Resumo do conteúdo contido na página número 1
· ·
TSE270X TSE271X TSE272X
INSTRUCTION MANUAL
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK.
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within The CAUTION label, shown on the left, is attached
an equilateral triangle, is intended to alert the user on the top of camera.
to the presence of uninsulated "dangerous
voltage" within
Resumo do conteúdo contido na página número 2
IMPORTANT SAFEGUARDS 12. Lightning 1. Read Instructions All the Safety and operating instructions should be For added protection for this video product during a read before the appliance is operated. lightning storm, or when it is left unattended and 2. Retain Instructions unused for long periods of time, unplug it from the wall outlet and disconnect the power supply and The safety instructions and instruction manual should cable system. This will prevent damage to the video be retained for fu
Resumo do conteúdo contido na página número 3
PRECAUTIONS FOR USE AND INSTALLATION * Never aim the camera at the sun. * Install your camera where no video noise appears. Never aim or point the camera at the sun even if you are When camera cables have been laid near electric wires or not shooting. television receivers, a noise may interfere the image. * Do not shoot intense light. If noise occurs, relocate cables or reinstall equipment. Strong light such as a spot light on the image plane will * Check the ambient temperature and humidity. ca
Resumo do conteúdo contido na página número 4
PART NAMES AND FUNCTIONS 2 4 1 3 10 2 1 Lens mount Mount a CS-mount lens. 2 Camera mount For mounting a camera on wall, housing, etc. (1/4"-20UNC thread) MODEL TSE270X 3 Focusing dial For fine-adjustment of the lens back-focus. 5 4 IRIS terminal Connect when an automatic iris lens is used. 7 6 5 VIDEO OUT terminal Connect to a monitor TV, etc. (BNC connector) 6 AC power terminal Connect this to optional AC 24V power supply. 7 Ground terminal MODEL TSE271X Connect this to the ground wire of the p
Resumo do conteúdo contido na página número 5
HOW TO CONNECT 1. Before connection, make sure that power of all units are OFF and cords are unplugged. 2. Mount a lens onto the camera. Refer to "HOW TO USE" for usable lens. 3. Connect video terminal of the camera and the video input terminal of a monitor TV, etc. with a 75Ω coaxial cable. 4. Connect the power terminal of the camera to a power supply. Caution: Installation should be made by a qualified service personnel and should conform to all local codes. Lens, coaxial cable for video signa
Resumo do conteúdo contido na página número 6
LINE-LOCK CONTROL (TSE270X/TSE272X) Matching the vertical synchronization with the power frequency is called the line-lock. When two or more cameras are switched by the video switcher to a monitor TV, the vertical sync. phase can be locked with the power frequency, and a stable vertical sync. is obtained without being disturbed at the time of switching. Monitor TV Video output CAMERA 1 Video input Video switcher Video output To AC 24V power supply (TSE270X) CAMERA 2 } To AC 120V power supply (
Resumo do conteúdo contido na página número 7
CAMERA CONTROLS By adjusting the switches/potentiometers provided on the side panel, the control functions are available. 1 AES switch TSE270X, TSE272X [Electronic shutter] The camera is factory-set at the AES switch OFF SENS-UP AUTO IRIS V-PHASE and 1/60 sec. shutter speed. [AES (Automatic Electronic Shutter)] AES BLC ALC DC VIDEO By setting the AES switch to ON, the LEVEL Automatic Electronic Shutter mode ON (1/60~1/100,000 sec) is available. Note: In electronic shutter mode; OFF *Sufficient b
Resumo do conteúdo contido na página número 8
PROFILE All dimensions in mm (inch) 43 (1.69) MODEL TSE270X 60 (2.36) 120 (4.72) MODEL TSE271X 43 (1.69) MODEL TSE272X 6-14, Meizen-cho, Mizuho-ku, ELMO CO., LTD. Nagoya, 467-8567 Japan OVERSEAS SUBSIDIARY COMPANIES ELMO Mfg. Corp. ELMO Canada Mfg. Corp. ELMO (Europe) G.m.b.H. 1478 Old Country Road, 44 West Drive, Brampton, Neanderstr. 18 Plainview, NY 11803-5034 Ontario, L6T 3T6, 40233 Dusseldorf, U.S.A. Canada Germany Tel. 516-501-1400 Tel. 905-453-7880 Tel. 0211-376051-53 Fax. 516-501-042
