Instrukcja obsługi ATD Tools ATD-6810

Streszczenie treści zawartej na stronie nr. 1

ATD-6810
SPRAY GUN W/CUP
INSTRUCTION MANUAL

Read this Instruction Manual carefully and understand it completely, basic precaution
should be strictly followed to prevent the damage to the tool and injury to the operator.
Retain this manual for further reference. And you should pay more attention to the
Technical Data.




Description
A High pressure spray gun is ideal for refinishing a classic car or a wide variety of home improvement
projects. This high pressure paint sprayer fea

Streszczenie treści zawartej na stronie nr. 2

Important Safety Instructions 1. For toxic vapors produced by spraying certain materials can create intoxication and serious damage to health. Always wear safety glasses, gloves and respirator to prevent the toxic vapor hazard, solvent and pointing paint coming into contact with your eyes or skin. 2. Never use oxygen, combustible or any other bottle gas as a power source or would cause explosion and serious personal injury. 3. Fluid and solvent can be highly flammable or combustible.

Streszczenie treści zawartej na stronie nr. 3

Adjustment The desired pattern, volume of fluid output and fine atomization can easily be obtained by regulating the Pattern Adjusting Knob, Fluid (PAINT) Adjusting Knob and Air Adjusting Knob. Adjusting pattern: Turning the Pattern Adjusting Knob to the right until tight will make spray pattern round and turning it to the left will make spray pattern ellipse. Adjusting volume of fluid output: Turning the Fluid (PAINT) Adjusting Knob clockwise will reduce the volume of fluid output and tu

Streszczenie treści zawartej na stronie nr. 4

Storing When not using spray gun, turn the fluid adjustment knob counter-clockwise to open which will reduce spring tension on needle fluid tip. Spray gun MUST BE well cleaned and lightly lubricated. Troubleshooting Symptom Problems Solution Fluttering or 1. Material level too low. 1. Add material into container. spitting 2. Container tipped too far. 2. Hold more upright. 3. Loose fluid inlet connection. 3. Tighten. 4. Loose or damaged fluid tip/seat. 4. Adjust or replace.

Streszczenie treści zawartej na stronie nr. 5