Streszczenie treści zawartej na stronie nr. 1
ASU9CQ
ASU12CQ
AOU9CQ
AOU12CQ
Streszczenie treści zawartej na stronie nr. 2
Fig. 1 Indoor Unit Fig. 6 Remote Control Unit H MASTER CONTROL button 1 Operating Control Panel (Fig. 2) I SET TEMP. / SET TIME buttons (+/-) 2 AIR CLEANER RESET / MANUAL AUTO J Signal Transmitter button K TIMER button Intake grill opening mechanism. L FAN CONTROL button When the remote control is not available for use, this button can be used as a M START/STOP button Quick-start button. However when the N AIR CLEAN button Air Cleaning check function (see page 13) O SET button is in operation,
Streszczenie treści zawartej na stronie nr. 3
FEATURES AND FUNCTIONS SLEEP TIMER SUPER QUIET OPERATION When SLEEP is selected be pressing TIMER button during When the FAN CONTROL button is used to select QUIET, Heating mode, the air conditioner’s thermostat setting is the unit begins super-quiet operation; the indoor unit’s air- gradually lowered during the period of operation; during flow is reduced to produce quieter operation. Cooling or Dry mode, the thermostat setting is gradually raised during the period of operation. When the set tim
Streszczenie treści zawartej na stronie nr. 4
PREPARATION CAUTION! Turn on the Power Take care to prevent infants from accidentally swallowing batteries. In the case of a direct line connection, turn on the circuit When not using the remote control unit breaker. for an extended period, remove the batteries to avoid possible leakage and damage to the unit. If leaking battery fluid comes in contact with your skin, eyes, or mouth, immedi- Load Batteries (R03 / LR03 ××××× 2) ately wash with copious amounts of water, and consult your phy
Streszczenie treści zawartej na stronie nr. 5
OPERATION To Select Mode Operation Press the START / STOP button (Fig.6 M). 1 The indoor unit’s OPERATION indicator lamp (red) (Fig. 3 5) will light. The air conditioner will start operating. Press the MASTER CONTROL button (Fig.6 H) to se- 2 lect the desired mode. Each time the button is pressed, the mode will change in the following order. s s s AUTO COOL DRY t FAN Example: When set to COOL. About three seconds later, the entire display will reappear. To Set the Thermostat Press the SET TEMP.
Streszczenie treści zawartej na stronie nr. 6
OPERATION About Mode Operation AUTO: Depending on the room temperature at the time operation begins, the During Cooling/Dry mode: operating mode will be switched automatically as shown in the Set the thermostat to a temperature set- accompanying table. ting that is lower than the current room Also, depending on the operating mode, the room temperature set- temperature. The Cooling and Dry modes will not operate if the thermostat is set ting will cause the “standard” temperature to be set as sh
Streszczenie treści zawartej na stronie nr. 7
AIR CLEANING OPERATION If you wish to eliminate dirt,dust,cigarette smoke, pollen, or just simply purify the air of the room, use the Air Cleaning Mode. Press the START/STOP button (Fig. 6 M). 1 The operation indicator lamp will light up (red, as shown in the figure). (If the unit is already in operation, please proceed to step 2.) Press the AIR CLEAN button (Fig. 6 N). 2 The AIR CLEAN indicator lamp (Fig. 3 7) will light up (green, as shown in the figure). Air conditioning and Air Cleaning wi
Streszczenie treści zawartej na stronie nr. 8
TIMER OPERATION Before using the timer function, be sure that the Remote Control Unit is set to the correct current time, see page 4. To Use the ON timer or OFF timer To Cancel the Timer Press the START / STOP button (Fig. 6 M). Use the TIMER button to select “TIMER 1 RESET.” (if the unit is already operating, proceed to step 2). The air conditioner will return to normal The indoor unit's OPERATION Indicator Lamp (red) (Fig. 3 5) will light. operation. To Change the Timer Settings Press the TIME
Streszczenie treści zawartej na stronie nr. 9
SLEEP TIMER OPERATION Unlike other timer functions; the SLEEP timer is used to set the length of time until air conditioner operation is stopped. To Use the SLEEP Timer To Cancel the Timer: While the air conditioner is operating or stopped, Use the TIMER button to select “TIMER 1 press the TIMER button (Fig. 6 K). RESET”. The indoor unit's OPERATION Indicator Lamp (red) (Fig. 3 5) lights and The air conditioner will return to normal the TIMER Indicator Lamp (green) (Fig. 3 6) light. operation. T
Streszczenie treści zawartej na stronie nr. 10
