Resumo do conteúdo contido na página número 1
94901 Revised Size 1/29/02 2/25/02 4:15 PM Page 1
RM94901
Universal
Remote Control
INSTRUCTION
MANUAL
Resumo do conteúdo contido na página número 2
94901 Revised Size 1/29/02 2/25/02 4:15 PM Page 2 Table Of Contents Button Description . . . . . . . . . . . . . . . . . . .1-3 Battery Installation . . . . . . . . . . . . . . . . . . . . .2 Programming Your Universal Remote TV . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 VCR . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Cable Box . . . . . . . . . . . . . . . . . . . . . . . .6 AUX/DVD or Other Device . . . . . . . . . . .7 Code Search . . . . . . . . . . . . . .
Resumo do conteúdo contido na página número 3
94901 Revised Size 1/29/02 2/25/02 4:15 PM Page 3 MUTE The Mute button operates the same as on your original remote. PREV CH The PREV CH (Previous Channel) button oper- ates the same as on your original remote. 0-9 The number buttons operate the same as on your original remote, and are used for enter- ing device codes. TV•VCR The TV•VCR button operates the TV•VCR func- tion of your VCR. ENTER The ENTER button operates the same as on your original remote. REV, PLAY, FOR, REC, STOP, PAUSE The
Resumo do conteúdo contido na página número 4
94901 Revised Size 1/29/02 2/25/02 4:15 PM Page 4 Special Programming Feature This remote can be programmed to control any of these devices: TV Satellite Receiver MiniShelf System VCR DVD Player Audio Receiver Cable Box CD Player The TV device button is dedicated for a TV only.The remaining buttons can be assigned to any of the above devices (even though the remote device buttons are screen-printed for specific devices. Satellite and audio receiver functions would be limit
Resumo do conteúdo contido na página número 5
94901 Revised Size 1/29/02 2/25/02 4:15 PM Page 5 Programming For TV 1. Manually turn on the TV. 2. Press and hold the SETUP BLINK button until the INDICATOR LIGHT lights, then release the SETUP button. 3. Press and release the TV button (the INDICATOR LIGHT will blink then remain lit). 4. Find the three digit code for your TV in the code list in the back of this book OFF and enter it using the Number Buttons. After your code is entered, the INDICATOR LIGHT will turn off. 5. A
Resumo do conteúdo contido na página número 6
94901 Revised Size 1/29/02 2/25/02 4:15 PM Page 6 Programming For VCR 1. Manually turn on the VCR. 2. Press and hold the SETUP button until the BLINK INDICATOR LIGHT lights, then release the SETUP button. 3. Press and release the VCR button (the INDICATOR LIGHT will blink then remain lit). 4. Find the three digit code for your VCR in the code list in the back of this book OFF and enter it using the Number Buttons. After your code is entered, the INDICATOR LIGHT will turn o
Resumo do conteúdo contido na página número 7
94901 Revised Size 1/29/02 2/25/02 4:15 PM Page 7 Programming for Cable Box 1. Manually turn on the Cable Box. 2. Press and hold the SETUP button until the INDICATOR BLINK LIGHT lights, then release the SETUP button. 3. Press and release the CAB button (the INDICATOR LIGHT will blink then remain lit). 4. Find the three digit code for your Cable Box in the code list in the back of this book OFF and enter it using the Number Buttons. After your code is entered, the INDICATOR LI
Resumo do conteúdo contido na página número 8
94901 Revised Size 1/29/02 2/25/02 4:15 PM Page 8 The DVD/AUX Button The DVD/AUX button can be used for a DVD player. It can also be assigned to any other type of device you have (another TV, VCR, Cable Box, Satellite Receiver, CD Player, Mini System, or Audio Receiver). 1. Manually turn on the the device you wish to assign to the DVD/AUX button (TV, VCR or Cable Box). BLINK 2. Press and hold the SETUP button until the INDICATOR LIGHT lights, then release SETUP button. 3. Press and
Resumo do conteúdo contido na página número 9
94901 Revised Size 1/29/02 2/25/02 4:15 PM Page 9 Programming With Code Search If your TV, VCR, or Cable Box does not respond after you have tried all the codes for your brand, or if your brand is not listed, try search- ing for your code by following the steps below. 1. Turn on the device you wish to program. 2. Press and hold SETUP until the INDICATOR LIGHT lights, then release SETUP. 3. Press and release the device button for the device you are programming (TV, VCR, CAB/SAT, DVD/A
Resumo do conteúdo contido na página número 10
94901 Revised Size 1/29/02 2/25/02 4:15 PM Page 10 Retrieving Codes If you need to find the three-digit code for your device, after your device is set-up using Code Search, use this procedure. 1. Press and hold SETUP until the INDICATOR LIGHT lights, then release SETUP. 2. Press and release the device button for the device’s code you are retrieving (TV, VCR or CAB). The INDICATOR LIGHT will blink once. BLINK 3. Press and release SETUP. The INDICATOR LIGHT will turn off. OFF 4. Starti
Resumo do conteúdo contido na página número 11
