Manual do usuário Honeywell T410A

Resumo do conteúdo contido na página número 1

T410A,B
Line Voltage
Electric Heat Thermostats
INSTALLATION INSTRUCTIONS
T410A provides single-line break.
1 PREPARATION
T410B provides double-line break.
Temperature Range: 40°F to 80°F (4°C to 27°C)
Proper installation of your Honeywell thermostat will
Electrical Ratings: 60 Hz noninductive
occur if you follow these instructions STEP-BY-
22A at 120-240 Vac; 19A at 277 Vac
STEP. It is recommended that as you read, understand
and complete each step, you check ✓ it off with pencil or
pen.
Do-It-Y

Resumo do conteúdo contido na página número 2

T410A,B LINE VOLTAGE ELECTRIC HEAT THERMOSTATS 3 WIRE AND MOUNT NEW THERMOSTAT 4 CHECK OUT THERMOSTAT Remove thermostat cover by grasping the top and Turn on the power to the heating system. bottom ends with fingers, and pulling outward. Turn setting knob all the way clockwise ; listen Connect wires to the thermostat as shown in the for clicking sound as switch makes contact. Electric applicable wiring diagram. Push the wires into the heater should begin operation. outlet box, and insert the th

Resumo do conteúdo contido na página número 3

T410A,B LINE VOLTAGE ELECTRIC HEAT THERMOSTATS 6 TROUBLESHOOTING Your Honeywell thermostat requires little or no attention. Most problems can generally be traced to the following: Symptom Checkout Action No heat. Make sure power is on at Heater should start to warm up within two minutes. If not, main service panel. Turn contact qualified electrician to check thermostat and heater. the temperature setting knob fully clockwise . Improper connections to With power to circuit OFF, tighten

Resumo do conteúdo contido na página número 4

Limited One-Year Warranty Honeywell warrants this product to be free from defects in the workmanship or materials, under normal use and service, for a period of one (1) year from the date of purchase by the consumer. If, at any time during the warranty period, the product is defective or malfunctions, Honeywell shall repair or replace it (at Honeywell’s option) within a reasonable period of time. If the product is defective, (i) return it, with a bill of sale or other dated proof of purchase, to