Manual do usuário Philips (PSS-2000BR/SS)

Resumo do conteúdo contido na página número 1

I N S T R U C T I O N M A N U A L
Plasma Swivel Stand
(PSS-2000BR/SS)
The Plasma Swivel Stand (PSS-2000) is available in black
(PSS-2000BR) or silver (PSS-2000SS) to securely mount
your large flat panel display. A stylish solution for residential,
commercial and business applications, the PSS-200 pro-
vides a wide variety of features for most table top installa-
tions.
Features include +/-45 degrees of swivel, free standing with
bolt down capability for permanent installation or securi

Resumo do conteúdo contido na página número 2

Instruction Manual Swivel Stand IMPORTANT WARNINGS and CAUTIONS! WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions. CAUTION: A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the corre- sponding instructions. • WARNING: Improper installation can result in serious personal injury! Make sure that the structural members can

Resumo do conteúdo contido na página número 3

Instruction Manual Swivel Stand INSPECT PARTS BEFORE ASSEMBLY Remove and Inspect the Stand 1. Open shipping container, remove unit from container, and remove wooden shipping base. 2. Carefully inspect the stand for shipping damage. If any damage is apparent, call your carrier claims agent and do not continue with the assembly procedure until the carrier has reviewed the damage. NOTE: Read all assembly instructions before start- ing assembly. 3. Carefully inspect all components for damage (S

Resumo do conteúdo contido na página número 4

Instruction Manual Swivel Stand DISPLAY PREPARATION PROCEDURES Prepare the display for installation as follows: 1. Install the PSB bracket (shipped with the PSS) on your display according to the instructions included in PSB bracket package. STAND ASSEMBLY PROCEDURES Attach rubber bumpers here Free Standing (not anchored) Applications Only: NOTE: Do not perform this step if you are going to anchor the stand to a surface. 1. Install five rubber bumpers on the bottom of the stand (see Figure 1)

Resumo do conteúdo contido na página número 5

Instruction Manual Swivel Stand Slide Height Adj. Screws Front Plate Nuts Figure 3. Stand Assembly Reattach front plate using these holes Flag in down position (lowered) Nuts Holes used for displays measuring less than 30 Inches Tall Figure 4. For displays Taller Than 30 Inches 4

Resumo do conteúdo contido na página número 6

Instruction Manual Swivel Stand DISPLAY INSTALLATION PROCEDURES Install the display as follows: 1. Make sure the latching flag of the stand is in the open (lowered) position (see Figure 4). 2. Align the mounting buttons of the PSB bracket, installed on your display, with the teardrop slots in the mounting plate of the stand. 3. Lower the display into place and raise the latching flag to Adjust swivel tension using these screws secure the display. If the latching flag will not engage complet

Resumo do conteúdo contido na página número 7

Instruction Manual Swivel Stand STAND ANCHORING PROCEDURES 1/4-20 X 1/2” Tapped holes NOTE: Due to the wide variety of anchoring options, hard- ware is not provided. Anchor stand follows: 1. Select a suitable location for anchoring, allowing for room for swivel and access for cabling. 2. Using the template provided, drill anchoring holes for the four 1/4-20 X 1/2” tapped holes (see Figure 7). 3. If routing cables through mounting surface, Use the tem- plate provided and drill the cable access