Instrukcja obsługi Clarion SA200

Streszczenie treści zawartej na stronie nr. 1

SA200
d
INSTALLATION GUIDE
Introduction
The Clarion SA200, a Sirius Satellite Radio approved
antenna, has been designed and engineered to receive
signal transmissions for Sirius' three satellites and network of
ground-based repeaters. This is a finely tuned antenna intended
to receive satellite signals throughout North America under
diverse conditions. It is imperative to read and understand
the "Installation Guide" to ensure optimum performance of the
satellite antenna.

Streszczenie treści zawartej na stronie nr. 2

d I n s t a l l a t i o n R e q u i r e m e n t s Due to the complexity of vehicle electronics and assembly, it is essential to posses the necessary skills and knowledge prior to attempting this installation. If you do not have the confidence to attempt this installation, contact a local installation facility in your area. M o u n t i n g L o c a t i o n The SA200 should be mounted horizontally onto a metal surface measuring at least 18" x 18", preferably at the highest point of the vehicle.

Streszczenie treści zawartej na stronie nr. 3

SA200 Installation Temperature To achieve the best adhesion, a heat gun can used to warm up the double-sided tape on the SA200 and surface of the vehicle. With these surfaces warmed up, the adhesion of the antenna to the vehicle will be more secure. The heat gun can also be used to warm up the rubber moldings surrounding the rear window, allowing the routing of the antenna cable to be easier. Be careful not to damage the paint or melting the rubber molding. Sedan Vehicle Installation The S

Streszczenie treści zawartej na stronie nr. 4

d Convertible Vehicle Installations On convertible vehicles (and some sedans that don't have sufficient space under the window moldings) the antenna module should be mounted on the center of the trunk lid approximately 6 inches away from the rear window. 1. Follow Step 1-4 of Sedan Vehicle Installation. 2. Route the cable from the antenna along the edge of the trunk lid underneath the lid. (Cable clamps maybe necessary to hold the antenna cable in place when access holes on the trunk lid a

Streszczenie treści zawartej na stronie nr. 5

SA200 Pick-Up Truck Installation The antenna module should be mounted on the centerline of the roof approximately 4 inches from the rear of the cab. 1. Follow Step 1-4 of Sedan Vehicle Installation. · If the molding for the brake light is made out of rigid plastic, it might be necessary to drill a small hole or slot to route the cable. Seal the hole with silicone compound after the installation. 2. Route the cable through the interior trim to where the receiver is located. It is

Streszczenie treści zawartej na stronie nr. 6

d Specifications Electrical Data: Antenna Passive Gain (SAT) 25 < < 50 ................................................................ 0 dBic 50 < < 70 ................................................................ 4.5 dBic 70 < < 90 ................................................................ 2 dBic Antenna Passive Gain (Terr.) 70 < < 90 ................................................

Streszczenie treści zawartej na stronie nr. 7

Streszczenie treści zawartej na stronie nr. 8

d SA200.2.04 661 W. Redondo Beach Blvd. REV.1 Gardena, CA. 90247 www.clarion.com