Manual do usuário Radio Shack PLXR5

Resumo do conteúdo contido na página número 1

2 WAY ELECTRONIC CROSSOVER
WITH SUBWOOFER REMOTE CONTROL
HIGH PERFORMANCE CAR AUDIO
MODEL:PLXR5
www.pyleaudio.com

Resumo do conteúdo contido na página número 2

INTRODUCTION FEATURES: 1

Resumo do conteúdo contido na página número 3

FUNCTIONS 1. SIGNAL INPUTS To be connected to the output of the source unit. 2. LOW PASS SUBWOOFER OUTPUT TERMINALS To be connected to the subwoofer channel amplifier left/right inputs. 3. HIGH PASS CHANNEL OUTPUT TERMINALS To be connected to the channel amplifier left/right inputs. 4. FUSE This crossover uses a 1-amp,blade-type fuses for protection from power surges or a short circuit. 5. POWER INPUT TERMINAL (12V) To be connected to the positive terminal of your vehicle battery or other const

Resumo do conteúdo contido na página número 4

FUNCTIONS 9. HIGH PASS GAIN CONTROL For adjusting the channel output signal level. 10. SUBWOOFER STEREO/MONO SWITCH For selection of stereo or mono mode subwoofer output. 11. HIGH-PASS FREQUENCY SELECTOR For selection of high-pass crossover frequency between 80 Hz and 2.5KHz 12. PHASE INVERTER Position the switch to the "180" position shifts the subwoofer output signals 180 degrees out-of-phase relative to the front and rear output signals. 13. BASS-BOOST LEVEL CONTROL (45Hz) For increasing th

Resumo do conteúdo contido na página número 5

ELECTRICAL & AUDIO CONNECTIONS 4

Resumo do conteúdo contido na página número 6

ELECTRICAL & AUDIO CONNECTIONS Precautions 1. To prevent short circuits, be sure to disconnect the negative battery ground lead before wiring the system up. 2. When you finish the installation, be sure to make one more check to be sure everything is done correctly. 3. Reinstate all car parts that were removed. 4. Reconnect the negative battery ground lead. Primary Wiring Descriptions ELECTRICAL PRIME CONNECTION DESCRIPTION 12V BATTERY + Connect to the positive battery terminal (constant + 12V s

Resumo do conteúdo contido na página número 7

NOISE CHECK & SYSTEM ADJUSTMENT 6

Resumo do conteúdo contido na página número 8

TROUBLE SHOOTING GUIDE 7

Resumo do conteúdo contido na página número 9

INSTALLATION INSTALLATION 8

Resumo do conteúdo contido na página número 10

SPECIFICATIONS SPECIFICATIONS Power source: 14.4 volts DC negative ground Input current 0.5 amp max Distortion: 0.01% THD at 1 V output level Frequency response: 10Hz-30KHz ±3 dB S/N ratio (A weighted): >95dB Separation: 60 dB Crossover frequencies (continuously variable): Low-pass: 35-400 Hz High-pass: 80-2.5KHz Crossover slope rate: 12 dB per octave 2nd Order Butter worth Subwoofer boost: Single octave + 12dB at 45 Hz Input impedance : > 10K Ohms Output impedance <1K Ohms Output voltage level