Краткое содержание страницы № 1
26998
40-Channel 900 MHz Caller ID Cordless
Telephone/Answering System
User’s Guide
1
We bring good things to life.
Краткое содержание страницы № 2
EQUIPMENT APPROVAL INFORMATION Your telephone equipment is approved for connection to the Public Switched Telephone Network and is in compliance with parts 15 and 68, FCC Rules and Regulations and the Technical Requirements for Telephone Terminal Equipment published by ACTA. 1 Notification to the Local Telephone Company On the bottom of this equipment is a label indicating, among other information, the US number and Ringer Equivalence Number (REN) for the equipment. You must, upon request, provi
Краткое содержание страницы № 3
TABLE OF CONTENTS CANCEL ......................................... 13 EQUIPMENT APPROVAL INFORMATION........ 2 INTERFERENCE INFORMATION ................... 2 IN USE/INDICATOR LIGHT .................. 13 FINDING THE HANDSET ..................... 13 HEARING AID COMPATIBILITY................... 2 CHANNEL BUTTON .......................... 13 INTRODUCTION ..................................... 5 TEMPORARY TONE ........................... 13 BEFORE YOU BEGIN .............................. 5 CALLER ID F
Краткое содержание страницы № 4
ANSWERING SYSTEM OPERATION .......... 19 HEADSET AND BELT CLIP OPERATION ..... 24 MESSAGES INDICATOR ..................... 19 CONNECTING A HEADSET TO THE SCREENING CALLS FROM THE BASE .... 20 HANDSET....................................... 24 MESSAGE PLAYBACK ....................... 20 CONNECTING THE BELT CLIP .............. 24 MEMORY FULL ............................... 20 CHANGING THE BATTERY ...................... 25 ERASING MESSAGES ....................... 20 BATTERY SAFETY PRECAUTIONS .25 LE
Краткое содержание страницы № 5
in use/charge INTRODUCTION Your cordless telephone/answering system with Caller ID is designed to give you flexibility in use and high quality performance. To get the most from your new cordless telephone/answering system, we suggest that you take a few minutes right now to read through this instruction manual. CAUTION: When using telephone equipment, there are basic safety instructions that should always be followed. Refer to the IMPORTANT SAFETY INSTRUCTIONS provided with this product and save
Краткое содержание страницы № 6
INSTALLATION AND SET UP CAUTION: Always disconnect phone cords from the wall outlets before battery installation or replacement. INSTALLATION NOTE: Some cordless telephones operate at frequencies that may cause interference to nearby TVs, microwave ovens, and VCRs. To minimize or prevent such interference, the base of the cordless telephone should not be placed near or on top of a TV, microwave oven, or VCR. If interference continues, moving the cordless telephone farther away from the TV or VCR
Краткое содержание страницы № 7
INSTALLING THE PHONE Your cordless telephone/answering system should be placed on a level surface such as a desk or table top, or you can mount it on a wall. CID/VOL TALK CALL BACK answerer redial format memory review skip play/stop 1 3 def 2 abc 4 ghi jkl 6 mno 5 pqrs wxyz 7 8 tuv 9 cancel 1 erase tone #pause * 0oper delete program ringer channel flash off on 2 CONNECTING THE AC (ELECTRICAL) POWER Plug the power supply cord into the power jack on the bottom of the base and the other end into
Краткое содержание страницы № 8
WALL MOUNTING NOTE: For best results, leave the phone on a flat surface during initial charging before you hang the phone on the wall. If you want to mount the phone on a wall, slip the mounting holes (on the back of the base) over the wall plate posts, and slide the unit down into place. (Wall plate not included.) TELEPHONE SETUP Display TALK/CALLBACK button CID/VOL buttons memory button format/answerer button CID/VOL TALK redial button CALL BACK skip button answerer redial format memory review
Краткое содержание страницы № 9
There are three programmable menus available: Language, Tone/Pulse Dialing, and Local Area Code. SETTING THE DISPLAY LANGUAGE 1. Make sure the phone is OFF (not in TALK mode). 2. Press and release flash/program button until 1 ENG 2 FRA 3 ESP shows in the display. The default setting is English 3. Use the handset number pad or press the left or right arrow buttons to enter the desired setting. For example, to choose English press the number 1 key. 4. When finished, press and release flash/program
Краткое содержание страницы № 10
in use/charge ANSWERING SYSTEM SETUP volume buttons min button memo button display hour button volume memo day/check button rev/skip page - + page button messages answer on/off play/stop button erase in use/charge mic announce button indicator erase button review (-)/skip (+) button play/stop button mic This section shows you how to set up your answering system to receive incoming calls. Before you begin the setup, you must turn on the answering system. • Press the answer on/off button on the si
Краткое содержание страницы № 11
