Manual do usuário Honeywell HE120A

Resumo do conteúdo contido na página número 1

TEMPLATE
HE120A,B
By-Pass Drum Humidifier
INSTALLATION INSTRUCTIONS
WARNING
HUMIDIFIER
Electrocution and Chemical Hazard.
Can cause death or blindness.
Do not cut or drill into any air conditioning line or electrical
BYPASS
accessory.
COLLAR
CAUTION
Freezing Water Hazard.
Can result in water damage to property.
Locate the humidifier where the ambient temperature is
between 32°F and 180°F (0°C and 93°C).
IMPORTANT
Template must be level before marking location.
1. Determine the best location

Resumo do conteúdo contido na página número 2

12. Cut an opening for the 6 in. (152 mm) collar in the selected COVER BEARING END OF DRUM ASSEMBLY DRUM SHAFT by-pass location. NOTE: Be sure to install a duct damper for summer shutoff if there is air conditioning. 13. Install the 6 in. (152 mm) collar. 14. Use sheet metal screws to connect the by-pass tubing from the collar to the humidifier. 15. Seal the connections with duct tape. 16. Insert the drain fitting in the bottom of the humidifier housing. NOTE: Be sure the overflow tube is po

Resumo do conteúdo contido na página número 3

All wiring must comply with applicable local codes, ordinances and regulations. 1. Mount the transformer in a convenient location. 2. Connect the wires to the 120V side of the transformer. 3. Wire the drum motor, transformer, and humidity Control. Refer to the humidity Control installation instructions for mounting and wiring information. SQUEEZE OPEN SLIGHTLY DRUM END TO INSTALL CHECKOUT PROCEDURE PAD TINNERMAN After winter startup or maintenance, use the following procedure to DRUM SHAFT