Streszczenie treści zawartej na stronie nr. 1
5
AUDIO/VIDEO CONTROL RECEIVER
RX-6010RBK / RX-6012RSL
SLEEP TV VCR AUDIO
SURROUND TEST – SUBWOOFER +
1 2 3
5
SURROUND
MODE EFFECT – CENTER +
4 5 6
AUDIO/VIDEO CONTROL RECEIVER
SOUND – VCR CH + – REAR•L +
7/P 8 9
5
MENU
TV/VIDEO CD-DISC – REAR•R + FM/AM TUNING FM/AM PRESET FM MODE
EON PTY SEARCH TA/NEWS/INFO DISPLAY MODE
10 +10
ENTER
DVD TV SOUND VCR ANALOG/DIGITAL STANDBY
MEMORY
MASTER VOLUME
CD
TAPE/CDR FM/AM
STANDBY/ON
DIGITAL
SURROUND DIGITAL
MUTING
+ +
TV VOL
VOLUME
– – 8
SURROUND ON/OFF IN
Streszczenie treści zawartej na stronie nr. 2
Warnings, Cautions and Others IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to
Streszczenie treści zawartej na stronie nr. 3
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and interconnections between pieces of equipment) are pro
Streszczenie treści zawartej na stronie nr. 4
Table of Contents Parts Identification ...................................... 2 Getting Started........................................... 3 Before Installation ...................................................................... 3 Checking the Supplied Accessories ........................................... 3 Connecting the FM and AM (MW/LW) Antennas ..................... 3 Connecting the Speakers ............................................................ 4 Connecting Audio/Video Components
Streszczenie treści zawartej na stronie nr. 5
5 Parts Identification Become familiar with the buttons and controls on the receiver before use. Refer to the pages in parentheses for details. 12345 6 78 9 AUDIO/VIDEO CONTROL RECEIVER FM/AM TUNING FM/AM PRESET FM MODE EON PTY SEARCH TA/NEWS/INFO DISPLAY MODE STANDBY MEMORY MASTER VOLUME STANDBY/ON DIGITAL SURROUND DIGITAL SURROUND ON/OFF INPUT ANALOG INPUT DIGITAL ADJUST SETTING DVD VCR TV SOUND INPUT ATT CONTROL DSP MODE DOWN UP SPEAKERS ON/OFF CD TAPE/CDR FM/AM SOURCE NAME PHONES pqwr ety u
Streszczenie treści zawartej na stronie nr. 6
Getting Started This section explains how to connect audio/video components and speakers to the receiver, and how to connect the power supply. Before Installation Connecting the FM and AM (MW/LW) Antennas General FM Antenna Connections • Be sure your hands are dry. • Turn the power off to all components. • Read the manuals supplied with the components you are going to A connect. B Locations • Install the receiver in a location that is level and protected from moisture. • The temperature around t
Streszczenie treści zawartej na stronie nr. 7
AM (MW/LW) Antenna Connections Basic connecting procedure 2 1 3 Snap the tabs on the loop into the ANTENNA slots of the base to assemble the FM 75 AM (MW/LW) loop. COAXIAL AM LOOP 1 Cut, twist and remove the insulation at the end of AM each speaker signal cable (not supplied). AM (MW/LW) Loop Antenna EXT 2 Open the terminal and then insert the speaker signal cable. 1 2 3 3 Close the terminal. Connecting the front speakers Connect front speakers to the FRONT SPEAKERS terminals. FRONT SPEAKERS
Streszczenie treści zawartej na stronie nr. 8
Connecting the subwoofer speaker Cassette deck or CD recorder You can enhance the bass by connecting a subwoofer. Connect the input jack of a powered subwoofer to the Cassette deck SUBWOOFER OUT jack on the rear panel, using a cable with RCA pin plugs (not supplied). PHONO To audio output To audio input CD CD SUBWOOFER OUT OUT (REC) Powered subwoofer TAPE CDR IN (PLAY) OUT (REC) Connecting Audio/Video Components VCR IN (PLAY) You can connect the following audio/video components to this receiv
Streszczenie treści zawartej na stronie nr. 9
Video component connections DVD player Use the cables with RCA pin plugs (not supplied). DVD player
A B Connect the white plug to the audio left jack, the red plug to the audio right jack, and the yellow plug to the video jack. DVD TV MONITOR OUT CD RIGHT LEFT DVD DVD OUT MONITOR (REC) OUT AUDIO TAPE CDR OUT (REC) IN DVD (PLAY) VCR IN TV (PLAY) OUT OUT (REC) (REC) VIDEO VCR VCR IN IN To audio To front left/right channel audio output (or to audio mixed (PLAY) (PLAY) output output if necess
Streszczenie treści zawartej na stronie nr. 10
Digital connections Connecting the Power Cord This receiver is equipped with two DIGITAL IN terminals — one Before plugging the receiver into an AC outlet, make sure that all digital coaxial terminal and one digital optical terminal. connections have been made. You can connect any component to one of the digital terminals using a digital coaxial cable (not supplied) or digital optical cable (not Plug the power cord into an AC outlet. supplied). Keep the power cord away from the connecting cables
Streszczenie treści zawartej na stronie nr. 11
Basic Operations The following operations are commonly used when you play any sound source. Turning the Power On and Off (Standby) Selected source name appears On the front panel: DIGITAL AUTO SPK INPUT ATT EON RDS SLEEP STANDBY To turn on the power, press LC R ANALOG PRO LOGIC DSP H.PHONE AUTO MUTING TUNED STEREO T A NEWS INFO VOLUME S.WFR LFE LINEAR PCM STANDBY/ON . LS S RS DIGITAL CH- The STANDBY lamp goes off. The name of STANDBY/ON the current source (or station frequency) appears on the di
