Resumo do conteúdo contido na página número 1
O l y m p i c
( 1 1 9 0 )
W o o d S t o v e a n d
F i r e p l a c e I n s e r t
• Residential Freestanding Stove
• Mobile-Home Freestanding Stove
• Alcove Approved
• Hearth-Stove Approved
• Masonry Fireplace Insert
Save these instructions
for future reference
SAFETY NOTICE:
If this appliance is not properly installed, a house fire may
result. For your safety, follow the installation directions.
Contact local building or fire officials about restrictions and
installation inspection require
Resumo do conteúdo contido na página número 2
2 Introduction Introduction We welcome you as a new owner of an Avalon Olympic wood-burning stove. In purchasing an Avalon Olympic you have joined the growing ranks of concerned individuals whose selection of an energy system reflects both a concern for the environment and aesthetics. The Avalon Olympic is one of the finest appliances the world over. This manual will explain the installation, operation, and maintenance of this appliance. Please familiarize yourself with the Owner's Manual be
Resumo do conteúdo contido na página número 3
Table of Contents 3 General Information Operating Your Appliance Introduction & Important Information...................... 2 Safety Notice.................................................... 25 Safety Precautions ............................................ 4 Before Your First Fire......................................... 25 Features & Specifications.................................... 6 Opening the Door.............................................. 25 Stove Installation Bypass Operation.......
Resumo do conteúdo contido na página número 4
Gas 4 Safety Precautions The viewing door must be Gasoline or other flammable closed and latched during liquids must never be used to operation. start the fire or "Freshen Up" the fire. Do not store or use gasoline or other flammable liquids in the vicinity of this Never block free airflow through appliance. the air vents on this appliance. This appliance is designed and Ashes must be disposed in a approved for the burning of cord metal container with a tight lid wood only. Do not attempt to a
Resumo do conteúdo contido na página número 5
Safety Precautions 5 When installed in a mobile home, this appliance must be Do not place clothing or other bolted to the floor, have outside flammable items on or near this air, and not be installed in the appliance. Mobile bedroom (Per H.U.D. requirements). Check with local Home building officials. Never try to repair or replace Do not make any changes or any part of this appliance unless modifications to an existing instructions are given in this masonry fireplace or chimney to manual. All
Resumo do conteúdo contido na página número 6
6 Features & Specifications Installation Options Features • Freestanding • EPA Phase II Approved • 3.1 Cubic Foot Firebox Volume • Freestanding in an Alcove • Single Operating Control • Freestanding in a Mobile Home • Accepts Logs Up to 24" Long • Masonry Fireplace Insert • Steel Plate Construction (1/4" & 3/16") NOTE: This fireplace insert is not approved for • Heavy Duty Refractory Firebrick Factory Built Z.C. (Metal) Fireplaces • Optional High-Tech Blower Heating Specifications Approximate Ma
Resumo do conteúdo contido na página número 7
Stove Installation (for qualified installers only) 7 SAFETY NOTICE: Please read this entire manual before you install and use your new room heater. Failure to follow instructions may result in property damage, bodily injury, or even death. Contact local building or fire officials about restrictions and installation inspection requirements in your area. Planning The Installation We suggest that you have an authorized Travis Industries dealer install your stove. If you install the stove yourself
Resumo do conteúdo contido na página número 8
8 Stove Installation (for qualified installers only) Floor Protection Requirements • Stove must be placed on the Travis Industries legs or Pedestal. • Floor protection must extend 6" to the sides and rear of the stove and 16" to the front of the stove (41-3/8" wide by 42-1/2" deep - see Figure 2 and Figure 3). • Floor protection must be non-combustible and at least .018" thick (26 guage). Stove Placement Requirements Clearances may be reduced by methods specified in NFPA 211, listed wall shields
Resumo do conteúdo contido na página número 9
Corner Wall Stove Installation (for qualified installers only) 9 Back Wall Top View - Clearance B Straight Installation Clearance E 6” Min. AAAAAAAAAAAAAA 29-3/8” A AAAAAAAAAAAA A Clearance A 5-3/4” A AAAAAAAAAAAA A Clearance D A AAAAAAAAAAAA A 6” Min. A AAAAAAAAAAAA A 20-1/2” A AAAAAAAAAAAA A Measure rear and side clearances from the nearest A AAAAAAAAAAAA A edge of the stove top. A AAAAAAAAAAAA A NOTE: vent diameter varies A AAAAAAAAAAAA A depending on brand and A AAAAAAAAAAAA A model. A A
Resumo do conteúdo contido na página número 10
10 Stove Installation (for qualified installers only) Chimney Requirements • DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE. • Chimney connector must be a minimum 24 MSG black or 26 MSG blued steel (6" diameter). Chimney must be used from the first floor or wall penetration to the chimney cap. • Use 6" diameter type UL 103 HT chimney from one manufacturer (do not mix brands) or code approved masonry chimney with a flue liner. • Chimney connector and chimney must be fastened
