Manual do usuário Edelbrock Performer-Plus 2172

Resumo do conteúdo contido na página número 2

VALVE SPRINGS CAUTION: WARNINGS ABOUT YOUR WARRANTY In order for this Performer-Plus cam and lifter kit to be covered 2. Turn the engine over again until the intake lifter just stops coming under ANY WARRANTY you MUST use the correct Edelbrock Sure down. At this point install pushrod and adjusting nut on exhaust Seat Valve Springs or original equipment springs. Failure to install rocker arm and repeat the same procedure as above. new Edelbrock valve springs or original specification springs wit

Resumo do conteúdo contido na página número 3

CAM GEARS AND CAMSHAFT END PLAY- If cam gear Use of a straight becomes loose, the cam will slide back in the block, causing the edge to help align lifters to hit the lobes next to them and also the cam bearing jour- the two timing nals. If the engine is run after this happens, the bottom of the lifters marks is highly and the sides of the lobes will become chipped. When installing a camshaft, it is always important to check for recommended proper operating clearances, especially when high perfor

Resumo do conteúdo contido na página número 4

CAMSHAFT: Performer-Plus Hydraulic CAMSHAFT: Performer-Plus Hydraulic CATALOG #2172 CATALOG #2172 ENGINE: Ford 351-M/400 c.i.d. V8 ENGINE: Ford 351-M/400 c.i.d. V8 RPM RANGE: Idle-5500 RPM RANGE: Idle-5500 CAUTION: Do not use dual valve springs. CAUTION: Do not use dual valve springs. Use only recommended stock or Edelbrock Sure Seat Valve Springs Use only recommended stock or Edelbrock Sure Seat Valve Springs #5872 or #5972 (for valve rotators) #5872 or #5972 (for valve rotators) Use stock rat

Resumo do conteúdo contido na página número 1

PERFORMER-PLUS
Camshaft/Lifters/Lube Kit
CATALOG #2172
MODEL: 351-M/400 c.i.d. Ford V8
Please study these instructions carefully before installing your new camshaft. If you have any questions or problems, do not hesitate to con-
tact our Technical Hotline at: (800) 416-8628 from 7:00 am to 5:00 pm, Monday through Friday, Pacific Standard Time or e-mail
us at: edelbrock@edelbrock.com.
CAMSHAFT: Edelbrock Performer-Plus camshafts are ground specifically for use with the corresponding Performer