Streszczenie treści zawartej na stronie nr. 12
Selecting different sources for picture and sound Listening Only with Headphones You can watch picture from a video component while listening to You must turn off speakers when you listen with headphones. sound from another component. Press one of the audio source selecting buttons (CD, TAPE/CDR, FM/AM), while viewing the 1. Connect a pair of headphones to the PHONES jack on the front picture from a video component such as the VCR or DVD player, panel. etc. 2. Press SPEAKERS ON/OFF so that the S
Streszczenie treści zawartej na stronie nr. 13
Adjusting the Subwoofer Output Level SPK INPUT ATT ANALOG L R You can adjust the subwoofer output level if you have selected “YES” for the “SUBWOOFER” (see page 11). Once it has been adjusted, the receiver memorizes the adjustment. Before you start, remember... SPK ANALOG L R • There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again. • When the front speakers are deactivated, the subwoofer level cannot be adjusted. Notes: On the f
Streszczenie treści zawartej na stronie nr. 14
Basic Settings Some of the following settings are required after connecting and positioning your speakers in your listening room, while others will make operations easier. Recording a Source Setting the Subwoofer Information You can record any source playing through the receiver to a cassette Register whether you have connected a subwoofer or not. deck (or a CD recorder) connected to the TAPE/CDR jacks and the VCR connected to the VCR jacks at the same time. Before you start, remember... • There
Streszczenie treści zawartej na stronie nr. 15
Center Delay Time Setting Setting the Speakers for the DSP Modes Register the delay time of the sound from the center speaker, To obtain the best possible surround sound of the DSP modes, you comparing to that of the sound from the front speakers. have to register the information about the speakers arrangement If the distance from your listening point to the center speaker is after all connections are completed. equal to that to the front speakers, select 0 msec. As the distance to the center sp
Streszczenie treści zawartej na stronie nr. 16
Crossover Frequency Setting Low Frequency Effect Attenuator Setting Small speakers cannot reproduce the bass sound very well. So, if If the bass sound is distorted while playing back a source using you have used a small speaker for any of the front, center, and rear Dolby Digital or DTS Digital Surround, follow the procedure below. channels, this receiver automatically reallocates the bass elements, originally assigned to the channel for which you have connected the On the front panel ONLY: smal
Streszczenie treści zawartej na stronie nr. 17
Digital Input (DIGITAL IN) Terminal Selecting the Analog or Digital Input Mode Setting When you have connected digital source components using both the analog connection (see page 5) and the digital connection methods When you use the digital input terminals, you have to register what (see page 7), you need to select the input mode correctly. components are connected to which terminals (DIGITAL IN 1/2). Before you start, remember... • There is a time limit in doing the following steps. If the se
Streszczenie treści zawartej na stronie nr. 18
When playing a software encoded with the DTS Digital Storing the Basic Settings and Surround, “AUTO” may not work properly and the following Adjustments symptoms may occur: • Sound does not come out at the beginning of playback. You can assign and store different sound settings for each different • Noise comes out while using the searching or skipping playing source. By using this function, you do not have to change function. the settings every time you change the source. The stored settings for
Streszczenie treści zawartej na stronie nr. 19
Receiving Radio Broadcasts You can browse through all the stations or use the preset function to go immediately to a particular station. MEMORY Tuning in Stations Manually 2. Press MEMORY. On the front panel ONLY: SPK L R ANALOG 1. Press FM/AM to select the band TUNED VOLUME FM/AM (FM or AM — MW/LW). CH- • Each time you press the button, the band alternates between FM and AM (MW/LW). “CH-” appears and the channel number position starts flashing on the display for about 5 seconds. SPK L R ANALOG
Streszczenie treści zawartej na stronie nr. 20
5 To tune in a preset station Selecting the FM Reception Mode On the front panel: When an FM stereo broadcast is hard to 1. Press FM/AM to select the band FM/AM receive or noisy (FM or AM — MW/LW). You can change the FM reception mode while receiving an FM The last received station of the selected broadcast. band is tuned in. • You can store the FM reception mode for each preset station. SPK ANALOG L R On the front panel ONLY: TUNED VOLUME FM MODE Press FM MODE. • Each time you press the button,