SETTING THE RING SELECT Use the RING SELECT switch on the bottom of the base to select the number of times you want the phone to ring before the system answers the call. You may choose three or five rings. SPEAKER VOLUME Use the volume up or down to adjust speaker volume to a comfortable level. RECORDING THE OUTGOING ANNOUNCEMENT For best results when recording, you should be about nine inches from the microphone, and eliminate as much background noise as possible. 1. Make sure the answering sys
Краткое содержание страницы № 12
CORDLESS PHONE BASICS MAKING A CALL To make a call: • Press the TALK/CALLBACK button before you dial. • Press TALK/CALLBACK button or place the handset in the base to hang up. IMPORTANT: Because cordless phones operate on electricity, you should have at least one phone in your home that isn’t cordless, in case the power in your home goes out. REDIAL Press the redial button to redial the last number you called (up to 32 digits). If you get a busy signal, and want to keep dialing the number, pres
Краткое содержание страницы № 13
RINGER SWITCH The ringer switch must be ON for the handset to ring during incoming calls. CANCEL Press the *tone/cancel button to cancel any command you initiated. IN USE/INDICATOR LIGHT The phone is ON or being charged when the in use/charge indicator on the base is turned on. FINDING THE HANDSET This feature helps to locate a misplaced handset. Press the page button on the base. The display shows PAGING. The handset beeps for about two minutes or until you press TALK/CALLBACK on the handset or
Краткое содержание страницы № 14
CALLER ID FEATURES This unit receives and displays information transmitted by your local phone company. This information can include the phone number, date, and time; or the name, phone number, date, and time. The unit can store up to 40 calls for later review. TRANSFERRING CALLER ID RECORDS TO MEMORY You may transfer a Caller ID record to the phone’s internal memory. 1. Use the CID/VOL(-) arrow or CID/VOL(+) arrow button to scroll to the desired record. 2. Press the memory button, and then pres
Краткое содержание страницы № 15
CALLER ID WITH CALL WAITING Provided you subscribe to Caller ID with Call Waiting service from your phone company, you may see who is calling when you hear the call waiting beep. The caller identification information appears in the display after you hear the tone. • Press the flash/program button to put the current call on hold so that you can answer the incoming call. RECEIVING AND STORING CALLS When you receive a call, Caller ID information is transmitted by the phone company to your telephone
Краткое содержание страницы № 16
DELETING THE CURRENT RECORD 1. Press channel/delete button. The display shows DELETE? 2. Press delete/channel again to erase the current record. The display shows DELETED, and you will hear a confirmation tone. DELETING ALL RECORDS 1. Press and hold channel/delete. The display shows DELETE ALL? 2. Press channel/delete again to erase all records. You will hear a confirmation tone. DIALING A CALLER ID NUMBER 1. Make sure the phone is OFF. 2. Use the CID/VOL left (-) and right (+) arrow buttons to
Краткое содержание страницы № 17
THE MEMORY FEATURE Store up to ten 24-digit numbers in memory for quick dialing. This memory feature is in addition to the 40 Caller ID records that can be stored in memory. STORING A NUMBER IN MEMORY 1. Make sure the phone is OFF (not in TALK mode). 2. Press the memory button. 3. Press the desired memory location number (0 through 9). 4. Press the memory button again. The display shows ENTER NAME. NOTE: If you don’t want to enter the name, skip step 5. 5. Use the keypad to store a name (up to 1
Краткое содержание страницы № 18
DIALING A STORED NUMBER 1. Make sure the phone is ON by pressing the TALK/CALLBACK button. 2. Press memory. 3. Press the number (0-9) for the desired memory location. The number dials automatically. DIALING CALLER ID NUMBERS 1. Make sure the phone is OFF. 2. Press memory. 3. Use the CID/VOL left (-) and right (+) arrow buttons to scroll through the numbers stored in memory until the desired number is shown. 4. Press TALK/CALLBACK. The number dials automatically. IMPORTANT: If you make test calls
Краткое содержание страницы № 19
1. Make sure the phone is ON. 2. Press memory and then press 7. 3. When you hear the access tone, press memory and then press 8. 4. At the next access tone, press memory and then 9. TIP: Wait for the access tones before pressing the next memory button, or your call might not go through. INSERTING A PAUSE IN THE DIALING SEQUENCE Press the # pause button to insert a delay in the dialing sequence of a stored telephone number when a pause is needed to wait for a dial tone (for example after you dial
Краткое содержание страницы № 20
SCREENING CALLS FROM THE BASE You can screen incoming calls by waiting for the caller to begin leaving a message (to hear who it is), then pick up the handset, and press TALK/ CALLBACK to talk to the caller. The answering system automatically stops recording when you activate the handset or pick up an extension phone. TIP: Make sure the volume on the base is set loud enough to hear your incoming calls. MESSAGE PLAYBACK The messages indicator lets you know when you have messages. To play messages
