Manual do usuário Edelbrock Honda TRX450R

Resumo do conteúdo contido na página número 1

Figure1.
INSTRUCTION SUPPLEMENT FOR 2004-
LATER HONDA TRX450R


Removing stock carburetor and cables.






1. Remove seat, front fenders, rear fenders

and gas tank. Make sure fuel petcock is

in “off” position. You will also need to

remove the three bolts holding airbox in

place. Loosen air boot hose clamp
Figure 2.
around carburetor and slide airbox back.

2. Remove throttle cable paying close attention
to routing, as the new cable(s) will need too

Resumo do conteúdo contido na página número 2

clamp. Do not bolt tank in place, as minor 1. Carefully trim the rubber alignment tab off of adjustments may be necessary and my be the face of the manifold with a razor blade or easier with the tank off. side cutters. 2. Remove the hex pipe plug from the carb cap 9. Turn fuel petcock to “on” and check for using a 11mm or 7/16 wrench. Do not leaks. discard plug, as it will be needed later. Install the metering adjustment tool included 10. Open throttle 3-5 times to prime acceler