Resumo do conteúdo contido na página número 1
UP409ZH (WDECT2315-2) OM 12/22/05 3:25 PM Page a
WDECT
+
2315 2
Wide Band Digital
Technology provides
the clearest sound
and the best privacy.
Quick Start
Guide
Resumo do conteúdo contido na página número 2
UP409ZH (WDECT2315-2) OM 12/22/05 3:25 PM Page i INSTALLATION & SAFETY Choosing the best location for your phone. When choosing a location for your phone there are a number of appliances the phone should not be near, and areas you should avoid. AVOID - CHARGE - Television sets and AVOID - the new phone other electronic Moisture for 15 - 20 hrs. appliances AVOID - Microwave ovens • This symbol AVOID - indicates important moisture operating and servicing instructions. Don’t - AVOID - overlo
Resumo do conteúdo contido na página número 3
UP409ZH (WDECT2315-2) OM 12/22/05 3:25 PM Page ii QUICK START GUIDE This page is a very condensed version of the Owner’s Start Manual. It is designed to allow you to get your phone installed and operating as quickly as possible - Here! however it does not attempt to explain any of the advanced features of the WDECT2315 series. Installing the Base Unit Route the cord. 1) Connect the AC adapter to the DC IN 9V jack and to a standard AC wall outlet. AC adapter (supplied) To AC outlet To DC IN 9V
Resumo do conteúdo contido na página número 4
UP409ZH (WDECT2315-2) OM 12/22/05 3:25 PM Page iii 3) Set the base on a desk or tabletop. Connecting the charger 1) Connect the AC adapter into the charging cradle and to a AC wall outlet. 2) Set the charger on a desk or tabletop. Installing the battery pack 1) Press down on the battery cover release and slide the • Charge the handset cover down until it comes off. battery pack for at least 15-20 hours before using your 2) Connect the battery plug to the socket at the rear of the new cordless
Resumo do conteúdo contido na página número 5
UP409ZH (WDECT2315-2) OM 12/22/05 3:25 PM Page iv Charging the handset(s) 1) Place the handset(s) in the main base unit or charging cradle with the keypad facing forward. Recharge your phone on a regular basis by returning the handset to the base after each phone call. 2) Make sure the charge LED illuminates. If the LED does not illuminate, check to see that the AC adapter is plugged in and that the handset makes good contact with the base charging contacts. • After installing the batteries i
Resumo do conteúdo contido na página número 6
UP409ZH (WDECT2315-2) OM 12/22/05 3:25 PM Page v CONTENTS INSTALLATION & SAFETY i PHONEBOOK 28 Phonebook 28 QUICK START GUIDE ii Storing Phone Numbers, Names, CONTENTS v Distinctive Rings, and Speed Dial 28 Steps for Entering Names and Special Characters 30 GETTING STARTED 1 Viewing the Phonebook 32 Controls and Functions 1 Making Calls Using the Phonebook 33 Uniden Company Philosophy 3 Speed Dialing 33 Welcome 3 Editing or Erasing a Stored Name, Features 4 Phone Number, Distinctive Ring, a
Resumo do conteúdo contido na página número 7
UP409ZH (WDECT2315-2) OM 12/22/05 3:25 PM Page 1 CONTROLS AND FUNCTIONS 1. Handset Antenna 2. Headset Jack Cover 3. Beltclip Hole 4. Hands-Free Speaker 1 5. Handset Battery Compartment 6 6. New Message LED 2 7 7. Handset Earpiece 8. LCD Display 3 9. /del Key 4 10. /vol/ / Key 8 a. ringer volume control 14 b. scroll keys for display screen 9 15 11. Key 10 16 12. redial/pause Key 17 13. speaker Key 5 14. Key 15. Key 11 18 16. Key 12 19 17. Key 13 20 18. Key 21 19. phonebook Key 22 20. /transfer
Resumo do conteúdo contido na página número 8
UP409ZH (WDECT2315-2) OM 12/22/05 3:25 PM Page 2 Main Base Charger Base 23 31 24 29 25 26 27 28 30 23. Base Antenna 29. Charging Contacts 24. Base Charging Contacts 30. charge LED 25. charge LED 31. DC IN 9V Jack 26. Key 27. TEL LINE Jack 28. DC IN 9V Jack [ 2 ]
Resumo do conteúdo contido na página número 9
UP409ZH (WDECT2315-2) OM 12/22/05 3:25 PM Page 3 UNIDEN COMPANY PHILOSOPHY To bring outstanding wireless communication products to people’s lives throughout the world. WELCOME Congratulations on your purchase of the Uniden Multi-Handset Cordless System telephone. This unit is different from conventional cordless telephones. When the base unit is connected to AC power and a telephone line, it can support up to 4 handsets. Using extra handsets, you can establish a 3-way conference call (2 hands
Resumo do conteúdo contido na página número 10
UP409ZH (WDECT2315-2) OM 12/22/05 3:25 PM Page 4 FEATURES Great features of this cordless phone include: • Designed and Engineered in Japan • Wide Band Digital Technology • Multi (4) Handset Capable • Digital Duplex Speakerphone on Handset Advanced Alpha Display Caller ID Features: • Alpha Memory Dialling • POP ID - Caller Name Identification* • 20 Individual Caller Tone Allocation* • 100 Caller ID * Memories with Phonebook • 3 Line Backlit Full Dot Matrix LCD Display with Clock • Maxi-Sound
Resumo do conteúdo contido na página número 11
