Instrukcja obsługi Harbor Freight Tools 52847

Streszczenie treści zawartej na stronie nr. 1

AIR DIE GRINDER
REAR EXHAUST
Model #52847
Operating and Maintenance Instructions
Distributed exclusively by
®
Harbor Freight Tools .
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
®
Copyright © 2001 by Harbor Freight Tools . All rights reserved. No portion of this manual or any
artwork contained herein may be reproduced in any shape or form without the express written con-
sent of Harbor Freight Tools.
For technical questions please call 1-800-

Streszczenie treści zawartej na stronie nr. 2

SPECIFICATIONS ITEM DESCRIPTION 90 PSI Max. Air Pressure 25,000 RPM Air Speed 1/4” NPT Fitting Size 1/4” Collet Sizes 11 mm Collet Wrench (Qty: 1) Accessories 17 mm Collet Wrench (Qty: 1) SAVE THIS MANUAL You will need this manual for the safety warnings and precautions, operating and maintenance procedures, parts lists and diagrams. Keep your invoice with this manual. Write the invoice number

Streszczenie treści zawartej na stronie nr. 3

9. CHECK FOR DAMAGED PARTS. Before using the Air Die Grinder, carefully check that it will operate properly and perform its intended function. Check for damaged parts and any other conditions that may affect the operation of the Air Die Grinder. Replace or repair dam- aged or worn parts immediately. 10. REPLACEMENT PARTS AND ACCESSORIES. When servicing, use only identical replace- ment parts. Only use tools and accessories intended for use with this Air Die Grinder. Approved tools and acces

Streszczenie treści zawartej na stronie nr. 4

FIGURE A UNPACKING When unpacking, check to make sure all parts shown on the Parts List and Assembly Diagram are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. OPERATING INSTRUCTIONS ALL PARTS BELOW REFER TO THE PARTS LISTED AND SHOWN IN THIS MANUAL. To Connect The Air Die Grinder To An Air Hose: 1. The Air Die Grinder requires the attachment of a 1/4” NPT Quick Connector (available from Ha

Streszczenie treści zawartej na stronie nr. 5

2. To change Collet (part #27) you will need to use the two accessory Collet Wrenches. 3. With one Wrench hold the Collet Holder (part #24) in place. Use the other Wrench to turn the Collet Nut (part #28) counterclockwise. 4. Remove the Collet Nut (part #28) and insert the appropriate size Collet (part #27) into the Collet Holder (part #24). 5. With one Wrench, hold the Collet Holder (part #24) in place. Use the other Wrench to turn the Collet Nut (part #28) clockwise to tighten and lock the C

Streszczenie treści zawartej na stronie nr. 6

PARTS LIST / ASSEMBLY DIAGRAM NOTE: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. REV 07k SKU 52847 PAGE 6