Manual do usuário Paxar Monarch 9462TM

Resumo do conteúdo contido na página número 1

OPERATING
INSTRUCTIONS
The Monarch® 9462™ Single-Station Battery Charger
charges one 7.4V lithium-ion battery at a time for the
following printers:
♦ Sierra Sport2™ 9460™
♦ Sierra Sport3™ 9433™
♦ Monarch® Pathfinder® Ultra® Silver 6032™
♦ Monarch® Pathfinder® Ultra® Gold 6037™
♦ Monarch® Pathfinder® Ultra® Platinum 6039™
Note: You must charge a battery before using it.

WARNINGS
♦ Use only a Paxar-qualified battery. The battery could
be damaged or explode if placed on a different

Resumo do conteúdo contido na página número 2

♦ Do not disassemble, short-circuit, heat above 80°C, or incinerate the battery. It may explode. ♦ Follow the operating and storage limit specifications listed at the end of these instructions. Otherwise, the battery may permanently lose its charge capacity. Setting Up the Equipment To set up the equipment: 1. Plug one end of the power supply into a wall electrical outlet. 2. Plug the other end of the power supply into the back of the charger. The Power LED is lit when the charger

Resumo do conteúdo contido na página número 3

Charging the Battery To charge the battery, insert the battery into the charger, with the ribbed end sticking out. Charging time can take up to three hours. It takes approximately 1 hour to reach the 80% level (where it is now usable). To reach 100%, it takes approximately 2 hours more. Reading the Display ♦ Power LED – on (solid). Charger is plugged in. ♦ Charging LED – flashes when you insert the battery; on (solid) during charging; off when charging is complete. ♦ Complete

Resumo do conteúdo contido na página número 4

Troubleshooting When an error occurs, the Charging and Complete LEDs blink together. In this case, repeat the charging process. If the error still occurs, repeat the process with a new battery. If there is a still a problem after the second repeat charge, call Paxar Service. In between charges, remove the battery, wait for the lights to stop flashing, then re-insert the battery. Specifications Operating Limits: Temperature 32°F to 104°F (0°C to 40°C) Humidity 5% to 90% non-condens