Resumo do conteúdo contido na página número 11
Stove Installation (for qualified installers only) 11 Chimney Termination Requirements • Must have an approved cap (to prevent water from entering) • Must not be located where it will become plugged by snow or other material • Must terminate at least 3' above the roof and at least 2' above any portion of the roof within 10' (see Figure 5) AA Chimney must extend 2' Slanted Roofs above any portion of the roof A AA Chimney must within 10' of the chimney extend 3' above the roof AA Chimney must
Resumo do conteúdo contido na página número 12
12 Stove Installation (for qualified installers only) Alcove Installation Requirements Whenever the stove is placed in a location where the ceiling height is less than 7' tall, it is considered an alcove installation. Because of the reduced height, the special installation requirements listed below must be met. • Chimney connector and chimney must be one of the following types: AMERI-TEC model DCC connector with AMERI-TEC UL 103 HT chimney DURAVENT model DVL connector with DURAVENT UL 103 HT ch
Resumo do conteúdo contido na página número 13
Stove Installation (for qualified installers only) 13 Mobile Home Requirements • Outside air must be installed - see "Outside Air Requirements" on page 11 • Chimney connector and chimney must be one of the following types: AMERI-TEC model DCC connector with AMERI-TEC UL 103 HT chimney DURAVENT model DVL connector with DURAVENT UL 103 HT chimney I.C.C. Excel HP connector with I.C.C. UL 103 HT chimney METALFAB model DW connector with METALFAB UL 103 HT chimney SECURITY model DP connector with SECU
Resumo do conteúdo contido na página número 14
14 Stove Installation (for qualified installers only) AA Chimney Cap Standard Ceiling (See the section "Chimney Termination Requirements" AA with a Factory for more details) Follow the chimney manufacturer's instructions Built Chimney and clearances for roof penetrations. A storm collar and flashing are required (some require a radiation A shield). Chimney Sections } A A Insulation AA AAA AA Follow the chimney manufacturer's instructions Minimum Air Space to and clearances for floor
Resumo do conteúdo contido na página número 15
} Stove Installation (for qualified installers only) 15 AA Exterior Factory Follow the chimney Chimney Cap AA manufacturer's Built Chimney (See the section "Chimney instructions and Termination Requirements" clearances for roof for more details) penetrations. A storm NOTE: A collar and flashing are Exterior chimneys are Chimney Sections required (some subject to greater } require a radiation Minimum Air Space to A A moisture and creosote shield). Combustibles (See accumulation due to
Resumo do conteúdo contido na página número 16
16 Stove Installation (for qualified installers only) NOTE: The chimney must have a clay Hearth Stove Direct tile liner. If it does not, the installation must use a positive connection (full Connection reline). The entire fireplace and Clay chimney must be clean, undamaged, Liner and meet all local building codes (UBC, NOTE: etc.). Damage must be repaired prior Stainless steel Direct connections require to installation. The chimney must be chimney connector installation of an airt
Resumo do conteúdo contido na página número 17
Fireplace Insert Installation (for qualified installers only) 17 SAFETY NOTICE: Please read this entire manual before you install and use your new room heater. Failure to follow instructions may result in property damage, bodily injury, or even death. Contact local building or fire officials about restrictions and installation inspection requirements in your area. Planning The Installation We suggest that you have an authorized Travis Industries dealer install your fireplace insert. If you ins
Resumo do conteúdo contido na página número 18
18 Fireplace Insert Installation (for qualified installers only) Top Air Chamber Extension The top air chamber extension is shipped separately with the heater and may be installed when the heater is used as an insert (see “Standard Model” under Insert Placement and Fireplace Requirements). Follow the directions below to install. 1. Remove the grill. Remove and discard the bypass extension rod (keep the pull ring). Remove the grill. Phillips Screwdriver Remove and discard the bypass extension
Resumo do conteúdo contido na página número 19
Combustible Mantel Non-Combustible Facing Non-Combustible Hearth Fireplace Insert Installation (for qualified installers only) 19 Fireplace Requirements Figure 16 shows the minimum size requirements. Minimum Standard Cook-Top Fireplace Size Model Model a Height (front) 22-1/4" 22-1/4" b Height (rear) 22-1/4" 22-1/4" c Width (front) 29-3/8" 29-3/8" j d Width (rear) 29-3/8" 29-3/8" h e Depth 14-1/8" 11-5/8" i f Hearth Depth* 22-3/8" 24-7/8" g Hearth Width 45-3/8" 45-3/8" b a h Facing Width 56-3/
Resumo do conteúdo contido na página número 20
Combustible Mantel Combustible Top Facing Facing Non-Combustible Hearth 20 Fireplace Insert Installation (for qualified installers only) Insert Placement Requirements • The insert must be placed so that no combustibles are within, or can swing within (e.g. drapes, doors), 36" of the front of the insert • Insert and hearth must be installed on a level, secure floor • The minimum clearances, facing, and hearth requirements in Figure 17 must be met. Standard Cook-Top Minimum Clearances Model Mode
