Manual do usuário Gamber Johnson 7160-0248-01 (-P)

Resumo do conteúdo contido na página número 1

INSTALLATION INSTRUCTIONS
Product Revision Form
INST-548
Panasonic CFH2 Vehicle Docking Station Rev. D
Printing Spec: PS-001
7160-0348
This instruction sheet is for the Gamber-Johnson Panasonic
Toughbook CFH2 Vehicle Docking Station
Gamber-Johnson Part Numbers: 7160-0348 (-P)
7160-0248-01 (-P)
*These instructions are for the docking station only. For
instructions on features, set-up and operation of the
Toughbook CFH2 computer, please refer to the manuals
provided by Panasonic with the computer

Resumo do conteúdo contido na página número 2

Components Latching Mechanism Actuator Button Front View Lock (Optional) Expansion Bus FIG. A Bottom View DC-IN Jack DC IN 16V External Display Port MINI DSUB 15-PIN Female LAN Port Serial Port USB Ports (3 ports) DSUB 9-PIN Male IEEE 802.3 10Base-T / IEEE 802.3u (4 PIN, USB2.0) 100Base-TX Will not support serial mouse. FIG. B 2 of 6

Resumo do conteúdo contido na página número 3

Installation Recommendations Conduct a "Bench Test" Gamber-Johnson strongly advises a "bench test" be conducted to verify that all electronic and software issues are resolved prior to installation: 1. Make sure computer is operational by itself. 2. Insert computer into docking station and verify that the display is operating in the dock. 3. Interconnect entire assembly and verify start-up of all components, including other equipment (printers, modems, scanners, etc.). Attaching Strain Re

Resumo do conteúdo contido na página número 4

Mounting The docking station can be mounted to any 75mm VESA hole pattern, or to the following Gamber-Johnson products: - VESA Adaptor Bracket (7160-0206) - Wall Mount Bracket (7160-0195) Connecting Peripherals Restrain the power, ethernet, and USB cables to the strain releif bracket with the cable ties provided as shown below. The video and serial cables have jack screws to hold them in place. To assure compliance with FCC, Part 15, Class B rules, only use shielded interface cables when

Resumo do conteúdo contido na página número 5

Inserting Computer Into Docking Station CAUTION: Turn computer power OFF when inserting and removing computer from docking station 1. Turn computer power OFF. 2. Insert bottom of computer into docking station (FIG G). 3. Push the top of computer back into the docking station until an audible "click" is heard and the computer is secured by the Latching Mechanism (FIG H). 4. (Optional) The Key Lock can now be used for security purposes. FIG. G FIG. H 5 of 6

Resumo do conteúdo contido na página número 6

Removing Computer From Docking Station 1. Turn computer power OFF. 2. If docking station is locked, unlock using the key provided. 3. Grasp the computer handle and press the Actuator Button in and down with the palm of your hand. (FIG I). 4. Pull the computer towards you to remove from docking station (FIG J). Actuator Button FIG. I FIG. J Product Mounting Disclaimer Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, inciden