Resumo do conteúdo contido na página número 1
PRODUCT GUIDE
MODEL 463620809
IMPORTANT: Fill out the product record information below.
Serial Number
See rating label on grill for serial number.
Date Purchased
For support and to register your
grill, please visit us at
www.charbroil.com
If you have questions or need
assistance during assembly,
please call 1-800-241-7548.
Estimated assembly time: 35-40 minutes
The following are trademarks registered by W.C. Bradley Co. in the U.S. Patent and Trademark Office: Char-Broil®; America's Legenda
Resumo do conteúdo contido na página número 2
TABLE OF CONTENTS DANGER For Your Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3 If you smell gas: Use and Care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-9 Grilling Guide. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-13 1. Shut off gas to the appliance. Limited Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 2. Extinguish any open flame. 3. Open lid. Parts List. .
Resumo do conteúdo contido na página número 3
WARNING CALIFORNIA PROPOSITION 65 1. Combustion by-products produced when using this product contain chemicals known to the State of California to cause cancer, birth defects, and other reproductive harm. 2. This product contains chemicals, including lead and lead compounds, known to the State of California to cause cancer, birth defects or other reproductive harm. Wash your hands after handling this product. Installation Safety Precautions • Use grill, as purchased, only with LP (propane
Resumo do conteúdo contido na página número 4
LP Cylinder USE AND CARE • The LP cylinder used with your grill must meet the following requirements: • Use LP cylinders only with these required measurements: 12" DANGER (30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) capacity maximum. • NEVER store a spare LP cylinder under or near the • LP cylinders must be constructed and marked in accordance appliance or in an enclosed area. with specifications for LP cylinders of the U.S. Department of Transportation (DOT) or for C
Resumo do conteúdo contido na página número 5
e s i w k LP Tank Exchange Connecting Regulator To The LP Tank • Many retailers that sell grills offer you the option of replacing 1. LP tank must be properly secured onto grill. (Refer to your empty LP tank through an exchange service. Use only assembly section.) those reputable exchange companies that inspect, precision fill, 2. Turn all control knobs to the OFF position. test and certify their cylinders. Exchange your tank only for an OPD safety feature-equipped tank as described in the
Resumo do conteúdo contido na página número 6
Straight Leak Testing Valves, Hose and Regulator 1. Turn all grill control knobs to OFF. 2. Be sure regulator is tightly connected to LP cylinder. 3. Completely open LP cylinder valve by turning hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately. There is a major leak at the connection. Correct before proceeding. 4. Brush soapy solution onto areas circled below. Hold coupling nut and regulator as shown for proper connection to LP cylinder valve. 6. Turn the cou
Resumo do conteúdo contido na página número 7
Safety Tips s Before opening LP cylinder valve, check the coupling nut for WARNING tightness. s When grill is not in use, turn off all control knobs and LP For Safe Use Of Your Grill And To Avoid Serious cylinder valve. Injury: s Never move grill while in operation or still hot. s Use long-handled barbecue utensils and oven mitts to avoid • Do not let children operate or play near grill. burns and splatters. • Keep grill area clear and free from materials that burn. s Maximum load for side
Resumo do conteúdo contido na página número 8
Burner Flame Check • Light burner, rotate knobs from HIGH to LOW. You should see WARNING a smaller flame in LOW position than seen on HIGH. Always check flame prior to each use. If only low flame is seen refer to Turn controls and gas source or tank OFF when not "Sudden drop or low flame" in the Troubleshooting Section. in use. HI LO CAUTION If ignition does NOT occur in 5 seconds, turn the Hose Check burner controls OFF, wait 5 minutes and repeat the • Before each use, check to see if hos
Resumo do conteúdo contido na página número 9
• Porcelain grates: Because of glass-like composition, most Cleaning the Burner Assembly residue can be wiped away with baking soda/water solution or Follow these instructions to clean and/or replace parts of burner specially formulated cleaner. Use non-abrasive scouring assembly or if you have trouble igniting grill. powder for stubborn stains. 1. Turn gas off at control knobs and LP cylinder. • Painted surfaces: Wash with mild detergent or nonabrasive 2. Remove cooking grate and heat tent.
