Resumo do conteúdo contido na página número 1
Amplifier Manual
Manuel de l’amplificateur
Model: SD1300.1, SD1300.5
Features: Caractéristiques:
• High Efficiency Class D Topology • Topologie de classe D de gamme complète
• Compact Size for Easy Installation • Petit format pour faciliter l’installation
• High and Low Pass Crossovers • Filtres croisés passe-haut et passe-bas
• Robust Unregulated Power Supply • Alimentation électrique robuste non réglementée
• Surface Mount Component Technology • Technologie de composant monté en su
Resumo do conteúdo contido na página número 2
Amplifier Owner’s Manual Specifications SD1300.1 SPECIFICATIONS Frequency Response: ± 1dB from 20Hz to 300Hz RMS Power 14.4Vdc ≤ 1% THD 900 x 1 @ 2 ohms 1300 x 1 @ 1 ohm Signal to Noise Ratio: >90dB Low Pass Crossover: 18dB per Octave Subsonic Filter: 12dB per Octave Dynamic Power 14.4Vdc >1% THD 1200 x 1 @ 2 ohms 1600 x 1 @ 1 ohm Low Pass Crossover Range: 30Hz to 300Hz Subsonic Crossover Range: 10Hz to 55Hz Recommended Fuse Size: 120 amp Bass B
Resumo do conteúdo contido na página número 3
Amplifier Owner’s Manual SD1300.1 Monoblock Power Amplifier INPUT SENS Connect preamp signal cables from the head unit to these terminals. Used to reach maximum amplifier power with a wide variety of headunits. SUBSONIC CROSSOVER FREQUENCY CROSSOVER FREQUENCY Controls the highpass crossover point for the speaker outputs to eliminate Controls the lowpass crossover point for the speaker outputs. extreme low frequencies. BASS BOOST RMD Variable bass boost from 0 to +18dB @ 45Hz. Optional RMD Vo
Resumo do conteúdo contido na página número 4
INPUT Amplifier Owner’s Manual L REMOTE RMD SD1300.5 X-OVER FREQ. BASS SUBSONIC SENS 5 Channel Power Amplifier PROTECT R POWER 30Hz 300Hz 0dB 18dB 10Hz 55Hz MIN MAX SPEAKER FRONT, REAR AND SUB INPUTS BASS BOOST Connect preamp signal cables from headunit to these inputs. The front Variable bass boost from 0 to +18dB @ 45Hz for the subwoofer channel only. AND rear inputs must be used, if only the front input is used then the rear speaker outputs will have no output signal. The Sub Input may or m
Resumo do conteúdo contido na página número 5
Amplifier Owner’s Manual System tuning 1. Install all system fuses. 13. R educe the headunit’s volume to a comfortable level. 2. Set the amplifier’s input sensitivity controls to their minimum positions 14. List en to various musical selections to check overall system balance. (full counterclockwise). Compare front to rear, midbass to midrange, etc. If one speaker set is too loud compared to another, then its level must be lowered to blend 3. S et all amplifier crossover switches accordin
Resumo do conteúdo contido na página número 6
Manuel de l’amplificateur Spécifications CARACTÉRISTIQUES SD1300.1: Puissance RMS 14.4Vdc ≤ 1% THD 900 x 1 @ 2 ohms 1300 x 1 @ 1 ohm Réponse en fréquence: ± 1dB from 20Hz à 300Hz Rapport signal/bruit : >90dB Puissance Dynamique 14.4Vdc >1% THD 1200 x 1 @ 2 ohms Filtres passifs passe-bas: 18dB par Octave 1600 x 1 @ 1 ohm Filtres passifs subsoniques: 12dB par Octave Plage du filtre passif passe-bas: 30Hz à 250Hz Taille de fusible: 120 amp Plage du filtre passif subsonique: 10Hz à 5
Resumo do conteúdo contido na página número 7
Manuel de l’amplificateur SD1300.1 Monoblock Power Amplifier ENTRÉE SENS NIVEAU Sert à atteindre une puissance d’amplificateur maximale avec une grande variété Reliez les câbles de signal préampli de l’unité principale sur ces bornes. d’unités principales. FRÉQUENCE DU FILTRE PASSIF PASSE-BAS FRÉQUENCE DU FILTRE PASSIF SUBSONIQUE Contrôle le point de filtre passe-bas pour les sorties du haut-parleur. Puissance RMS 14.4Vdc ≤ 1% THD 900 x 1 @ 2 ohms Contrôle le point de filtre passe-haut po
Resumo do conteúdo contido na página número 8
INPUT Manuel de l’amplificateur L REMOTE RMD X-OVER FREQ. BASS SUBSONIC SENS PROTECT sD1300.5 R 5 Channel Power Amplifier POWER 30Hz 300Hz 0dB 18dB 10Hz 55Hz MIN MAX SPEAKER AVANT ET ARRIERE D’ENTREES AMPLIFICATION DES BASSES Connectez préampli câbles de signal de l’unité centrale à ces entrées. La Amplification des basses variable de 0 à +18 dB à 45Hz. façade arrière et les intrants doivent être utilisés, si ce n’est que l’entrée FUSE avant est utilisé alors les sor GROU ND ties haut R -parleu
Resumo do conteúdo contido na página número 9
Manuel de l’amplificateur Système de réglage 1. I nstallez tous les fusibles du système. 13. Réduisez le volume de l’unité principale à un niveau confortable. 2. Réglez les commandes de sensibilité de l’entrée de l’amplificateur sur leurs 14. É coutez les différentes sélections musicales pour vérifier la balance globale positions minimales (entièrement dans le sens inverse des aiguilles d’une du système. Comparez l’avant à l’arrière, les basses moyennes à la plage montre). moyenne, etc. S
Resumo do conteúdo contido na página número 10
Amplifier Owner’s Manual Installation NOTES: © 2011 Phoenix Gold • www.phoenixgold.com
Resumo do conteúdo contido na página número 11
Amplifier Owner’s Manual Owner Information Owner’s Name: Serial Number: Purchase Location: Purchase Date: Installer: © 2011 Phoenix Gold • www.phoenixgold.com
Resumo do conteúdo contido na página número 12
Phoenix Gold A Division of AAMP of America™ 13190 56th Court Clearwater, Florida 33760 P: 888-228-5560 info@phoenixgold.com www.phoenixgold.com © 2011 AAMP of Florida, Inc Designed and Engineered in the USA LIMITED WARRANTY ON AMPLIFIERS Phoenix Gold warrants this product to be free of defects in materials and workmanship for a period of one (1) year from the original date of purchase. This warranty is not transferable and applies only to the original purchaser from an authorized Phoenix Gold
