Manual do usuário Mark Feldstein & Assoc ., Inc.sp1790jk

Resumo do conteúdo contido na página número 1

INTRODUCTION



This 900 MHz digital hybrid wireless speaker system uses the latest wireless
technology that enables you to enjoy music and TV sound anywhere inside or
SP1790JK
outside your home. You simply connect the system to any audio source such as
900MHz Wireless Indoor/Outdoor Speakers Radio, TV, VCR, Hi-Fi, and CD/MP3/VCD/DVD/Blu-Ray player. Without any
complicated wiring and installation, this system enables you to enjoy incredible

bona fide sound in minutes.


FEATURES

Resumo do conteúdo contido na página número 2

COMPONENT IDENTIFICATION INSTALLATION INSTRUCTIONS TRANSMITTER TRANSMITTER 1. Insert the antenna tube onto the antenna wire. 2. Connect the supplied AC power adapter to an electrical wall outlet. SPEAKER RECEIVERS 3. Plug the AC power adapter into the DC input jack located on the rear of the transmitter. 4. When the AC adapter is plugged in, the red POWER LED illuminates. If the red POWER LED does not illumin

Resumo do conteúdo contido na página número 3

CONNECTING TO MEDIA DEVICE The rear of the transmitter has one audio cord that can be connected properly to the audio output jack of TV, Computer, VCR, Radio, CD/MP3/VCD/DVD/Blu- Ray players or to headphone/earphone jack with the connector provided. 4. Press On/Off button located on each speaker and turn the speakers ON. The POWER LED will light up in Blue. To turn the speakers off, press the ON/OFF button located on the speakers and the POWER LED

Resumo do conteúdo contido na página número 4

NOTE: 6. To put unit in Standby Mode: Press the “AUTO TUNE” button for the best reception. Should you experience a) To protect the transmitter and save power, the transmitter will turn any frequency interference, move your channel switch from one channel to the off automatically if it detects that the unit is not being operated or, other channel (there are two channels for selection) on the transmitter, and then there is weak reception from the signal audio source, for 5 minutes. p

Resumo do conteúdo contido na página número 5

TROUBLE SHOOTING TECHNICAL SPECIFICATIONS NO SOUND Transmission Mode : UHF - Ensure the AC/DC adapter is fully inserted into the wall outlet and the Carrier Frequency : 900 MHZ Digital Hybrid jack located on the transmitter. Operation Voltage : Transmitter, DC 12V 150mA - Ensure the speakers are switched on and Blue LED light is visible. - If the speaker’s battery capacity is too low, replace with new batteries Speakers, 6 x ‘C’ size Alkaline batteries or DC 9V or connect the A

Resumo do conteúdo contido na página número 6

BATTERY NOTICE: Do not mix old and new batteries. Do not mix alkaline standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. Replace all batteries at same time when they appear to be worn and unit is not operating properly. Remove batteries when unit is not used for long periods of time. To avoid leakage or explosion, do not put batteries in fire. WARNING This product may contain chemicals known to the state of California to cause Cancer and birth defects and other