UP409ZH (WDECT2315-2) OM 12/22/05 3:25 PM Page 5 CHECKING THE PACKAGE CONTENTS Make sure you have received the following items in the package. If any of these items are missing or damaged, contact your retailer. • Base unit (1) • Handset (3) • AC adapter (3) • Rechargeable battery pack (3) • Line adapter (Australia only) (1) • Linecord (1) • Beltclip (3) • Charger (2) Also included: • This Owner’s Manual TERMINOLOGY Throughout this manual, terms such as Standby and Talk Mode are used. Below i
Resumo do conteúdo contido na página número 12
UP409ZH (WDECT2315-2) OM 12/22/05 3:25 PM Page 6 MOUNTING THE BASE UNIT ON A WALL You can mount your base directly to the wall. Before doing this, consider the following: • Avoid electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall. • Mount your phone within distance of a working phone jack. • Make sure the wall material is capable of supporting the weight of the base and handset. • Use screws with anchoring device
Resumo do conteúdo contido na página número 13
UP409ZH (WDECT2315-2) OM 12/22/05 3:25 PM Page 7 BATTERY MAINTENANCE Battery use time (per charge) Fully charged • Up to 7 hours continuous use. • Up to 10 days when the handset is in the standby mode (up to 15 hours when in DirectLink mode) Recharge your phone on a regular basis by returning the handset to the charger after each phone call. Low battery alert When the batteries are very low and need to be charged, the phone is programmed to eliminate functions in order to save power. The bat
Resumo do conteúdo contido na página número 14
UP409ZH (WDECT2315-2) OM 12/22/05 3:26 PM Page 8 Battery replacement and handling When the operating time becomes short, even after a battery is recharged, please replace the battery. With normal usage, your battery should last about one year. Please contact your place of purchase or the Uniden Parts Department for a replacement battery. Caution • Use only the specified Uniden battery pack (BT-446). • Do not remove the batteries from the handset to charge them. • Never throw the battery into
Resumo do conteúdo contido na página número 15
UP409ZH (WDECT2315-2) OM 12/22/05 3:26 PM Page 9 HEADSET INSTALLATION Your phone may be used with an optional headset, the Uniden HS910. To use this feature, insert the headset plug into the headset jack. Your phone is ready for hands-free conversations. Headset is available through Uniden authorized retailers. DISPLAY AND ICONS Example of the standby mode display SUN 12:00A Day of the week and time / battery icon Handset #1 Handset ID and Banner New: 5 :OFF Number of new Caller I
Resumo do conteúdo contido na página número 16
UP409ZH (WDECT2315-2) OM 12/22/05 3:26 PM Page 10 ABOUT THE MENU OPTIONS There are 5 main menu options, (DirectLink Mode, Room Monitor, Handset Setup, Global Setup and System Reset) and submenu options. During Global Setup Summary of the Main Menu and Submenu and System Reset, make sure your Two Way Communication between the Handsets Anywhere without cordless phone is in the Base (DirectLink) standby mode (not DirectLink Mode allows a pair of handsets to work without the base unit, for dire
Resumo do conteúdo contido na página número 17
UP409ZH (WDECT2315-2) OM 12/22/05 3:26 PM Page 11 Handset Setup The following submenu options must be set separately for each handset. Submenu name Description Edit Voice Mail Program or delete the voice mail access number (see page 14). Ringer Tones Adjusting the ringer tone (tone your phone makes when ringing) (Default is Flicker) (see page 15). Set the distinctive ring (see page 15). “Distinctive Ring” allows you to preset memory locations with a designated ring tone. When an incoming cal
Resumo do conteúdo contido na página número 18
UP409ZH (WDECT2315-2) OM 12/22/05 3:26 PM Page 12 Global Setup If you change one of the Global settings, you change the setting for all additional handsets. Only one handset can change Global settings at a time. Submenu name Description Day & time Set the day and time of your display (see page 17). Name Tag (POP ID) Display the stored name with the Caller ID telephone number, if the displayed (Default is on) Caller ID telephone number is exactly the same as a number stored in the phone book
Resumo do conteúdo contido na página número 19
UP409ZH (WDECT2315-2) OM 12/22/05 3:26 PM Page 13 SETTING UP THE MENU Entering the Menu 1) Press the /del key in standby mode. 2) Use /vol/ or /vol/ to move the pointer to DirectLink Mode To back to the a desired main menu (DirectLink Mode, Room Monitor, Room Monitor previous screen, Handset Setup, Global Setup, and System Reset). Handset Setup press /del. 3) Press to select the desired main menu. 4) Use /vol/ or /vol/ to select a desired submenu, and then press to enter. In the submenu, use
Resumo do conteúdo contido na página número 20
UP409ZH (WDECT2315-2) OM 12/22/05 3:26 PM Page 14 Room Monitor Using Room Monitor 1) Enter the Room Monitor menu (see “Entering the To Room Monitor Menu” on page 13). Handset #2 To Room Monitor appears. This is an example, if 2) Select the handset you want to monitor by using you have handset #1 /vol/ or /vol/ . and #2. 3)Press . RoomMonitor appears, and you hear sounds in the RoomMonitor room where the handset is installed. Handset #2 4) To finish the Room Monitor, press or return t
