Instrukcja obsługi SECO-LARM USA Enforcer RF Receivers SK-910R-4

Streszczenie treści zawartej na stronie nr. 1

®
ENFORCER
SK-910 SERIES
RF RECEIVERS
Model
SK-910R ...............One-channel receiver, 315MHz
SK-910RL .............Low-voltage, one-channel receiver, 315MHz
SK-910R2 .............Two-channel receiver, 315MHz
SK-910R-4 ............One-channel receiver, 433.92MHz
SK-910RL-4 ..........Low-voltage, one-channel receiver, 433.92MHz
SK-910R2-4 ..........Two-channel receiver, 433.92MHz
®
SECO-LARM

Streszczenie treści zawartej na stronie nr. 2

System These RF receivers are compatible with both code hopping and fixed-code transmitters (see page 4 of this manual for a list of compatible transmitters). They can be used for a variety of applications, such as allowing the same transmitter to arm/disarm a vehicle alarm and open/close a garage door opener. The receivers come in one- or two-channel versions. Each channel can learn the codes of up to 15 different transmitter buttons on a first-in, first-out basis. Installation Notes 1. Mount o

Streszczenie treści zawartej na stronie nr. 3

Mode Switch Operation (one per channel) • Learn mode — Press and hold the switch for three seconds. • Clear memory — Press three seconds, then when the LED starts flashing, press again for three seconds to delete all previously learned codes. • Reset latched output — If this channel was programmed for latch output, once the relay is turned on with a transmitter button, press the mode switch to turn the relay off. • Memory Display — Press and release the mode switch to show number of codes stored

Streszczenie treści zawartej na stronie nr. 4

Typical Applications: Positive Output: 12VDC receiver power driving a 12VDC apliance: COM Positive Power Source COM NC NC NO Positive Power Output NO 12VDC O/P - - GND Power for SK-910R Power for SK-910R } } + + +12VDC Negative Output: 12VDC receiver power input, 24VAC output driving a motor 24VAC(1) Input COM Negative Power Source COM 24VAC(2) 2 NC NC Motor 1 24VAC(1) Output NO Negative Power Output NO GND - - Power for SK-910R } +12VDC + + General Specifications Operating Frequency: 315 MHz (S