Manual do usuário AQUATECH Swimming Pool Cleaner

Resumo do conteúdo contido na página número 1

Jet Cleaner
Automatic Commercial Swimming Pool Cleaner
OPERATOR’S MANUAL
PLEASE READ THE ENTIRE MANUAL CAREFULLY BEFORE USING YOUR Jet Cleaner

Resumo do conteúdo contido na página número 2

Dear Customer Congratulations! You have purchased one of the best pool cleaners that technology can offer, the Jet Cleaner. The Jet Cleaner is a fully automatic robotic pool cleaner with the powerful Jet Drive Propulsion System. Through its unique design, the Jet Cleaner will systematically clean the entire pool, wash away debris with its Hydro-Scrubbing power washing jets and collect debris in the Filter Bag down to 2 microns in size. All you have to do is put the Jet Cleaner into your poo

Resumo do conteúdo contido na página número 3

OPERATING INSTRUCTIONS STEP 1 1. Place the Power Supply in a dry sheltered area at least 12 feet (3.6 meter) away from the pool. Since the Power Supply is not water proof, it should not be left out in the rain or placed into puddles of water. Plug the Power Supply cord into a 115Volt grounded GFCI outlet. STEP 2 1. Plug the Jet Cleaner’s Floating Cable into the Power Supply. Be sure that the Power Supply ON/OFF switch is in the OFF position. 2. Adjust the pi

Resumo do conteúdo contido na página número 4

OPERATING INSTRUCTIONS REMOVING THE Jet Cleaner FROM THE POOL Upon completion of the Jet Cleaner’s cleaning cycle (When the pool is clean), turn off the power supply by pressing the ON/OFF switch to the OFF position. Unplug the Jet Cleaner’s Floating Cable from the Power Supply Gently pull the Jet Cleaner toward you using the Floating Cable. When the Jet Cleaner is within reach, grab its handle and release the floating cable. Removing the Jet Cleaner by its Floating Cable may cause severe dam

Resumo do conteúdo contido na página número 5

Resumo do conteúdo contido na página número 6

CLEANING PATTERNS OTHER CLEANING PATTERNS If you feel that the Jet Cleaner is not cleaning your entire pool, you may wish to make one of the following adjustments to its cleaning pattern: SETTING THE CLEANING PATTERN FOR YOUR POOL Your Jet Cleaner is pre-set to scan and clean most pools 70 to 80 feet (20 to 24 meters) in length. The Jet Cleaner is factory set to look like the picture in Fig. 9 with one Lock pin installed on each side. The Jet Cleaner will systematically clean your pool

Resumo do conteúdo contido na página número 7

CLEANING PATTERNS FIG.11 Pins (2) position for large Pin position for small Pin position for medium commercial - public pools commercial - public pools commercial - public pools NOTE: These Images Show The Location Of The Second Pin Used For Large Commercial Pools. 7

Resumo do conteúdo contido na página número 8

Warranty Statement Other failure caused by repair, done by anyone other than an authorized service representative of AquaJet Inc., shall not be IMPORTANT covered. LEGAL LIMITATIONS: No agent, representative, dealer or Please read the following warranty statement employee of AquaJet Inc. has the authority to increase or alter the obligations of this warranty. carefully before taking any actions pertaining to TO VALIDATE THIS WARRANTY: The enclosed warranty repairs, servicing and especi