Instrukcja obsługi Dynasty Spas GS501

Streszczenie treści zawartej na stronie nr. 1

VS500/501 GS500/501 Control Reference Card
Circ Operation
Initial Start-up
When your spa is first actuated, it will go into Priming mode, indicated by “ .” Please see the M-7 Installation Instruction Manual
for complete instructions on Power-up and Pump Priming. The Priming mode will last for less than 5 minutes (press "Temp" or
"Set" to skip Priming Mode) and then the spa will begin to heat the spa and maintain the water temperature in the Standard mode.
Your system has a 24-hour circ pump.

Streszczenie treści zawartej na stronie nr. 2

Diagnostic Messages Message Meaning Action Required No message on display. The control panel will be disabled until power returns. Spa Power has been cut off to the spa. settings will be preserved until next power up. Temperature unknown. After the circ pump has been running for 2 minutes, the temperature will be displayed. “Overheat” - The spa has shut down. One of the DO NOT ENTER THE WATER. Remove the spa cover and allow water to cool. Once the heater has cooled, reset by sensors has