94901 Revised Size 1/29/02 2/25/02 4:16 PM Page 11 Menu Functions The Menu is used to make changes such as setting color, channels, timers, etc. Entering the Menu Mode: 1. Push the DEVICE button on the remote. 2. Push the MENU button. This puts the remote in Menu Mode. The Menu should now be visible on the BLINK television. The INDICATOR LIGHT will blink continuously to indicate the remote is now in Menu Mode. While in MENU these buttons will function as follows: VOL UP/DOWN butt
Resumo do conteúdo contido na página número 12
94901 Revised Size 1/29/02 2/25/02 4:16 PM Page 12 Exiting the Menu Mode: To exit the Menu Mode and clear the screen push the DEVICE button on the remote. The INDICATOR LIGHT should go out indicating the remote is now out of Menu Mode and will revert to it’s normal mode of operation. NOTE: The remote will automatically exit the Menu Mode after 10 seconds of inactivity with no buttons being pushed. Special Notes: 1. Because of the wide variety of menu formats, some experimenting may be
Resumo do conteúdo contido na página número 13
94901 Revised Size 1/29/02 2/25/02 4:16 PM Page 13 Trouble Shooting Solution Problem A) Replace the batteries Indicator Light not (with fresh, new AAA blinking when you Alkaline batteries). press any key B) Check that batteries are properly installed. A) Try all the codes The RM94905 does listed for your brand. not operate your B) Try the Code Search device method (page 11). Start Code Search over again Not performing com- to locate the proper code. mands properly Try the VCR code for
Resumo do conteúdo contido na página número 14
94901 Revised Size 1/29/02 2/25/02 4:16 PM Page 14 Lose Your Codes? Enclosed with this remote is a sticker on which you should write the codes for each device you programmed. Apply the sticker to the back of the remote or somewhere convenient for future reference. Also on the sticker is our website address which, should you lose your codes or pro- gramming instructions, you can find available on our website: www.jascoproducts.com Limited Warranty 90 DAY LIMITED WARRANTY: Jasco Products Compa
Resumo do conteúdo contido na página número 15
94901 Revised Size 1/29/02 2/25/02 4:16 PM Page 15 Índice Descripción del botón, . . . . . . . . . . . . . . . . . .14-15 Instalación de la batería, . . . . . . . . . . . . . . . . . . .15 Programando su TV telecontrol universal . . . . .16 Programando su VCR . . . . . . . . . . . . . . . . . . . . . .17 El rectángulo del cable . . . . . . . . . . . . . . . . . . . .18 Programando su Aux . . . . . . . . . . . . . . . . . . . . . .19 Búsqueda del código . . . . . . . . . . . . . . . . . . .
Resumo do conteúdo contido na página número 16
94901 Revised Size 1/29/02 2/25/02 4:16 PM Page 16 0-9 Los botones del número funcionan igual que en su telecontrol original, y se utilizan para introducir códigos de dispositivo. TV*VCR El botón de TV*VCR funciona la función de TV*VCR de su VCR. ENTER El botón del ENTER (INTRODUCIR) funciona igual que en su telecontrol original. REV, PLA Y, FOR, REC, S TOP, P AUSE Los botones de REV (rebobinado), del JUE G O (PLAY), del FOR (delantero rápido), de REC (expedi- ente), de la PARADA (STOP), y de
Resumo do conteúdo contido na página número 17
94901 Revised Size 1/29/02 2/25/02 4:16 PM Page 17 Pr ogramación Para la TV 1. Gire manualmente la prensa de la TV 2. Presione y sostenga el botón de la SETUP hasta que se enciende las luces de la BLINK LUZ de INDICADOR (INDICATOR LIGHT) , después versión el botón de la SETUP. 3. Presione y versión el botón de la TV (sigue habiendo la LUZ de INDICADOR entonces centelleo se encendió). 4. Encuentre el código de tres cifras para su TV en la lista de código que comienza abajo e in
Resumo do conteúdo contido na página número 18
94901 Revised Size 1/29/02 2/25/02 4:16 PM Page 18 Pr ogramación Para el VCR 1. Gire manualmente la prensa del VCR. 2. Presione y sostenga el botón de la SETUP hasta que se enciende las luces de la LUZ BLINK de INDICADOR(INDICATOR LIGHT) , después versión el botón de la SETUP. 3. Presione y versión el botón del VCR (sigue habiendo la LUZ de INDICADOR entonces centelleo se encendió). 4. Encuentre el código de tres cifras para su VCR en la lista de código que comienza abajo e i
Resumo do conteúdo contido na página número 19
94901 Revised Size 1/29/02 2/25/02 4:16 PM Page 19 Pr ogramación Para El Rectángulo Del Cable 1. Gire manualmente el rectángulo del cable. 2. Presione y sostenga el botón de la SETUP hasta que las luces de la LUZ de INDICADOR, después BLINK release/versión el botón de la SETUP. 3. Presione y release/ versión el botón del CABLE (sigue habiendo la LUZ de INDICADOR entonces centelleo se encendió). 4. Encuentre el código de tres cifras para su rectángulo del cable en la lista de
Resumo do conteúdo contido na página número 20
94901 Revised Size 1/29/02 2/25/02 4:16 PM Page 20 El botón AUX. El botón AUX permite que usted asigne otro rectángulo de la TV, del VCR o del cable que se controlará. 1. Gire manualmente el rectángulo del dispositivo que usted desea asignar al button device. 2. Presione y sostenga el botón de la SETUP hasta que las luces de BLINK la LUZ de INDICADOR, después versión el botón de la SETUP. 3. Presione y versión el botón DVD/AUX. La LUZ de INDICADOR centelleo. 4. Presione device
