Manual do usuário Precisionaire Rings Panels Filter SAR1P20-2424

Resumo do conteúdo contido na página número 1

Manufacturing
Specifications
For Ring Panel Filters
Standard Specifications: Panel Varieties:
DIMENSIONS STANDARD SIZE SINGLE PANELS
1. The outer dimension of the wire frame is 3/4" under These are the most common single panels. They are one
thenominal filter size in each direction for a single panel. piece filters. There is only one wire support frame that
spans the entire dimension of the filter.
2. The width of a link panel shall be 3/4" under nominal
size from wire to wire.
Model Numbers
3.

Resumo do conteúdo contido na página número 2

Manufacturing Specifications For Ring Panel Filters Standard specifications: FILTER DIMENSIONS 1. One pocket cubes are trapeziod in shape and taper in all four directions. 2. Two and three pocket cubes are tapered on top and bot- tom. 3. The depth of the filter has a tolerance of -1"/+1" 4. The outer dimensions of the self-supportive frame are 3/4" under nominal size from wire to wire. The 1-2" medai overlap fills the remaining space to act as a gasket. 5. Headered cubes have an outer dimension

Resumo do conteúdo contido na página número 3

Manufacturing Specifications For for Media Rolls & Blankets Media Varieties: Standard specifications: SA600-G10 Each SA600 media pad and roll has its own model numer. MEDIA ROLLS No custom sizes are used for this media type. 1. Roll lengths are +/- 5% and widths are -0/+1/2". Model Number 2. Maximum roll widths are: EX. SA600-361 or SA600-1001 SA600-G10 90.55" The first 5 digits identify the SA600-G10 media. If there SAR-1 90.55" are three digits after the hyphen then it is a pad. If there are f

Resumo do conteúdo contido na página número 4

Manufacturing Specifications For for Media Rolls & Blankets Conversion Formula for square inches to square feet HOW TO FIND CUSTOM PAD PRICING SA600-G10 and SAR-1 Custom Media Pads All other custom media pads For all other medias, a custom range has been First find how many square feet are in the custom established. To find the correct part number, sim- pad ply multiply the length times the width in inches to Do this by taking the length times the width in inches get the total square inches o