Resumo do conteúdo contido na página número 1
INSTRUCTION MANUAL
CAMERA CONTROL UNIT
IK-TF9U
For Customer Use
Enter below the Serial #
which is located on the
bottom of the cabinet. Retain
this information for future
reference.
Model #: IK-TF9U
Serial #:
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class A digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environm
Resumo do conteúdo contido na página número 2
SAFETY PRECAUTIONS Safety icons This manual contains safety instructions that must be observed in order to avoid potential hazards that could result in personal injuries, damage to your equipment, or loss of data. These safety cautions have been classified according to the seriousness of the risk, and the icons highlight these instructions as follows: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. Indicates a potentially hazardous situ
Resumo do conteúdo contido na página número 3
Note the following instructions when installing. • Do not cover the product by any material. • Do not put the product on an Inflammable material such as carpet or blanket. • Do not put the product in a narrow space, since the heat generated from the product may be difficult to emanate. If you do not follow the above, the heat generated by the product may cause fire. Do not placing the product in direct sunshine and/or high temperature. Temperature build up inside the product may result in fire.
Resumo do conteúdo contido na página número 4
Copyright and Right of Portrait There may be a conflict with the Copyright Law and other laws when a customer uses, displays, distributes, or exhibits an image picked up by the camera without permission from the copyright holder. Please also note that transfer of an image or file covered by copyright is restricted to use within the scope permitted by the Copyright Law. TABLE OF CONTENTS 1. CAUTIONS ON USE AND INSTALLATION ..... 5 (4. 6) Changing the manual shading correction seting ............
Resumo do conteúdo contido na página número 5
This product is 3CCD color camera with digital video output. 1. CAUTIONS ON USE AND INSTALLATION Handling the unit. The following descriptions are for that a camera head • “IK-TF9H” connected to this camera control unit. Do not drop, jolt, or vibrate, as this may result in damage to the unit. This may cause problems. Do not shoot intense light. • Treat the camera cables carefully to prevent cable If there is an intense light at a location on the problems, such as breaks in the cable and loose sc
Resumo do conteúdo contido na página número 6
3. NAMES AND FUNCTIONS 1 Camera cable for 8 DC IN 12V terminal ‘IK-TF9H’ terminal 2 DISP button 4 MENU UP button (AWB) DISP 6 DATA UP (AWB) button MENU DATA DC IN 12V PAGE 7 DATA DOWN button 5 MENU DOWN button 9 3 PAGE button DIGITAL terminal [ Front ] [ Rear ] 12 10 11 [ Bottom ] [ Top ] Camera cable for ‘IK-TF9H’ terminal Where the camera cable for ‘IK-TF9H’ is connected. 1 DISP button Used when switching the display. 2 PAGE button Used when switching to the menu and when selecting the menus.
