Manual do usuário Canon

Resumo do conteúdo contido na página número 1

How To hardwire the CANON SURE SHOT OWL PF DATE 35mm CAMERA

Revised 1/12/04

This document outlines the modification of the Canon Sure
Shot Owl PF Date Camera so the shutter controls can be
operated remotely. It is recommended that the following “three
wire” setup be used in all cameras modified, and alternate “2
wire” setups are converted outside the camera.
Please note that following these modifications will void the
camera’s warranty. No guarantee is implied or expressed in
these

Resumo do conteúdo contido na página número 2

Remove screw inside camera enclosure #2 Remove Viewfinder Shroud, Battery Door, and Shutter Button Assembly Remove viewfinder shroud by prying shroud Viewfinder shroud removed from away from camera body at the top corner. camera body. Remove shutter button assembly. Remove battery door.

Resumo do conteúdo contido na página número 3

#3 Remove the Camera Body from the Camera Cover Remove the camera body from the camera cover by prying the body from the battery compartment. The camera body can be removed completely from the camera cover. The camera body removed from the camera cover. Camera body / cover.

Resumo do conteúdo contido na página número 4

#4 Modify Wire Route and Attach Wiring Harness Locate camera body side with strap guide. Notch the strap guide for the wire route. Insert wires through lower hole in camera cover, and hot glue “free” end into strap guide slot.

Resumo do conteúdo contido na página número 5

#5 Wiring the Camera Wire the camera with the following positions. One wire is soldered to the pad that connects to pin 6, (counted from right to left) on the top pc board of the camera. This is the refresh wire. One wire is soldered to the pad that connects to pin 5, (counted from right to left) on the top pc board of the camera. This is the shutter wire. The last wire is soldered to the spot indicated on the front pc board of the camera body. This is the common wire.

Resumo do conteúdo contido na página número 6

Better picture of solder pad 4 (common) #6 Reassemble Camera Body and Cover Slide camera body into camera cover inserting right side of camera body first. Press camera body into camera cover, until the door latch hits edge of camera body.

Resumo do conteúdo contido na página número 7

Pry camera cover over door latch and slide camera body back into camera cover. Check fit at bottom of camera cover. Check fit on top of camera cover Check wiring harness to make sure wires are not located directly under top screw hole.

Resumo do conteúdo contido na página número 8

#7 Reinstall Shutter Button Assembly, Battery Door, and Viewfinder Shroud. Reinstall shutter button assembly, battery door, and viewfinder shroud that were removed in step #2. #8 Reinstall Screws Reinstall screws, starting with the longest screws at the strap guide holes. Squeeze camera body and camera cover together for these screws only. Finish screw reinstall for remaining screws.

Resumo do conteúdo contido na página número 9

#9 Finish Hardwired Camera and Testing Complete wired camera with “three wire” setup, showing servo three wire connector. To test camera, refresh wire #6 and shutter wire #5 are solder together. Camera will fire flash when these two wires are touched to common wire #4. Camera must be on, and back door must be latched. “Film” winding will be heard after the first test. Subsequent test will not include winding without film in the camera. A 6 second delay is needed between tests f