Streszczenie treści zawartej na stronie nr. 1
WV-CW974 Cover_E/FR6mm.qxd 07.2.9 1:32 PM ページ1
Color CCTV Camera
Operating Instructions
Model No. WV-CW974
Panasonic System Solutions Company, Panasonic Canada Inc.
Unit Company of Panasonic Corporation of North America 5770 Ambler Drive, Mississauga,
Ontario, L4W 2T3 Canada (905)624-5010
Security Systems
http://www.panasonic.ca
www.panasonic.com/security
For customer support, call 1.877.733.3689
Panasonic Sales Company
Executive Office: Three Panasonic Way 2H-2, Secaucus, New Jersey 07094
Streszczenie treści zawartej na stronie nr. 2
WV-CW974 Cover_E/FR6mm.qxd 07.2.9 1:32 PM ページ3 ENGLISH VERSION NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This CAUTION equipment generates, uses, and can radiate radio frequency RISK OF ELECTRIC SHOCK energy and, if not installed and used in accordan
Streszczenie treści zawartej na stronie nr. 3
Important safety instructions 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Clean only with dry cloth. 6) Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. 7) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 8) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized
Streszczenie treści zawartej na stronie nr. 4
Limitation of liability THIS PUBLICATION IS PROVIDED “AS IS” WITHOUT THIS PUBLICATION COULD INCLUDE TECHNICAL WARRANTY OF ANY KIND, EITHER EXPRESS OR INACCURACIES OR TYPOGRAPHICAL ERRORS. IMPLIED, INCLUDING BUT NOT LIMITED TO, THE CHANGES ARE ADDED TO THE INFORMATION IMPLIED WARRANTIES OF MERCHANTABILITY, HEREIN, AT ANY TIME, FOR THE IMPROVEMENTS OF FITNESS FOR ANY PARTICULAR PURPOSE, OR NON- THIS PUBLICATION AND/OR THE CORRESPONDING INFRINGEMENT OF THE THIRD PARTY'S RIGHT. PRODUCT(S). Disclaime
Streszczenie treści zawartej na stronie nr. 5
Features This Color CCTV Camera is a video surveillance device ■ Privacy Zone Function that incorporates a 1/4-type {1/4"} CCD, a 30x zoom The privacy zone function can mask specific areas of lens, preset and pan and tilt capabilities in a dome the scene from view. configuration. ■ Patrol Function 3 3 3 3 ■ Super Dynamic (SUPER-D ) The patrol function can store manual camera move- SUPER-D 3 can capture clear images of subjects ment routines for automatic playback. For example, whose illuminat
Streszczenie treści zawartej na stronie nr. 6
About the Auto-Tracking Function The camera's auto tracking function operates by using • Rain or snow on the dome cover may reduce image recognition. The client is responsible for performance. Consider placing the camera under understanding and applying the following warnings eaves or some kind of cover. regarding installation and operation necessary to • Use the electronic sensitivity enhancement (page 29) prevent losses due to malfunction or lack of detection if using the camera at night (ap
Streszczenie treści zawartej na stronie nr. 7
8. Do not install the camera near the air outlet of an ■ Note the following to ensure long-term trouble- air conditioner. free operation The lens may become cloudy due to condensation Long operation under high temperatures and high if the camera is used under the following humidity can cause components to deteriorate and conditions. shorten camera life. • Rapid temperature fluctuations by switching the air Make sure the camera is installed in a location where it conditioner on and off. is not d
Streszczenie treści zawartej na stronie nr. 8
■ Consumables ■ Installation precautions Parts having contacts such as the lens-drive motors, ■ Be sure to perform installation work in accor- cooling fan motor and slip-rings inside the camera are dance with proper technical standards for electric subject to wear with time. Contact the nearest service installation. dealer about replacement and maintenance of such parts. ■ Camera Installation Location ■ Cleaning the camera Discuss the installation location for the camera with Turn off the came
Streszczenie treści zawartej na stronie nr. 9
• In a motor vehicle, on a boat, or other areas subject (1) In the rain to strong vibration (This camera is not designed for The picture may be hard to see if the wind blows use in a vehicle.) rain onto the dome cover while it is raining. • Near an air conditioner outlet or any areas subject to (2) In the snow sudden changes in temperature. (Such conditions When it snows, snow may collect on the dome can cause clouding and condensation formation on cover and block some of the picture. (The amou
Streszczenie treści zawartej na stronie nr. 10
CONTENTS Important safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Limitation of liability . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Disclaimer of warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Streszczenie treści zawartej na stronie nr. 11
Construction Alarm Input Connector Alarm Output Connector Video Output Connector Data Port Camera Safety Wire Power Cord for Heater Power Connector Attachment Pipe Upper Base Rear sun shield (provided) Front sun shield (provided) Sun shield (pre-attached at factory) Dome cover (do not remove) Lens The lens cannot replaced. Ensuring Trouble-free Operation • This camera uses a “slip ring” for transmission of electrical power and signals. A dirty slip ring can cause deterioration of picture qua
