Resumo do conteúdo contido na página número 1
32" LCD TV
Téléviseur ACL de 32 po
Televisor con pantalla LCD de 32"
DX-LCD32-09
USER GUIDE • GUIDE DE L’UTILISATEUR • GUÍA DEL USUARIO
Resumo do conteúdo contido na página número 2
Contents 2 Setting parental controls ......................................................... 17 Dynex DX-LCD32-09 Downloading rating information ............................................. 18 Restoring factory defaults........................................................ 19 32" LCD TV Maintaining.................................................................................... 19 Troubleshooting ............................................................................. 19 Contents Re
Resumo do conteúdo contido na página número 3
Important safety instructions 3 6Cleaning—Unplug your TV from the wall outlet before 16 Replacement parts—In case your TV needs replacement cleaning. Do not use liquid cleaners or aerosol cleaners. Use a parts, make sure that the service person uses replacement parts damp cloth for cleaning. specified by the manufacturer or parts with the same characteristics and performance as the original parts. Use of 7 Ventilation—Do not block any ventilation openings. Install in unauthorized parts can
Resumo do conteúdo contido na página número 4
1 2 3 4 5 1 2 TV components 4 • Do not leave your TV in a hot or cold location. Also, do not Side leave your TV in a location exposed to direct sunlight or near a heater. This may cause the cabinet to warp and the screen to malfunction. CH • Storage temperature: 32° to 122°F (0° to 50°C) • Working temperature: 41° to 104°F (5° to 40°C) CH 26 After image—Do not allow a still picture to be displayed for an extended period, because this can cause a permanent VOL after-image to remain on the sc
Resumo do conteúdo contido na página número 5
1 2 3 4 5 6 7 8 9 10 TV components 5 Back Remote control 1 2 16 3 17 4 18 5 19 6 7 20 8 21 9 22 10 23 11 12 13 24 14 25 15 26 # Component Description 1 Connect headphones to this # Button Description jack. 1 Press to turn on your TV. Press 2 HDMI 2 and HDMI 1 Connect HDMI devices to these (power) again to enter standby mode. jacks. You can connect two HDMI devices. 2 ZOOM Press to select the aspect ratio. You can select Normal, Wide, 3 VGA AUDIO/PIC Connect the audio and video Zoom, or C
Resumo do conteúdo contido na página número 6
Setting up your TV 6 # Button Description 11 Press or to move up or down in an on-screen menu. Press or to adjust an on-screen option. 12 ENTER Press to confirm a selection or open a sub-menu in the on-screen menu. 13 MENU Press to open the on-screen menu. 14 SLEEP Press to set the sleep timer. 15 MTS/SAP In analog TV mode, press to select the sound mode. You can select STEREO, SAP (second 3 Replace the battery compartment cover. audio program), or MONO. Cautions: In digital TV mode
Resumo do conteúdo contido na página número 7
Setting up your TV 7 3 Turn on your VCR, insert a videotape, then press PLAY on the Connecting an antenna or direct cable VCR. Optimum color reception requires good signal, which generally means Note: AV and S-Video connections share the same audio jacks. that you should use an outdoor antenna. The type and position of the antenna you need depends on your location. Connecting a VCR for recording To connect an antenna or direct cable: To connect a VCR for recording: • Connect a 75 Ohm coaxial
Resumo do conteúdo contido na página número 8
Setting up your TV 8 To play from the component video device: Connecting an HDMI device 1 Turn on your TV, then press INPUT. The INPUT SOURCE menu You can connect two HDMI devices. opens. To connect an HDMI device: 2 Press or to select COMPONENT1 or COMPONENT2, then • Connect an HDMI cable to the HDMI 1 or HDMI 2 jack on the press ENTER. back of your TV and to the HDMI Out jack on the HDMI device. Note: You can press COMP once to select COMPONENT1 or twice to select COMPONENT2. 3 Turn on t
Resumo do conteúdo contido na página número 9
Using your TV 9 Note: When your TV is in standby mode, power is still flowing into it. To Connecting a digital optical audio device completely disconnect power, unplug the power cord. To connect a digital optical audio device: Selecting the video input source • Connect an optical audio cable to the S/PDIF jack on the back of your TV and to the S/PDIF In jack on the S/PDIF device. To select the video input source: 1 Turn on your TV, then press INPUT. The INPUT SOURCE menu opens. 2 Press or t
Resumo do conteúdo contido na página número 10
Using your TV 10 Picture menu Lock menu Picture Sound Time Setup Lock Channel Picture Sound Time Setup Lock Channel Picture Mode Standard Change Password Contrast System Lock 50 On Brightness 50 US Color 50 Canada Tint 0 RRT Setting Sharpness 50 Reset RRT Color Mode Cool Select Move MENU Select Move MENU Exit Exit Sound menu Channel menu Picture Sound Time Setup Lock Channel Picture Sound Time Setup Lock Channel Sound Mode Standard Air/Cable Air Bass 50 Auto Scan Favorite Treble 50 Balance 50 Sh
Resumo do conteúdo contido na página número 11
