Manual do usuário Pelco EH8104

Resumo do conteúdo contido na página número 1

®
EH25/8104ORKIT
O-Ring Replacement Kit for
EH2500 Series Dust-Tight and
EH8104 Series
Pressurized Camera Enclosures
Installation/Operation Manual
C1953M (11/98)
The EH25/8104ORKIT contains two O-rings (one will be used for the rear plate
1.0 INSTALLATION
seal only, the second is a spare), a tube of O-ring lubricant, and two bags of desic-
cant.
This O-ring kit installation instruction applies to the EH2500 and EH8104 Series
enclosures.
Pelco does not supply basic tools needed for the installat

Resumo do conteúdo contido na página número 2

6. Lubricate the new O-ring with the lubricant in the kit and install it in the groove in the enclosure rear plate. 7. Reconnect the video and electrical cables. 8. Reinstall the rear plate on the rear of the enclosure body. Apply additional lubricant to the new O-ring, if necessary, and ensure it remains in the correct position. Reinstall and tighten the screws. O-RING REPLACEMENT (EH8104 Series Enclosures) 1. Turn off power to the enclosure. 2. Remove the mating connector from the rear of the

Resumo do conteúdo contido na página número 3

16. Remove the air chuck from the Schraeder valve and reinstall the valve cap. Reinstall the plastic cap on the pressure relief valve. The enclosure is ready for service. Pelco Manual C1953M (11/98) 3

Resumo do conteúdo contido na página número 4

WARRANTY 2.0 WARRANTY AND Pelco will repair or replace, without charge, any merchandise proved defective in material or RETURN INFORMATION workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FT/FR8000 Series fiber optic products. ® • Three years on Genex Series products (multiplexers, server, and keyboard). ® • Three years on Camclosure and fixed camera models, except the CC3701H-2, CC3701H-2X, CC3751H-2, CC3651H-2X, M