Manual do usuário Edelbrock 17930

Resumo do conteúdo contido na página número 1

155 Liter/Hr, In Tank Fuel Pump
For 1985-1997 Ford Mustang (Except for 1996-1997 Cobra)
Catalog # 17930
INSTALLATION INSTRUCTIONS
• PLEASE study these instructions carefully before installing your new In-Tank Fuel Pump for 1985-1997 Ford Mustang
(Except 1996-1997 Cobra). If you have any questions or problems, do not hesitate to contact our Technical Hotline at:
1-800-416-8628, from 7am-5pm PST, Mon-Fri, or via e-mail at: Edelbrock@Edelbrock.com. Please fill out and mail
your warranty card.
•

Resumo do conteúdo contido na página número 2

INSTALLATION PROCEDURE (Note: This rotary fuel injection pump will not work Fuel Pressure Regulator on carbureted fuel systems. It is for electronic fuel Fuel Tank injection only.) (Note: The word “bracket” used throughout these Injector(s) instructions refers to the fuel pump mounting Fuel Filter bracket and fuel level sender assembly.) PREPARATION Vapor Canister 1. Make sure the engine is cool and the vehicle is on level ground. Set the parking brake. Fuel Return Line 2. Remove the negativ

Resumo do conteúdo contido na página número 3

BRACKET REMOVAL 1. Note the position of the fuel pickup filter in relation to the 1. Thoroughly clean all dirt and debris from the top of the bracket before removing the filter. Remove and discard tank. Clean out any dirt from around the locking ring the filter. and retainer. This must be done to prevent dirt of 2. Prior to removing the lead wires, inspect the terminal foreign material from falling into the fuel tank while ends attached to the fuel pump. Some vehicles use a removing the brac

Resumo do conteúdo contido na página número 4

FUEL TANK INSTALLATION WRAP UP 1. Inspect the condition and location of all tank mounting 1. Using only equipment approved for use with gasoline, pads, insulators and brackets. Defective, missing or refill the fuel tank with gasoline. (Note: Always clean mislocated pads and insulators will cause the any gasoline spills immediately). transmission of excessive noise into the vehicle. 2. Inspect the fuel system for leaks. Repair any leaks before 2. Install the new fuel line retaining clips, 1/4”