Streszczenie treści zawartej na stronie nr. 12
ON 1 2 3 4 5 6 7 8 DIP SW1 SW1 START RS485Setting Dip switch settings In a configuration, the camera's RS485 data port is used for camera control by the system controller, the camera's DIP switches must be configured to specify the unit number and communication parameters. You need to set the DIP switches before installing the camera in the ceiling or on a wall. Important: Do not adjust the DIP switches if you are using a coaxial multiplex system, leave them off. 1. Attaching and removing th
Streszczenie treści zawartej na stronie nr. 13
■ Unit Number (DIP Switch 1) The factory default settings of these DIP switches are all OFF. (Coaxial Multiplex System) Table-1 Unit Unit Unit DIP Switch 1 DIP Switch 1 DIP Switch 1 Number Number Number ON ON ON 1 ~ 96 23 46 1234 5678 (page 14 Note) 1234 5678 1234 5678 ON ON ON 1 24 47 1234 5678 1234 5678 1234 5678 ON ON ON 2 25 48 1234 5678 1234 5678 1234 5678 ON ON ON 3 26 49 1234 5678 1234 5678 1234 5678 ON ON ON 4 27 50 1234 5678 1234 5678 1234 5678 ON ON ON 5 28 51 1234 5678 1234 5678
Streszczenie treści zawartej na stronie nr. 14
Unit Unit Unit DIP Switch 1 DIP Switch 1 DIP Switch 1 Number Number Number ON ON ON 69 78 87 1234 5678 1234 5678 1234 5678 ON ON ON 70 79 88 1234 5678 1234 5678 1234 5678 ON ON ON 71 80 89 1234 5678 1234 5678 1234 5678 ON ON ON 72 81 90 1234 5678 1234 5678 1234 5678 ON ON ON 73 82 91 1234 5678 1234 5678 1234 5678 ON ON ON 74 83 92 1234 5678 1234 5678 1234 5678 ON ON ON 75 84 93 1234 5678 1234 5678 1234 5678 ON ON ON 76 85 94 1234 5678 1234 5678 1234 5678 ON ON ON 77 86 95 1234 5678 1234 567 8 1
Streszczenie treści zawartej na stronie nr. 15
Camera installation 2. Disassembling the Camera ■ Mounting the Camera (1) Remove the upper base from the camera by Ceiling mount loosening 3 screws. The screws that are The figure shows an example of the camera mounted removed need to be used during reassembly. on a ceiling with a locally procured bracket. Be careful to not lose them. Turn the upper base Refer to the instructions included with the bracket for and separate it. filling gaps and holes with waterproof material. * Special screw (moun
Streszczenie treści zawartej na stronie nr. 16
START 3. Mounting the Bracket 4. Mounting the camera (1) Fix the bracket to the installation surface using (1) Aim the "START" arrow at the bent portion of the appropriate bolts, nuts or the like (not supplied). leaf spring. Make sure that everything is tightened securely. Bending Leaf Spring Attachment Pipe (2) Be sure to hook the fall prevention wire into the bracket. (2) Fix the attachment pipe to the bracket. (3) Thread cables through the bracket. Connect cables, referring to CONNECTIONS. Fa
Streszczenie treści zawartej na stronie nr. 17
3. Before clamping the sun shield, close the front and ■ Installing the brackets rear sun shields (first latch the hook on the wire Refer to the installation guides provided with the side, and then do the other side). brackets. * Take care that the camera safety wire does not go ■ Attach the brackets to the camera on the inside. 1. Put the waterproof caps (provided) onto the tops of the screws. Camera Safety wire Sun shield 4. Align the arrow ( ) on the rear sun shield with the "START" arro
Streszczenie treści zawartej na stronie nr. 18
Connections Precautions • The following connections should be made by qualified service personnel or system installers in accordance with all local codes. • Turn off the power at the fuse box before starting the installation work, or it so could result in fire, electric shock, personal injury, and material damage. 24 V AC Cable for Heater Separate 2-wire 24 V AC Cable for camera 24 V AC RS485 Data Port Twisted Pair Cable*1 To Matrix Switcher, (RJ-12) etc. Video Output Coaxial Cable (5C-
Streszczenie treści zawartej na stronie nr. 19
How to Assemble the Cable with the Accessory Connector Strip back the cable jacket approx. 3 mm {0.1"} and separate the individual conductors. Approx. Approx. 3 mm {0.1"} 3 mm {0.1"} Wire Wire A Up Up Contact Contact Insert Insert the wire until A position Insert the wire until A position and clamp the contacts. and clamp the contacts. Prepare the individual conductors for clamping. Use MOLEX band tool part number 57027-5000 (for UL- Style Cable UL1015) or 57026-5000 (for UL-Style UL1007) for cl
Streszczenie treści zawartej na stronie nr. 20
RS485 setup The following procedure is to configure the RS485 8. Move the cursor to WAIT TIME, and then tilt the setup when using the system controller to control the joystick left or right to select a wait time setting. camera (pan, tilt, etc.) via the camera's data port. The wait time is the time that the camera should wait before resending data when no receive 1. Display the setup menu (page 24), move the cursor acknowledgement (ACK) is returned after data is to COMMUNICATION O, and then pre
