Manual do usuário Edelbrock Honda 99-LATER

Resumo do conteúdo contido na página número 1

INSTRUCTION SUPPLEMENT Thumb Throttle

99-LATER HONDA
Attach cable into cable wheel with the cable
TRX400EX
end at the 8:00 position of the cable wheel,

then into bracket. Secure by replacing the
Removing Stock Carb and Cables
cable bracket end and phillips screw. See

Figure 2.
1.Remove seat/fender assembly and fuel
Figure 2.
tank.


2.Remove throttle cables paying close
attention to routing.

3.Remove thumb throttle housing if you are
installing a twist throttle.

4.

Resumo do conteúdo contido na página número 2

2.Adjust the pull cable to achieve wide- open throttle. Adjust the idle cable to take 8. Attach air boot to front of carb and secure up the slack. When cables are properly with clamp. adjusted, there should be approx. 1/8” of free-play in the throttle. NOTE: If flooding occurs, open throttle wide open while turning over engine until the engine starts. Edelbrock Carburetor Installation If you have any questions concerning installation or tuning please call our toll free 1. U