Manual do usuário Cables Unlimited SPK-SHOWER

Resumo do conteúdo contido na página número 1

SPK-SHOWER
showerPOD 900MHz Wireless Shower Speaker




U U U US S S SE E E ER R R R M M M MA A A AN N N NU U U UA A A AL L L L
w w w ww w w ww w w w....a a a au u u ud d d diiiio o o o----u u u un n n nlllliiiim m m miiiit t t te e e ed d d d....c c c co o o om m m m
w w w ww w w ww w w w....c c c ca a a ab b b blllle e e es s s su u u un n n nlllliiiim m m miiiit t t te e e ed d d d....c c c co o o om m m m

Resumo do conteúdo contido na página número 2

Introduction & General Instructions Overview This Audio Unlimited™ showerPOD 900MHz wireless shower speaker system utilizes the latest advances in wireless transmission technology to deliver dynamic, high-quality audio from virtually any audio/video device, indoors up to 150 feet away. Simply connect the transmitter to a desired audio source: i-Pod, MP3, CD, DVD, Hi-Fi system or radio to enjoy wireless, full spectrum sound without complicated wiring and installation while having a shower.

Resumo do conteúdo contido na página número 3

Parts Identification Transmitter Receiver Adapter

Resumo do conteúdo contido na página número 4

Transmitter Operation 1. Plug the included AC adapter into a standard wall outlet 2. Turn on the power switch on rear transmitter. A blue indicator flashes when the AC adapter is plugged in. If the blue POWER indicator does not illuminate, ensure the adapter is plugged in. 3. Insert the adapter connector plug firmly into the DC jack located at the back of the transmitter 4. You can pull out a 3.5mm audio cable in front of the transmitter, which you can connect it to the i-pod’s output j

Resumo do conteúdo contido na página número 5

AC Operation 1. To operate the speaker using AC power, plug the 9V power adapter into a standard wall outlet 2. To insert the power adapter connector plugs firmly into the DC IN jacks located underneath the speaker Speaker Operation 1. To switch on the speaker, press the POWER button located on the front panel of the speaker. A blue power LED on the speaker illuminates 2. To listen to a desired audio source through the speaker, switch on the audio device that the transmitter base is c

Resumo do conteúdo contido na página número 6

Speaker Operation Note: When transmitting over long distances, the audio signal becomes weaker and interference increases. If the source signal is too weak for reception, the transmitter automatically switches off, blue indicator will flash after approximately four minutes to protect the unit and save power. If the source signal returns to an adequate level, the transmitter automatically switches back on. Power Off To switch off power, press the ON/OFF button on the front panel of t

Resumo do conteúdo contido na página número 7

- Ensure the connected audio device is switched on and producing a signal. - Ensure that the volume level is set to a moderate level Distortion - Ensure the speaker and transmitter are operating on the same frequency. If not, press the AUTO TUNE button until both units are operating on the same frequency - Switch the CHANNEL selector position (1 or 2) on the transmitter base and press the AUTO TUNE button the speaker until the matching frequency is reached - Speaker batteries may be t

Resumo do conteúdo contido na página número 8

through the headphone jack does not have the signal strength required by the transmitter. Raising the volume of your device will increase the signal strength to the transmitter. The blue signal LED will light when the required signal strength from your device is reached. We recommend that you keep the volume set on your iPod or MP3 player at a minimum of ¾ of full volume.