Resumo do conteúdo contido na página número 1
Packard Bell
EasyNote ST
Disassembly Manual
Resumo do conteúdo contido na página número 2
11111 1 Table of Contents About this Guide.....................................................................................................................2 For More Information..............................................................................................................2 Technician Notes ...................................................................................................................2 Disassembly..............................................................
Resumo do conteúdo contido na página número 3
2 About this Guide This guide contains systematic disassembly instructions for the Packard Bell EasyNote ST. The instructions are illustrated where necessary with images of the part that is being disassembled. Packard Bell B.V. reserves the right to make changes to the EasyNote ST without notice. For More Information For more information about the Packard Bell EasyNote ST, visit Packard Bell‘s support web site at www.packardbell.com. The support web site also has links to additional Packard Bell
Resumo do conteúdo contido na página número 4
3 WARNING Hazardous Voltage Ensure that the notebook is disconnected There is hazardous voltage present inside the from its power source and from all notebook when it is connected to an AC supply, telecommunications links, networks, or even when the notebook’s power switch is off. modem lines whenever the casing cover Exposure to hazardous voltage could cause is removed. Do not operate the notebook personal injury. To avoid risk of injury, contact an with the cover removed. Authorized Service Pr
Resumo do conteúdo contido na página número 5
44444 4 Battery Perform the following steps to remove the battery: 1. Make sure the power is off. 2. Turn the notebook upside down. Note: Use an anti-static mat or something soft like a piece of cloth underneath the notebook to prevent damage to the exterior of the notebook. 3. Slide the battery lock/unlock latch (A) to the unlock position. B A Fig. 1 Removing the battery. 4. Slide the battery release latch (B) to the release position (see Fig. 1 on page 4). 5. Lift the battery upwards; there ar
Resumo do conteúdo contido na página número 6
55555 5 2. Lift the cover upwards from the back. There are four tabs holding the cover in place on the front. Raise the cover until you can remove it from the casing (see Fig. 2 on page 4). 3. Pull the plastic tab on the hard disk drives towards the left to disconnect the drives. Fig. 3 Disconnecting and removing hard disk drive. 4. Take the drives out of the compartment (see Fig.3 on page 5). 5. Remove the four screws (Phillips-head) on the metal brackets to separate them from the hard disk dri
Resumo do conteúdo contido na página número 7
66666 6 3. Release the clip on each side securing the memory module; the module will eject upwards. Fig. 5 Removing memory module. 4. Carefully remove the memory module from the socket. Note: In case two memory modules have been installed, you have to remove the top module first before you can remove the one underneath. Wireless LAN Adapter To remove the wireless LAN adapter (mini PCI Express), first remove the battery (see Battery on page 4) and then perform the following steps: 1. Remove the t
Resumo do conteúdo contido na página número 8
77777 7 Note: There are two WiFi antenna cables connected to the wireless LAN adapter. The black WiFi antenna cable is connected to MAIN (1) connector and the white WiFi antenna cable is connected to AUX (2) connector. 4. Remove the screw securing the wireless LAN adapter; it will eject upwards (see Fig. 6 on page 6). 5. Take out the wireless LAN adapter from the socket. TV Tuner (Optional) To remove the optional TV tuner (mini PCI Express), first remove the battery (see Battery on page 4), and
Resumo do conteúdo contido na página número 9
88888 8 Intel Turbo Memory (Optional) To remove the optional Intel Turbo Memory module (mini PCI Express), first remove the battery on page 4), and then perform the following steps: (see Battery 1. Remove the two screws securing the memory compartment cover (see Fig. 4 on page 5). 2. Lift the cover upwards from the left. There are two tabs holding the cover in place on the right. Raise the cover until you can remove it from the casing (see Fig. 4 on page 5). 3. Remove the two screws securing th
Resumo do conteúdo contido na página número 10
99999 9 5. Insert the flat screwdriver into the notch at the underside of the tray to release the tray bezel lock. Fig. 10 Location tray bezel lock underside. 6. Insert the small flat screwdriver into the notch at the side of the tray to release the side lock. Fig. 11 Location tray bezel side lock. 7. Separate the tray bezel from the drive. Note: The tray bezel is a delicate part, use care when handling it. Keyboard To remove the keyboard, first remove the battery (see Battery on page 4) and the
Resumo do conteúdo contido na página número 11