Resumo do conteúdo contido na página número 7
4. CONNECTION 4. 1 Standard Connection Lans Camera control unit Cable Camera cable (option) (option) for IK-TF9U IK-TF9U (option) Frame grabber board, Monitor IK-TF9H image process (option) equipment etc. DC IN 12V DC power supply (option) 4. 2 Cautions on Connection • Only use optional camera head model # IK-TF9H with this camera controller. The use of another head may cause damage to the control unit and camera head. • When connecting the camera cables, be sure to turn off the camera contro
Resumo do conteúdo contido na página número 8
5. OPERATION A camera head “IK-TF9H” is supposed to be connected to this camera control unit from this section. Refer to the item " 4. CONNECTION", connect each equipment correctly. 1 Turn on the connected equipment and the power source of the camera. 2 When using the camera for the first time and when replacing the camera cable and the camera head, be 3 sure to operate the ABB adjustment refer to the item "Automatic Black Barance". 4 Aim the lens at the object, adjust the lens iris adjustment,
Resumo do conteúdo contido na página número 9
1 AWB (Automatic white balance) • Set the MODE to AWB on the WHT BAL menu. Perform the C.TEMP (color temperature conversion) setting, if necessary. (Refer to the item "7.2 (3) WHT BAL (White balance)".) 3200K : Appropriate for indoor shooting. 5600K : Appropriate for outdoor shooting. • If the index menu/menu is displayed, press the [DISP] button to disable the character display on the menu. • Shoot a known white object that fills the screen and push [DATA UP] button for approx. 1 second. • The
Resumo do conteúdo contido na página número 10
White Electronic shutter Gain Process Sync Option balance 6. ITEMS CONTROLLED BY USING ON SCREEN DISPLAY Preset value Item Available selections (Factory setting) MODE MANU, SS, E. TRG MANU E. TRG 1P SNR, 1P SR, PW SNR, PW SR 1P SNR MANU speed OFF, 1/100s, 1/250s, 1/500s, 1/1000s, 1/2000s, OFF 1/4000s, 1/10000s, 1/25000s, 1/50000s, 1/1000000s Syncro. Partial read OFF 2H/1592H~1590H/1592H, OFF, 2FRM~512FRM OFF scan. Partial read 25fps 2H/1270H~1268H/1270H, OFF, 2FRM~512FRM Partial read 30fps 2H/10
Resumo do conteúdo contido na página número 11
7. MODE SETTING BY ON SCREEN DISPLAY Various settings can be controlled on the unit by using the on screen menu displayed on the monitor. The contents once set are memorized even if the power source is turned off, so it is unnecessary to set again when using the unit next time. When the setting is performed, select the menu of the item to be set. 7. 1 Using the Menus When the power is turned on, the normal screen showing only the video signal appears. Change the output to each screen (video sign
Resumo do conteúdo contido na página número 12
7. 2 Menus • Select the menu to change the setting by referring the item "7.1 Using the Menus".) • When the [MENU UP], [MENU DOWN] buttons are pushed, the "→" on the screen moves up and down. Move the "→" to the item to change. Note: When performing the mode setting in the menu display while selecting ON in "PART" (refer to page 29) and E.TRG in "MODE", the display shows normal mode and then the camera returns the setting mode. ( 1 ) SHUTTER (Electronic shutter) The electronic shutter has thre
Resumo do conteúdo contido na página número 13
(1. 1) Changing each setting in MANU mode Move up down Set by pushing By pushing DATA UP, DOWN MENU UP, DOWN • Sutter mode MANU, SS, E.TRG -- SHUTTER -- • Sutter speed setting OFF, 100 (1/100s), 250 (1/250s), 500 (1/500s) MODE MANU 1000 (1/1000s), 2000 (1/2000s), 4000 (1/4000s) MANU 100 10000 (1/10000s), 25000 (1/25000s) PART OFF 50000 (1/50000s)100000 (1/100000s) • Partial scanning switch OFF/25fps/30fps/35fps/40fps/45fps/50fps/ E25fps/E30fps/E35fps/E40fps/E45fps/E50fps
