Instrukcja obsługi SECO-LARM USA Flush-Mount Low-Profile UFO Camera EV-6640-N3WQ

Streszczenie treści zawartej na stronie nr. 1

Flush-Mount Low-Profile
UFO Camera

Manual



Model Video Output Resolution
EV-122C-FVB3Q NTSC 480 TV Lines
EV-6640-N3WQ NTSC 600 TV Lines
EV-122C-PVB3Q PAL 480 TV Lines
EV-6640-P3WQ PAL 600 TV Lines

 Small size - only 3” diameter  Lens rotates to nearly any angle
1
 / ” Sony Super HAD II CCD  Low-profile design blends into nearly
3
any décor
 3.7mm Pinhole lens
 Vandal-resistant metal housing
 Low 0.05 Lux rating


Note: Products with model numbers that en

Streszczenie treści zawartej na stronie nr. 2

ENFORCER Flush-Mount Low-Profile UFO Camera Specifications: NTSC EV-122C-FVB3Q EV-6640-N3WQ PAL EV-122C-PVB3Q EV-6640-P3WQ Type Flush-Mount Low-Profile UFO Camera 1 Image sensor /3” Sony Super HAD II CCD Resolution 480 TVL 600 TVL Lens 3.7mm Pickup NTSC 510x492 pixels 768x494 pixels elements PAL 500x528 pixels 752x582 pixels Sync Internal Video output 1.0Vp-p composite video, 75Ω Minimum illumination 0.05-lux S/N ratio >48dB Shutter control Auto Electric Shutter (AES),

Streszczenie treści zawartej na stronie nr. 3

ENFORCER Flush-Mount Low-Profile UFO Camera Overview: Screw Base Ring bracket (1 Shown, 3 included) (inside the ceiling wa l) Camera ball Flange Female BNC connector DC Jack DC Plug with terminal block Flange Base Ring bracket Before Starting: 1. Please read this manual carefully and keep it for 4. Do not point the camera at the sun. Heat could damage future reference. the camera, even when not in use. 2. Use the camera within given temperature

Streszczenie treści zawartej na stronie nr. 4

ENFORCER Flush-Mount Low-Profile UFO Camera Troubleshooting:  Check that the camera is powered up.  Check that the power supply’s polarity is correct. The screen is blank.  Check that the monitor is powered up.  Check that the video cable connecting the camera to the monitor is connected properly.  Clean the lens using a soft, clean cloth. The screen image is dim  Check that the light source is adequate.  Adjust the monitor’s contrast knob. The screen image has poor contrast