Resumo do conteúdo contido na página número 1
MITSUBISHI
AUTO-SCANNING WITH DIGITAL CONTROL
COLOR DISPLAY MONITOR
MODEL NFJ9905SKHUW
USER’S GUIDE
For future reference, record the serial
number of your display monitor in the
space below:
SERIAL No.
The serial number is located on the
rear cover of the monitor.
Resumo do conteúdo contido na página número 2
ENGLISH CAUTION The power cord provided with this monitor is designed for safety and must be used with a properly grounded outlet to avoid possible electrical shock. Do not remove the monitor cabinet as this can expose you to very high voltages and other hazards. ANMERKUNG: Dieser Monitor erfüllt die Anforderungen der deutschen Ergonomie-Norm ZH1/ 618/10.80 bei Verwendung der beiden folgenden Timing: Auflösung Videoeingang fH(kHz) fv(Hz) Interlace/Non-Interlace 1280x1024 Analog RGB, 0.7Vs-s 91.1
Resumo do conteúdo contido na página número 3
RADIO INTERFERENCE REGULATIONS STATEMENT FOR U.S.A. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communi
Resumo do conteúdo contido na página número 4
ENGLISH Congraturations! You have just purchased a TCO ‘95 approved and labelled product! Your choice has provided you with a product developed for professional use. Your purchase has also contributed to reducing the burden on the environment and to the further development of environmentally- adapted electronic products. Why do we have environmentally-labelled computers? In many countries, environmental labelling has become an established method for encouraging the adaptation of goods and ser
Resumo do conteúdo contido na página número 5
In and after the middle of this page, you will find a brief summary of the environmental requirements met by this product. The complete environmental criteria document may be ordered from: TCO Development Unit S-114 94 Stockholm Sweden Fax: +46 8 782 92 07 E-mail (Internet): development @tco.se Current information regarding TCO’95 approved and labelled products may also be obtained via the Internet, using the address: http//www.tco-info.com/ TCO’95 is a co-operative project between Environmen
Resumo do conteúdo contido na página número 6
ENGLISH User’s Guide CONTENTS 1. INTRODUCTION .................................................................................................. 6 1.1 Features ..................................................................................................... 6 1.2 Internal Preset Memory Capability ............................................................. 7 1.3 Power Management Function .................................................................... 7 1.4 DDC .........................
Resumo do conteúdo contido na página número 7
1 INTRODUCTION 1 Congratulations on your purchase of the high resolution color monitor. We designed this monitor to provide you with years of reliable trouble-free operation. This guide tells you how to connect, adjust and care for your monitor. This guide also provides technical specifications and instructions for troubleshooting any basic problems you may experience with your monitor. 1.1 Features The Diamond monitor is a 50cm/19"(46cm/18.0" Diagonal Viewable Image) intelligent, microproces
Resumo do conteúdo contido na página número 8
ENGLISH 1.2 Internal Preset Memory Capability To minimize adjustment needs, the factory has preset popular display standards into the monitor, as shown in Table 1. If any of these display standards are detected, the picture size and position are automatically adjusted. All of the factory presets may be overwritten by adjusting the user controls. The monitor is capable of automatically storing up to six additional display standards. The new display information must differ from any of the exist
Resumo do conteúdo contido na página número 9
1.4 DDC TM TM The monitor includes the DDC 1 and DDC 2B feature. DDC (Display Data Channel) is a commu- nication channel over which the monitor automatically informs the host system about its capabilities (e.g. each supported resolution with its corresponding timing). DDC is routed through previously unused pins of the 15-pin VGA connector. The system will perform “Plug and Play” feature if both, monitor and host, implement the DDC protocol. 1.5 Location Considerations When setting up and using
Resumo do conteúdo contido na página número 10
ENGLISH ON ON 1 2 3 4 5 6 1.7 Unpacking After you unpack the box you should have all of the items indicated in Figure 1. Save the box and packing materials in case you ship or transport the monitor. Complete and mail in warranty cards. 12 35 4 6 1. Color Monitor 2. AC Power Cord 7 8 9 10 11 3. Signal Cable SC-B102 4. USB Upstream Cable 5. Macintosh Adapter AD-A205 6. Floppy Disk 7. Ferrite Core 8. Software Agreement 9. User's Guide 10. Warranty-Card Figure 1. 11. Questionnaire-Card 1.8 Tilt/Sw
Resumo do conteúdo contido na página número 11
