Instrukcja obsługi Hearth and Home Technologies RC200

Streszczenie treści zawartej na stronie nr. 1

RC200
IntelliFire Plus™ Multifunction Remote Control
Installation & Operating Instructions
Canadian Equipment Requirements
Hearth & Home Technologies disclaims any responsibility for,
This digital apparatus does not exceed the (Class A/ Class
and the warranty will be voided by, the following actions:
B) limits for radio noise emissions from digital apparatus
• Installation and use of any damaged system component.
set out in the Radio Interference Regulations of the Cana-
• Modifi cation of th

Streszczenie treści zawartej na stronie nr. 2

5. Close the housing door and press the power button. Installation of Remote Control Housing The red light illuminates if the battery was properly in- CAUTION! Risk of Fire! DO NOT install damaged or stalled. See Figure 3. modifi ed components. Warranty will be voided if damaged or modifi ed components are installed. Kit components: One remote control, two #6 screws, two wall anchors, one A23 battery and one AUX200 module (if purchased retail). RED LED RED LED 1. Remove remote control comp

Streszczenie treści zawartej na stronie nr. 3

• Insert 3 prong plug from AUX200 module into REM/AUX Function Buttons receptacle of fi replace junction box. Press the POWER button to turn the fi replace ON and OFF. The fi replace will fi rst ignite the pi- lot. Once the pilot fl ame is established the main burner will be lit. Press the FLAME button to adjust the fl ame height. The fl ame height can be adjusted to 5 different settings: MAX, HIGH, MEDIUM, LOW, MIN. Flame height will not be adjustable for fi rst ten seconds when fi replace is tur

Streszczenie treści zawartej na stronie nr. 4

RC200 12V DC (A23 X 1) FLAME IGNITER SENSE TO JUNCTION 6V DC BOX (120V) SUPPLY 3 PRONG 120VAC CONTROL MODULE I AUX200 MODULE S FAN FLAME TO JUNCTION MODULATION BOX 120VAC BATTERY PACK 6V DC RED ORANGE GREEN BLACK (PILOT) (MAIN) BROWN BROWN/RED OPTIONAL ON/OFF SWITCH GROUND Figure 8. RC200 Wiring Diagram 4 Hearth & Home Technologies • RC200 Multifunction Remote Control • 2166-392 Rev. B • 9/10 WHITE WHITE ORANGE

Streszczenie treści zawartej na stronie nr. 5

The fi replace may be manually shut down by one of the Power Outage following methods: • If fi replace battery backup system IS installed at time of Turn off the control module: power outage, fi replace operation will not be interrupted. • Open or remove the decorative front to access the control • If fi replace battery backup system IS NOT installed at module. time of power outage, fi replace will shut off. To resume fi replace operation, install battery backup. • Move switch to OFF (See Figur