Instrukcja obsługi NETGEAR FS105 V2

Streszczenie treści zawartej na stronie nr. 1

Technical Support
PLEASE REFER TO THE SUPPORT INFORMATION CARD THAT SHIPPED WITH
YOUR PRODUCT.
By registering your product at www.NETGEAR.com/register, we can provide you with faster
expert technical support and timely notices of product and software upgrades.
Fast Ethernet Switch
10/100 Mbps FS105 v2/FS108 v2
NETGEAR, INC.
Support Information
Phone: 1-888-NETGEAR (For US & Canada only) - 24 x7 phone support
See Support Information card for other countries.
E-mail: support@NETGEAR.com (24 x 7 o

Streszczenie treści zawartej na stronie nr. 2

On=Link FAST ETHERNET SWITCH FS108 Blink=Act 100M 10M PWR 1 2 3 4 5 6 7 8 Auto 10/100 Mbps Fast Ethernet Switch MODELFS105 Fast Ethernet Switch MODEL FS108 Statement of Conditions Introduction In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the product described in this document without notice. ® The NETGEAR 5/8-Port Fast Ethernet Switch Model FS105 v2/FS108 v2 provides you with NETGEAR does not assume any liab

Streszczenie treści zawartej na stronie nr. 3

On=Link FAST ETHERNET SWITCH FS108 100M 10M Blink=Act PWR 1 2 34 5 6 7 8 Auto 10/100 Mbps Fast Ethernet Switch MODEL FS105 Fast Ethernet Switch MODELFS108 Unpack the Box and Verify the Prepare to Install the Switch Contents 1 2 1 2 Decide where you want to place the switch. Find a flat horizontal surface — such as a table, desk or shelf. The switch comes with wall-mounting screws. You’re welcome to use the screws if Fast Ethernet Switch FS105 v2/FS108 v2 you want to hang the switch in an open sp

Streszczenie treści zawartej na stronie nr. 4

Install the Switch and Connect the Other Troubleshooting Devices 3 3 The Power light is not lit The switch has no power. • Make sure the power cord is properly connected to the switch. • Make sure the power adapter is properly connected to a functioning power outlet. If it’s in a power strip, make sure the power strip is turned on. If the socket is controlled by a light switch, make sure the switch is in the on position. • Make sure you are using the NETGEAR power adapter supplied with your swit