Manual do usuário Life Fitness 9500HR

Resumo do conteúdo contido na página número 1

Life Fitness Model 9500HR Treadmills
How to…Install the Support Plate on Damaged Frame Cross-Member/Bracket
Tools required: Hex Key Wrench Set, Socket Set, C-Clamps, Phillips Screwdriver GK26-00002-0063
NOTE: STEPS 1-12 cover Belt, Deck, and Wax Bag Removal.
1. Turn the unit power OFF, then unplug the POWER CORD at the electrical outlet.
2. Remove the front and rear FRAME CAPS on the right side of the unit.
3. Remove the right HANDRAIL FOOT COVER.
4. Remove the mounting bolts
securing right HAND

Resumo do conteúdo contido na página número 2

Life Fitness Model 9500HR Treadmills How to…Install the Support Plate on Damaged Frame Cross-Member/Bracket NOTE: STEPS 13-16 cover LIFT ACTUATOR REMOVAL Actuator Motor and ASSESSEMENT OF DAMAGE to THE FRAME CROSS-MEMBER. 13. Unplug the LIFT ACTUATOR from the WIRE HARNESS. Hair Pin Clip 14. Remove the upper nut, bolt, and washer Actuator securing the ACTUATOR NUT Screw BRACKETS together. Loosen the lower Pin Bracket nut, bolt, and washer and lift out the (Welded to actuator nut past the bracket

Resumo do conteúdo contido na página número 3

Life Fitness Model 9500HR Treadmills How to…Install the Support Plate on Damaged Frame Cross-Member/Bracket NOTE: STEPS 21-24 cover how to adjust the lift actuator screw if moved or if incline error message is displayed. 21. Test the unit. If an incline error occurs then proceed to adjust the actuator screw. 22. With the unit on its left side, disconnect the lift frame from the lift actuator nut, enter 919 into the SERVICE MENU (this will require that power to the unit be restored and the unit p

Resumo do conteúdo contido na página número 4

Life Fitness Model 9500HR Treadmills How to…Install the Support Plate on Damaged Frame Cross-Member/Bracket NOTE: STEPS 31-33 cover BELT TENSIONING on NEW belts. 31. Prior to belt tensioning, place two pieces of tape 50” apart on the left and on the right edges of the striding belt as illustrated. 50” 32. Alternately tighten the two tensioning bolts 1/4 turn clockwise until the belt stretches so that the distance between the tapes increases to 50.25”. 33. Adjust tracking as described on previous