1010101010 10 2. Release the keyboard by prying it up along the top side of the keyboard. There are five tabs holding the keyboard in place on the front, particularly at the following keys: , , , and <*>. Fig. 12 Removing keyboard. 3. Tilt the keyboard gently forward and let it rest upside down on the touchpad. 4. Before removing the keyboard entirely, carefully release the white clip securing the flat cable and disconnect the cable from the main board. Fig. 13 Releasing ke
Resumo do conteúdo contido na página número 12
1111111111 11 1. Remove the nine screws securing the keyboard cover. Note that three screws are located in the battery compartment. Fig. 14 Location keyboard cover screws. 2. Turn the notebook over so the top is facing up and open the LCD completely. 3. Release the cover by prying it up along the top side of the cover. 4. Tilt the cover gently forward; there are six tabs holding the cover in place on the front. Top Cover To remove the top cover, remove the battery (see Battery on page 4), remove
Resumo do conteúdo contido na página número 13
1212121212 12 3. Turn the notebook over so the top is facing up and remove the five screws securing the top cover. Fig. 17 Location of cover screws in keyboard compartment. Note: The screw nearest to the optical drive is shorter than the other four. 4. Remove the two screws securing the top cover underneath the keyboard cover. Fig. 18 Location screws underneath keyboard cover. 5. Release the white clip securing the touchpad flat cable and disconnect the cable. Fig. 19 Disconnecting touchpad flat
Resumo do conteúdo contido na página número 14
1313131313 13 6. Release the white clip securing the button board flat cable and disconnect the cable. Fig. 20 Disconnecting button board flat cable. 7. Remove the top cover. LCD Assembly To disassemble the LCD assembly, first disconnect the WiFi antenna cables from the wireless LAN adapter (see steps 1 to 3 in Wireless LAN Adapter on page 6), remove the top cover (see Top Cover on page 11), and then perform the following steps: 1. Disconnect the three LCD cables from the headers on the main boa
Resumo do conteúdo contido na página número 15
1414141414 14 4. Remove the screws securing the hinges. Fig. 22 Location LCD hinge screws. 5. Lift out the LCD assembly. Speakers To remove the speakers, first remove the top cover (see Top Cover on page 11), and then perform the following steps: 1. Remove the screws securing the speakers to the casing. Fig. 23 Location speaker screws. 2. Clear the speaker cables: detach any adhesive tape securing the speaker cables to the main board. Packard Bell EasyNote ST Disassembly Manual
Resumo do conteúdo contido na página número 16
1515151515 15 3. Disconnect the speaker cables from the header on the main board. Fig. 24 Location of speaker cable header on the main board. Note: The left and right speaker assembly share the same header on the main board. Main Board To remove the main board, remove the hard disk drives (see Hard Disk Drives on page 4), remove the memory (see Memory on page 5), remove the wireless LAN adapter (see Wireless LAN Adapter on page 6), remove either the TV tuner card (see TV Tuner (Optional) on page
Resumo do conteúdo contido na página número 17
1616161616 16 2. Carefully disconnect the power cable from the header on the main board. Fig. 26 Location of cooler cable and screws. 3. Remove the two screws securing the cooler (see Fig. 26 on page 16). 4. Remove the DC jack cable from the header on the main board. Fig. 27 Location of main board screws and DC jack header. Packard Bell EasyNote ST Disassembly Manual
Resumo do conteúdo contido na página número 18
1717171717 17 5. Disconnect the optional Bluetooth cable from the header on the main board. Fig. 28 Disconnecting optional Bluetooth cable. 6. Release the white clip securing the USB board cable and disconnect the audio board cable from the headers on the main board. Fig. 29 Disconnecting USB board and audio board cables. Note: On Fig. 29, one of the headers is partly covered by the flat cable. 7. Remove the three screws securing the main board (see Fig. 27 on page 16). 8. Carefully slide the ma
Resumo do conteúdo contido na página número 19
1818181818 18 9. Before removing the main board entirely, carefully release the white clip securing the Ethernet/USB board flat cable and disconnect the cable from the main board. Fig. 30 Location of Ethernet/USB flat cable. 10. Lift the main board out of the casing. Note: Optionally, you can disconnect the other end of the flat cable from the switch board. CPU and Heat Sink To remove the CPU and the heat sink, first remove the main board (see Main Board on page 15) and then perform the followin
Resumo do conteúdo contido na página número 20
1919191919 19 4. Turn the screw in the CPU into the unlock position to release the CPU. Fig. 32 Location of screw securing CPU. 5. Carefully take out the CPU from the socket. CMOS Battery To remove the CMOS battery, first remove the main board (see Main Board on page 15), and then perform the following steps: 1. Release the CMOS battery and take it from the socket on the main board. Fig. 33 Removing CMOS battery. Packard Bell EasyNote ST Disassembly Manual
