Manual do usuário Ives Heavy Duty Offset Top Pivot 7230F

Resumo do conteúdo contido na página número 1

Installation Instructions
7230F
3/4” Heavy Duty Offset Bottom Pivot
Right hand
Cap screw
installation shown;
left hand opposite
Pivot cap
Door leaf
3/32” set
screw
Right hand Left hand
Pivot shaft
installation installation
Figure 1
Base plate
1. Prepare and mortise bottom of door and floor to receive pivot set. Determine pivot location
using dimensions on reverse side. Be sure to properly locate and mark pivot center point
of the base plate. The bottom pivot set is non-handed. The pivot shaft w

Resumo do conteúdo contido na página número 2

NOTE ! It is very important for installer to verify that center line of top pivot point lines up with center line of bottom pivot point before final installation. Heel edge of door must be beveled 1/8” in 2” as shown below. 13/16” 1-1/4” to 21 mm* 32 mm* Depth of mortise will vary *depending upon installation and/or threshold height. 3/4” 1-3/16” 19 mm 30 mm Bevel heel edge of door 1/8” in 2” with 3/16” rad, typ Edge of base plate is flush with 5/16” edge of door 8 mm 2-3/8” 60 mm Right hand ins