Manual do usuário TOA Electronics WM-5270UHF

Resumo do conteúdo contido na página número 1

INSTRUCTION MANUAL
UHF WIRELESS MICROPHONE WM-5270
Thank you for purchasing TOA's UHF Wireless Microphone.
Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment.
1. SAFETY PRECAUTIONS
• Be sure to read the instructions in this section carefully before use.
• Make sure to observe the instructions in this manual as the conventions of safety symbols and messages
regarded as very important precautions are included.
• We also recommend you keep th

Resumo do conteúdo contido na página número 2

3 2 4. HANDLING PRECAUTIONS • Do not expose the unit to rain or an environment where it may be splashed by water or other liquids, as doing so may result in unit failure. • Never open nor remove the unit case to modify the unit. Refer all servicing to your nearest TOA dealer. • Take care not to drop the unit onto the floor nor bump it against a hard object as the unit could fail. • Do not place the unit in locations of high temperature (ex. in a car parked in summer) or high humidity as the un

Resumo do conteúdo contido na página número 3

7. CHANNEL NUMBER SETTING H 0 -6 -12 Step 1. Switch off the power. Rotate the microphone grip PAD L counterclockwise to remove it. I/O Step 2. Using the screwdriver housed in the microphone BANK CHANNEL 8 9 7 4 A 6 body, set the Channel selector switch pointer to 5 3 B 4 C 2 3 D the desired channel number. 2 E 1 1 0 F Step 3. Replace the microphone grip. Note Channel selector switch Make sure that the wireless microphone is identical to the wireless tuner in the channel number. Should the m

Resumo do conteúdo contido na página número 4

11. NEW EMPHASIS CIRCUIT ON/OFF SWITCH The WM-5270 incorporates an improved new Emphasis circuit that further suppresses noise. The Emphasis circuit can be switched to the new circuit (pre-compressor Emphasis) by setting the New Emphasis circuit ON/OFF switch to ON (H position), and to the conventional circuit (post-compressor Emphasis) by setting the switch to OFF (L position). When using the WM-5270 with the switch set to ON, also reset the WT-5800 series tuner to a new circuit by means of the