Using your TV 11 3 Press or to select Auto Scan. 5 Press or to select Cable System, then press or to select your type of cable or satellite system. You can select STD, IRC, HRC, or AUTO. If you are not sure what type of system you have, select AUTO. Picture Sound Time Setup Lock Channel 6 Press or to select Start to Scan, then press or ENTER to Air/Cable Air start scanning. Your TV memorizes all cable or satellite channels Auto Scan you receive. Favorite Note: If you want to stop t
Resumo do conteúdo contido na página número 12
Using your TV 12 5 Press or to select a channel, then press ENTER to hide the 3 Press or to select an option, then press or to adjust the channel (remove the check mark). option. You can adjust: Note: If the channel list has more than one page, press or to scroll to • Picture Mode—Selects Standard, Dynamic, Soft, or the next page. Personal. 6 Press EXIT to save your changes and close the menu system. • Contrast—Adjusts the amount of white between the lightest and darkest parts of the
Resumo do conteúdo contido na página número 13
Using your TV 13 You can also adjust advanced VGA picture settings. 3 Press or to select Noise Reduction, then press or to select Weak, Middle, Strong, or Off. To adjust advanced VGA picture settings: 1 Press MENU. The on-screen menu opens. 4 Press MENU to return to a previous menu, or press EXIT to close 2 Press or to select Setup, then press to open the Setup the menu system. menu. Optimizing the image To optimize the image: 1 Press MENU. The on-screen menu opens. Picture Sound Time S
Resumo do conteúdo contido na página número 14
Using your TV 14 3 Press or to select an option, then press or to adjust the Displaying the information banner option. You can adjust: The information banner displays current status information, such as the • Sound Mode—Selects Standard, Music, Movie, or channel number or signal source. In DTV mode, you may also see Personal. additional information. • Bass—Adjusts the low sounds. To display the information banner: • Treble—Adjusts the high sounds. • Press DISPLAY. The information banner
Resumo do conteúdo contido na página número 15
Using your TV 15 3 Press or to select Favorite. 3 Press or to select Channel Label. Picture Sound Time Setup Lock Channel Picture Sound Time Setup Lock Channel Air/Cable Air/Cable Air Air Auto Scan Auto Scan Favorite Favorite Show/Hide Show/Hide Channel No. Channel No. 2-1 2-1 Channel Label WGBH-SD Channel Label WGBH-SD : : DTV Signal Good DTV Signal Good Select Move MENU Select Move MENU Exit Exit 4 Press or ENTER. The favorite channel list opens. Channels that 4 Press or ENTER. The chan
Resumo do conteúdo contido na página número 16
Using your TV 16 4 Press or to select an option, then press or to adjust the Using the sleep timer option. You can adjust: You can select an amount of time you want your TV to wait before it • CC Mode—Selects the closed caption mode. You can select automatically turns off. If you turn off your TV before the timer runs out, On, CC on Mute, or Off. the timer is cleared. • Basic Selection—Selects the closed caption type. You can To set the sleep timer: select CC1 through CC4 or Text1 throu
Resumo do conteúdo contido na página número 17
Using your TV 17 Setting the password Turning the parental lock on or off Before you block channels, you need to set a password. The password To turn the parental lock on or off: 1 Press MENU. The on-screen menu opens. controls access to the parental lock system. To set the password: 2 Press or to select Lock, then press . The password entry 1 Press MENU. The on-screen menu opens. screen opens. 2 Press or to select Lock, then press . The password entry screen opens. Picture Sound Time Setu
Resumo do conteúdo contido na página número 18
Using your TV 18 4 If necessary, press or to select System Lock, then press or to select On. Canadian English ratings 5 Press or to select US or Canada, then press ENTER. E Exempt programming 6 If you selected Canada, press or to select Canada English C All children or Canada French, then press or to select the rating. C8+ Children age 8 and over 7 If you selected US, press or to select MPAA or TV. G General programming 8 If you selected MPAA, press or to set the rating. PG Par
Resumo do conteúdo contido na página número 19
Maintaining 19 To delete the RRT information: 4 When a message asks if you want to restore factory settings, 1 Press MENU. The on-screen menu opens. select Yes to restore the settings, or select No to exit without restoring settings. 2 Press or to select Lock, then press . The password entry screen opens. Maintaining To clean your TV: 1 Turn off and unplug your TV. Picture Sound Time Setup Lock Channel 2 Wipe it with a soft, dry cloth. Enter Password – – – – If the surfaces are extremely d
Resumo do conteúdo contido na página número 20
Specifications 20 General Legal notices FCC Part 15 Problem Solution This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These One or more channels • Make sure that your TV has cannot be displayed. memorized channels. limits are designed to provide reasonable protection against harmful • Make sure that the channel has interference in a residential installation. This equipment generates, not been deleted f
