Manual do usuário Greenheck Fan Corp.M8182

Resumo do conteúdo contido na página número 1

Part #454200
INSTALLATION INSTRUCTIONS
Honeywell Modutrol IV Series Actuators
Models M4182, M9185D, & M8182
UL Listed Electric Actuators with Two Position Control
These instructions apply to the external field installation of
Honeywell actuators on Greenheck model VCD Control Dampers,
FSD Fire/Smoke Dampers, and SMD Smoke Dampers when they
are duct mounted or sleeved.
Tools Required:
Honeywell actuators rotate to their energized position when power Wrenches:
3 3 3 1 9 7 5
is applied and sprin

Resumo do conteúdo contido na página número 2

Instructions: These installation instructions assume the damper is already mounted in a duct or sleeve with the damper shaft extending beyond the sleeve or duct 6 inches. 1. Install the stand off bracket (item 16). Dampers with a jackshaft 1a. Mount the stand off bracket onto the jackshaft bracket with 1 1 (4) / / /4 4-20 X /2 in. thread cutting screws (item 17). Use the orientation shown on this page. Note: The bracket must be perpendicular to the damper on Orientation of Stand Off

Resumo do conteúdo contido na página número 3

Steps 6a,b for dampers 6. Assemble the linkage with 1 in. shafts 1 (substitute these parts in Parts needed for dampers with /2 in. shafts: 1 1 place of 7, 8, 9, &13) 1 (Qty. 2) /2 in. crankarms (item 7) 1 0 5 1 (Qty. 2) /16 - 18 x 1 /2 in. bolts ( item 8) 5 (Qty. 2) /16 - 18 spinlock nuts ( item 9) 1 2 (Qty. 1) Drive link (item 15) (Qty. 2) Linkage adjustment pin (item 13) 1 (Qty. 2) / / /4 4 - 20 spinlock nuts (item 6) (Qty. 1) Actuator crankarm (item 19) 1 1 5 (Qty. 2) /

Resumo do conteúdo contido na página número 4

White 120 v 8. Wire the actuator according to the Violet appropriate wiring illustration that 280v Orange identifies the actuator’s electrical 240v connections. Wiring should be per an Black Com. approved project or job wiring diagram and must comply with all applicable electrical codes Note: Tape or wire nut all unused leads. Transformer 9. Apply power to the actuator. T2 T2 The damper blades should fully open or close and return to the fail position when power is discon