ADJUSTING THE DIRECTION OF AIR CIRCULATION Vertical (up-down) direction of airflow is adjusted by pressing the Remote Control Unit’s SET button. Horizontal (right-left) airflow direction is adjusted manually, by moving the Air Flow Direction Louvers. Whenever making horizontal airflow adjustments, start air conditioner operation and be sure that the vertical air direction louvers are stopped. Vertical Air Direction Adjustment R DANGER! Never place fingers or foreign objects in- Press the SE
Streszczenie treści zawartej na stronie nr. 11
SWING OPERATION Begin air conditioner operation before performing this procedure. To select SWING Operation Press the SWING button (Fig. 6 P). The SWING indicator lamp (orange) (Fig. 3 8) will light. In this mode, the Air Flow Direction Louvers will swing automatically to direct the air flow both up and down. To Stop SWING Operation Press the SWING button (Fig. 6 P) once again. The SWING indicator lamp (orange) (Fig. 3 8) will go out. Airflow direction will return to the setting before swing was
Streszczenie treści zawartej na stronie nr. 12
CLEANING AND CARE Before cleaning the plasma filter unit, be sure to turn off the power supply to the air conditioner. WARNING! Electric shock may result. Make sure the plasma filter unit is properly mounted before cleaning or performing other tasks CAUTION! on it. If the unit is not properly mounted, it could fall off and cause damage or injury. You can be injured if you touch the heat exchanger when removing or installing the plasma filter unit. Do not insert your fingers between the pla
Streszczenie treści zawartej na stronie nr. 13
CLEANING THE PLASMA AIR CLEANING FILTER Before cleaning the plasma filter unit, be sure to turn off the power supply to the air conditioner. WARNING! Electric shock may result. Make sure the plasma filter unit is properly mounted before cleaning or performing other tasks CAUTION! on it. If the unit is not properly mounted, it could fall off and cause damage or injury. You can be injured if you touch the heat exchanger when removing or installing the plasma filter unit. Do not insert your f
Streszczenie treści zawartej na stronie nr. 14
Cleaning the dust collection unit 4. Install the unit. 5. Install the air filter. (The above figure is only for reference, so the intake grille Please consult instructions for cleaning the air filter is not included.) on page 12. 6. Close the intake grille. Push the intake grill in at 4 points (the two ends of its lower side as well as two center points of the lower side, as shown in the figure) to close it. 1 Align the two ends of the dust collection Please ensure that the intake grille is u
Streszczenie treści zawartej na stronie nr. 15
How to install or remove the Air- Air-cleaning and Deodorizing filter cleaning and Deodorizing filter maintenance As well as ensuring the maintenance of the dust collecting 1. Remove the dust-collecting unit. unit, please also take care of the filter. Please consult steps 1 and 2 of cleaning the dust- (Please carry out maintenance on the filter every 6 months.) collecting unit on page 13. 1. Open the intake grille and remove the air 2. Install or remove the Air-cleaning and filter from the rig
Streszczenie treści zawartej na stronie nr. 16
TROUBLESHOOTING In the event of a malfunction (burning smell, etc.), immediately stop operation, disconnect the WARNING! Power Supply Plug, and consult authorized service personnel. Merely turning off the unit’s power switch will not completely disconnect the unit from the power source. Always be sure to disconnect the Power Supply Plug or turn off your circuit breaker to ensure that power is completely off. Before requesting service, perform the following checks: Symptom Problem See Page Doesn’
Streszczenie treści zawartej na stronie nr. 17
TROUBLESHOOTING Symptom Items to check See Page Is the Power Supply Plug disconnected its outlet? CHECK ONCE Doesn’t operate at all: MORE Has there been a power failure? — Has a fuse blown out, or a circuit breaker been tripped? Is the timer operating? 8 - 9 Is the air filter dirty? Air the air conditioner’s intake grille or outlet port blocked? Poor Cooling or Heating Did you adjust the room temperature settings (thermostat) performance: correctly? Is there a window or door open
Streszczenie treści zawartej na stronie nr. 18
OPERATING TIPS Temperature and Humidity Range Cooling/Dry Mode Outdoor temperature About 32 to 115 °F Indoor temperature About 64 to 90 °F Outdoor temperature About 80% or less 68°F or obove If the unit is used for long periods under high-humidity conditions, condensation may form on the surface of Indoor Humidity the indoor unit, and drip onto the floor or other objects Outdoor temperature About 50% or less underneath. below 68°F En-18