Resumo do conteúdo contido na página número 14
(1. 2) Changing each setting in SS (synchro. scan) mode Move up down Set by pushing By pushing DATA UP, DOWN MENU UP, DOWN • Sutter mode MANU, SS, E.TRG -- SHUTTER -- • Synchro. scanning setting OFF : 2H/1592H ∼ 1590H/1592H↔OFF↔2FRM↔512FRM MODE SS 30fps, E.30fps : 2H/1060H ∼ 1058H/1060H↔OFF↔2FRM↔512FRM SS OFF PART OFF 40fps, E.40fps : 2H/774H↔772H/774H↔OFF↔2FRM↔512FRM • Partial scanning switch OFF/25fps/30fps/35fps/40fps/45fps/50fps/ E25fps/E30fps/E35fps/E40fps/E45fps/E50fps
Resumo do conteúdo contido na página número 15
(1. 3) Changing each setting in E.TRG mode The E.TRG has five modes; 1P SNR, 1P SR, PW SNR, PW SR, PR. First set the "→" to MODE and select E. TRG, then set the "→" to E.TRG and select the desired E.TRG mode. (1. 3. 1) Changing each setting in 1P SNR mode Move up down Set by pushing By pushing DATA UP, DOWN MENU UP, DOWN • Sutter mode MANU, SS, E.TRG -- SHUTTER -- • E.TRG mode 1P SNR, 1P SR, PW SNR, PW SR, RR MODE E.TRG E.TRG 1P SNR • Input trigger pulse setting at 1P SNR and 1P SR TRG.P I
Resumo do conteúdo contido na página número 16
(1. 3. 2) Changing each setting in 1P SR mode Move up down Set by pushing By pushing DATA UP, DOWN MENU UP, DOWN • Sutter mode MANU, SS, E.TRG, RR -- SHUTTER -- • E.TRG mode 1P SNR, 1P SR, PW SNR, PW SR MODE E.TRG E.TRG 1P SR • Input trigger pulse setting at 1P SNR and 1P SR TRG.P Input trigger pulse : positive polarity EXP. 50ms Input trigger pulse : negative polarity PART OFF • Exposure time setting at 1P SNR and 1P SR 0.01 ms 0.02 ms 0.4 ms 1 ms 20 ms 5
Resumo do conteúdo contido na página número 17
(1. 3. 3) Changing each setting in PW SNR mode Move up down Set by pushing By pushing DATA UP, DOWN MENU UP, DOWN • Sutter mode MANU, SS, E.TRG -- SHUTTER -- • E.TRG mode MODE E.TRG 1P SNR, 1P SR, PW SNR, PW SR, RR E.TRG PW SNR TRG.P • Input trigger pulse setting at PW SNR and PW SR PART OFF Input trigger pulse : positive polarity Input trigger pulse : negative polarity • Partial scanning switch OFF/25fps/30fps/35fps/40fps/45fps/50fps/ E25fps/E30fps/E35fps/E40fps/E45fps/E50fps
Resumo do conteúdo contido na página número 18
(1. 3. 4) Changing each setting in PW SR mode Move up down Set by pushing By pushing DATA UP, DOWN MENU UP, DOWN • Sutter mode MANU, SS, E.TRG -- SHUTTER -- • E.TRG mode MODE E.TRG 1P SNR, 1P SR, PW SNR, PW SR, RR E.TRG PW SR TRG.P • Input trigger pulse setting at PW SNR and PW SR PART OFF Input trigger pulse : positive polarity Input trigger pulse : negative polarity • Partial scanning switch OFF/25fps/30fps/35fps/40fps/45fps/50fps/ E25fps/E30fps/E35fps/E40fps/E45fps/E50fps
Resumo do conteúdo contido na página número 19
( 2 ) GAIN (Video gain) When the image is dark even if the lens iris is open, change the gain (video gain) to get the proper video level. For the gain adjustment of the unit, MANU (Manual) and OFF (0dB) modes are provided. 1 MANU (Manual gain) Gain adjustment is performed on the GAIN menu. The adjustment range is from 0dB to 18dB in 1dB steps. 2 OFF Gain is fixed at 0dB. Set the "→" to MODE, push the [DATA UP], [DATA DOWN], and select mode among MANU, OFF. (2. 1) Changing each setting in GAIN
Resumo do conteúdo contido na página número 20
( 3 ) WHT BAL (White balance) WHT BAL has two modes; AWB, MANU. Set the "→" to MODE, push the [DATA UP], [DATA DOWN], and select mode among AWB, MANU. (3. 1) Changing each setting in AWB (Automatic White Balance) mode Move up down Set by pushing By pushing DATA UP, DOWN MENU UP, DOWN -- WHT BAL -- MODE AWB • White balance mode setting (AWB, MANU) R GAIN 0 Automatically adjusting value for red gain and blue gain B GAIN 0 are shown on the screen C.TEMP 3200 * These values may not be changed
