Manual do usuário Associated Equipment 6002B

Resumo do conteúdo contido na página número 1

MODEL 6002B
OPERATOR'S MANUAL

ASSOCIATE
IMPORTANT SAFETY INSTRUCTIONS
1. SAVE THESE INSTRUCTIONS. This manual contains important safety and operating instructions for the battery charger you have
purchased. You may need to refer to these instructions at a later date.
2. CAUTION. To reduce risk of injury, charge only wet cell, lead-acid, automotive type rechargeable batteries. Other types of batteries may burst
causing personal injury and property damage.
3. Do not expose the charger

Resumo do conteúdo contido na página número 2

16. DC CONNECTION PRECAUTIONS a. Connect and disconnect the DC output clamps only after setting the charger switches to the OFF position and removing the AC cord from the electric outlet. Never allow the clamps to touch each other. b. Attach the DC clamps to the battery post and twist or rock back and forth several times to make a good connection. This tends to keep the clamps from slipping off the terminals and helps to reduce the risk of sparking. 17. STOP/GO LITE INSTRUCTIONS When u

Resumo do conteúdo contido na página número 3

connect this plug to a two-pole receptacle, as shown in FIGURE (B), until a properly grounded outlet can be installed by a qualified electrician. 3

Resumo do conteúdo contido na página número 4

DANGER. Before using an adapter as illustrated, be certain that the center screw of the outlet plate is grounded. The green-colored rigid ear or lug extending from the adapter must be connected to a properly grounded outlet - make certain it is grounded. If necessary, replace the original outlet cover plate screw with a longer screw that will secure the adapter ear or lug to the outlet cover plate and make ground connection to grounded outlet. NOTE: USE OF AN ADAPTER IS NOT ALLOWED IN CAN

Resumo do conteúdo contido na página número 5

TO CHARGE BATTERIES Make connections to the battery per the instructions in preceding section of this manual. Determine the battery voltage and set initial charge rate settings per chart. Turn the timer on. If a higher rate of charge is desired, turn the AMPS CHARGE switch to the appropriate 2, 3, 4 or HI position. Always return the AMPS CHARGE switch to the LO position before advancing the VOLTS CHARGE switch. 12V CRANKING ASSIST AND BOOST STARTING Turn off all lights and accessories

Resumo do conteúdo contido na página número 6

WIRING DIAGRAM MODEL 6002B PARTS LIST Front leg ................................. 610864 AC Circuit Breaker .......................... 610397 Side Panel (1)......................... 605209 Wheels w/nuts (2)................... 610553 Timer w/knob .................................. 610895 Front Panel............................. 611075 Axle w/nuts ............................. 605673 Switch w/knob................................. 605675 Back Panel ............................. 611076 Ba

Resumo do conteúdo contido na página número 7

027-0359E.doc illustration list 6002b English Fig FILE NAME DESCRIPTION 1 LOGO.EPS ASSOCIATED LOGO 2 STOP-GO.WPG STOP GO LITE ON BATTERY-ENGLISH 3 PLUG_ENG.CXD GROUNDING ADAPTER -ENGLISH 4 SIDETERM.TIF SIDE TERMINAL ADAPTER 5 CHRGTABL.CXD CHARGE RATE TABLE – ENGLISH LEVEL 6 27-520A.CXD 6001A CABINET 7 A4573A.CXD INSTRUMENT PANEL 8 PARABAT.CXD PARALLEL BATTERY – ENGLISH LEVEL 9 27-359WE.CXD 6002B WIRING DIAGRAM PUBLISHER: DO NOT REPRINT THIS PAGE 7