1.9 Quick Operation Chart To summarize the steps in connecting your computer with the color monitor and setting the necessary controls and switches, refer to the chart below. Connect the color monitor and computer with See 3. INSTALLATION AND CONNECTION the necessary cords and cables. Turn on the computer. Turn on the color monitor. Set the controls. See 4.OSD(On Screen Display) FUNCTIONS If a problem appears. OK OK See 5. TROUBLESHOOTING If the problem persists. Call for your authorized MITSU
Resumo do conteúdo contido na página número 12
ENGLISH 2 PART NAME 2 2.1 Control Names See Figures 3 and 4 for the location of the user controls, indicator and connectors. Each part is identified by number and is described individually. 1. POWER SWITCH 2. POWER-ON INDICATOR 7. DOWNSTREAM PORT 3. INPUT CONNECTOR SELECT BUTTON 6. FUNCTION ADJUST BUTTONS BNC / D-SUB SCROLL ENTER 4. SCROLL BUTTON 5. ENTER BUTTON Figure 3 2.2 Function 1. POWER SWITCH: A push-on / push-off switch for AC power. 2. POWER-ON INDICATOR: This indicator illuminates at
Resumo do conteúdo contido na página número 13
REAR D-SUB BNC COMP. R G B HD VD AC POWER CONNECTOR SIGNAL INPUT CONNECTOR (DB9-15P) 8. UPSTREAM PORT A D-SUB B BNC COMP. 1 R G B HD VD 2 9. DOWNSTREAM PORT SIGNAL INPUT CONNECTOR (BNC) Figure 4 8. UPSTREAM PORT: To connect to USB equipped computer(s). 9. DOWNSTREAM PORT: To connect to USB equipped peripherals, e.g, USB camera, keyboard, printer, etc. - 1-12 - ENGLISH
Resumo do conteúdo contido na página número 14
ENGLISH 3 INSTALLATION AND CONNECTION 3 On the back of the monitor four kinds of plug-in connections are provided: AC power connector for the AC input, DB9-15P connector and BNC connector for video signal input and USB ports for USB communication. 3.1 AC Power Connection One end of the AC power cord is connected into the AC power connector on the back of the monitor. The other end is plugged into a properly grounded three-prong AC outlet. The monitor’s auto-sensing power supply can automat
Resumo do conteúdo contido na página número 15
3.2.2 Connecting to An Apple Macintosh Computer Figure 6 shows the SC-B102 cable and AD-A205 Adapter to the video port in an Apple Macintosh. 1. Power off, both the monitor and the computer. 2. Set the DIP switches of Macintosh Adapter according to the setting chart. (See 7.3 Macintosh Adapter AD-A205 settings) 3. Connect the 15-pin (DB-15P) end of the AD-A205 Adapter to the straight 15-pin connector on the Macintosh video port on the CPU or on the video board. 4. Connect the sub-miniature 15-p
Resumo do conteúdo contido na página número 16
ENGLISH 3.2.4 BNC Connection (1) IN CASE OF A COMPOSITE SYNC ON GREEN VIDEO SIGNAL (SYNC ON GREEN): Connect the R, G and B video signals to the BNC receptacles on the back of the monitor. D-SUB BNC COMP. R G B HD VD (2) IN CASE OF EXTERNAL COMPOSITE SYNC SIGNAL: Connect the R, G and B video signals and the Composite sync signal to BNC receptacles on rear panel, respectively. D-SUB BNC COMP. R G B HD VD (3) IN CASE OF SEPARATE HORIZONTAL AND VERTICAL SYNC SIGNALS: Connect the R, G and B video sig
Resumo do conteúdo contido na página número 17
3.3 USB System Basic Application FRONT BACK D-SUB BNC COMP. R G B HD VD Upstream Ports Downstream Port A D-SUB B BNC COMP. R G B HD VD 1 2 Downstream Ports Scanner Keyboard Camera Computer NOTE The computer is required to have Windows 98 installed and USB functions. When connecting one computer, either Upstream port A or B is available. The Upstream port with that the computer is connected is detected automatically. - 1-16 - ENGLISH
Resumo do conteúdo contido na página número 18
ENGLISH CAUTION Use the included ferrite core with the USB cable which is connected to the USB connectors (Downstream) to reduce the possibility of causing interference to radio, television, and other electrical devices. D-SUB BNC COMP. A B R G B HD VD 1 2 1 USB CONNCTOR 2 (DOWNSTREAM) USB CABLE FERRITE CORE HOW TO MOUNT THE FERRITE CORE Place the included ferrite core under the USB cable at approx. 1.2 in.(3 cm) from the USB plug. Then, close the plastic case until you have a clock. USB Cable
Resumo do conteúdo contido na página número 19
3.4 Installation of USB Function 1. Power on the display monitor and computer. 2. Enumerate Mitsubishi USB HUB using the following procedure. NOTE During the enumeration of Mitsubishi USB Hub, con- nect the keyboard and mouse equipped with USB function, to the computer and not to the downstream ports on the display monitor. After the enumeration, the keyboard and mouse can be used by connecting to the downstream ports. (1) Insert the included floppy disk in the computer. (2) Connect the compute
Resumo do conteúdo contido na página número 20
ENGLISH 3. Enumerate the Mitsubishi Monitor Function using the following procedure. (1) Insert Windows 98 CD-ROM into your computer. Then, Figure 11 will ap- pear. Figure 11 (2) Click “Next” on Figure 11 and Figure 12 will appear. Figure 12 (3) Click “Next” on Figure 12 and Figure 13 will appear. Figure 13 - 1-19 -