Resumo do conteúdo contido na página número 10
GRILLING GUIDE – Getting Started Temperature The temperature gauge in the hood of your new grill measures air temperature. The air temperature inside your grill will never First Time Use be as hot as the temperature at the cooking surface. Read your Assembly Manual and ensure the grill is put together properly. Remove all Point-of-Purchase advertising material from Note: Since 1995, all regulators (the part that attaches to the gas all grill surfaces before first use. We recommend oper
Resumo do conteúdo contido na página número 11
Rotisserie Cooking GRILLING GUIDE – Grilling 101 Rotisserie cooking is best for 'round' meat, such as large roasts, whole poultry, and pork. It generally requires an accessory motor Outdoor grilling is really quite simple. You'll succeed with and spit rod that allows the meat to be turned at a constant burgers, dogs, or steaks usually on your very first try. With speed. Rotisserie cooking is best done in front of a special experience, you will learn how to work with your grill, creati
Resumo do conteúdo contido na página número 12
Wood Chips GRILLING GUIDE – Tips & Tricks For extra smoke flavor when grilling, try adding wood chips. Cooking on your new grill is a hands-on experience, and it is Soak the chips in water for approximately 30 minutes before recommended to remain outside with your grill while cooking. adding to a smoke box or pan. Place smoke box or pan on top of Grilling can be affected by many external conditions. In cold the cooking grate above the flame. Turn grill on high until the weather, you wi
Resumo do conteúdo contido na página número 13
Cooking surfaces: If a bristle brush is used to clean any of the GRILLING GUIDE – Cleaning Your Grill grill cooking surfaces, ensure no loose bristles remain on cooking Why Clean? surfaces prior to grilling. It is not recommended to clean cooking We've all heard the saying, 'an ounce of prevention is worth a surfaces while grill is hot. pound of cure.’ This is great advice when it comes to keeping your grill clean. Storing Your Grill • Clean cooking grates. Routine Care • Store grill in dr
Resumo do conteúdo contido na página número 14
LIMITED WARRANTY This warranty only applies to units purchased from an authorized retailer. Manufacturer warrants to the original consumer-purchaser only that this product shall be free from defects in workmanship and materials after correct assembly and under normal and reasonable home use for the periods indicated below beginning on the date of purchase*. The manufacturer reserves the right to require that defective parts be returned, postage and or freight pre-paid by the consumer for re
Resumo do conteúdo contido na página número 15
PARTS LIST Key Qty Description NOT Pictured ... A 1 FIREBOX BOWL 1 HARDWARE PACK ... B 1 GRILL LID 1 ASSEMBLY MANUAL, ENGLISH C 1 LOGO PLATE D 1 HOSE/VALVE/REGULATOR ASSY E 1 CONTROL PANEL, MAIN F 1 BURNER G 1 ELECTRODE/COLLECTOR BOX H 2 SIDE SHELF I 2 MOUNTING BRACKET, LF/RB J 2 MOUNTING BRACKET, RF/LB K 1 CART LEG, UPPER LEFT, W/O TANK BRACE L 2 WHEEL M 1 AXLE ROD N 1 SIDE BRACE F/ TANK RETAINER O 1 CART LEG, UPPER RIGHT, W/O TANK BRACE P 1 MATCH HOLDER Q 1 LOWER LEG, CART, REAR, W/LEG EXTENDE
Resumo do conteúdo contido na página número 16
PARTS DIAGRAM B KK C Y GG AA H F Z II J JJ FF G A HH I H P O E K I EE J D DD CC N W BB R V Q V U M S T X L 16
Resumo do conteúdo contido na página número 17
Side Brace Support Bracket Upper Leg Support Bracket ASSEMBLY Left Leg 1 ‘ Place one upper leg as shown . NOTE: Left front and left back legs do not have leg extenders. In front, attach upper leg, side brace and left front leg (curve) with #10-24x1-1/4" screw and #10-24 flange nut. ‘ Attach support bracket in second hole from bottom of leg with hinge pins and hitch pins (A). Upper Leg Hitch Pin Qty. 2 Hinge Pin Qty. 2 Left Back Leg (Straight) #10-24x1-1/4’’ Machine Screw Qty. 1 Hi
Resumo do conteúdo contido na página número 18
Front Panel 3 Lay front legs down on the floor Fit front panel between legs. Attach with #10-24x2’’ Machine screws and #10-24 Flange nuts. #10-24 Flange Nut Front Panel Qty. 4 #10-24x2” Machine Screw Qty. 4 Back Braces to Cart 4 Attach back braces with #10-24x1-1/4’’ Machine screws and #10-24 Flange nuts. Wheels Turn assembly upside down. Insert axle rod through wheel, legs and other wheel. Attach with a wheel bushing and hitch pin. Attach all in second hole. Hitch Pin Wheel Qty
Resumo do conteúdo contido na página número 19
Control Panel 5 Stand cart upright In front, slide control panel between left and right legs, attach control panel with #10-24X2’’ Machine screws and #10-24 Flange nuts. Tighten all screws. Control panel Side Brace #10-24 Flange Nut Qty. 4 #10-24x2” Machine Screw Qty. 4 Valve/Hose/Regulator and Ignitor 6 Attach valve/hose/regulator assembly to control panel with #10-24x1/2’’ Machine screws. Attach ignitor to control panel using the stamped nut that’s provided. NOTE: if
Resumo do conteúdo contido na página número 20
Hook tank exclusion wires onto front panel brackets, attach other end to back brace with #8-32X3/8’’ Sheet metal screws. 7 #8-32X3/8’’ Sheet Metal Screw Qty. 2 Tank Exclusion Wire Heat Shield Attach heat shield with #10-24x1/2’’ Machine screws and #10-24 Flange nuts. 8 Tank Retainer Insert tank retainer into side brace and secure with #10-24x3/8’’ Wing nut. 10 Heat Shield #10-24X1/2” Machine Screw Qty. 2 #10-24 Wing Nut Flange Nut Qty. 2 #10-24x3/8’’ Wing Screw Qty. 1 Tank Ret
