key on the remote controller for the squeezed video source. 7 Original Source Image 16 : 9 video source 4 : 3 video source 7 Full mode The 16:9 squeezed image is displayed with the cor
Streszczenie treści zawartej na stronie nr. 18
ENGLISH CONNECTION When making connections be sure to: • Turn off all equipment before making any connections. • Use the proper cables for each connection. • Insert the plug properly. Any plugs that are not fully inserted often generate a noise. When pulling out a cable: • Be sure to grab the plug, not the cable itself. Connections with Video equipments COMPONENT VIDEO OUT DVD S-VIDEO OUT VIDEO OUT VCR Connection with a HD-Video or PC RGB OUT HD Set Top Box / BS Tuner RGB OUT Computer 14
Streszczenie treści zawartej na stronie nr. 19
SET UP PROCEDURES Connection with a DV camcoder DV-SD OUT DV camcoder DIGITAL AUDIO IN Receiver equipment with a Dolby Digital decoder Note: DV IN connector is available for DV-SD format of i.LINK(IEEE1394). Advanced connection RS-232C External Controller Screen 35mm Mini Plug (Mono) Ferrite core REMOTE CONTROL IN REMOTE CONTROL OUT Control Adapter cable Receiver equipment with a Dolby Digital decoder 15 ENGLISH
Streszczenie treści zawartej na stronie nr. 20
ENGLISH INITIAL SET UP 1. Connect the supplied AC power cord. The STANDBY indicator lights up and the projector goes into the standby mode. 2. Press the POWER ON key on the remote controller or the POWER key on the projector. The POWER indicator lights up. 3. Press the FOCUS key on the remote controller to display the FOCUS pattern and turn the Focus ring to make an adjustment. Adjust the focus for the sharpest image possible to obtain, using focus pattern. Press the FOCUS key again to clear off
