Краткое содержание страницы № 1
Краткое содержание страницы № 2
IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a dry cloth for cleaning. 4. Do not use this product near water sources,
Краткое содержание страницы № 3
13. Do not use the telephone in the vicinity of a gas leak. CAUTION: TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS BY THE BATTERY, READ AND FOLLOW THESE INSTRUCTIONS. 1. Use only the appropriate type and size battery pack specified in the instruction manual provided for this product. 2. Do not dispose of the battery pack in a fire. The cell may explode. Check with State and local codes for possible special disposal instructions. 3. Do not open or mutilate the battery pack. Released electrol
Краткое содержание страницы № 4
SERVICE REQUIREMENTS If the cordless telephone should malfunction, or need changes or modifications, all repairs will be performed by an authorized Toshiba Service Station. This unit has been registered with the FCC for direct connection to the telephone network. Under the FCC program, no customer is authorized to repair this unit. This applies to a unit both in and out of warranty. If an unauthorized repair is performed, the registration of the unit for direct connection to the network will be
Краткое содержание страницы № 5
INTRODUCTION Toshiba America Consumer Products, Inc. takes pride in presenting your phone, one of the finest cordless telephones available. Intelligent design, superb craftsmanship, and the latest technological advances have been combined to provide you with a telephone that is easy to operate and will provide you with years of dependable service. Please take the time now to read your Owner’s Manual carefully, so that you may enjoy the many convenient features of your telephone. FEATURES • 900 M
Краткое содержание страницы № 6
INSTALLATION 1. SETTING UP THE BASE UNIT For use on a desk or counter top follow the instructions below. DESKTOP MOUNTING: Fasten the AC adaptor cord to prevent it from being disconnected. Raise the antenna to vertical position. Single-Line Telephone Jack (RJ11C) Telephone Line Cord Power Outlet (AC 120V, 60Hz) AC Adaptor • USE ONLY WITH Supplied AC ADAPTOR (TAC-8001); power source AC 120V, 60Hz/DC 9V). • The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel w
Краткое содержание страницы № 7
9 0 0 M Hz 2. CHARGE THE BATTERY PACK Note Use only the supplied battery pack (TRB-8000 power source Red Black 600 mAh, 3.6V). q Remove the battery compartment cover on the back of the handset by sliding it down. w Plug the battery pack cord into the connector in the battery compartment by observing the correct polarity. It fits in only one way. e Place the battery pack in the battery compartment. r Put the battery compartment cover back by sliding until it snaps into place. Make sure not to ge
Краткое содержание страницы № 8
After the battery pack is fully charged; Operation Approx. battery life While in use (Talk mode) up to 7 hours While not in use (Standby mode) up to 14 days When TALK/BATT LOW LED blinks, all handset buttons are disabled and the battery needs to be charged. If this occurs during a call, you hear short beeps. Finish the call as soon as possible and place the handset on the base unit. Note If a call comes in when the battery is too low to operate properly, you will be unable to answer the call or
Краткое содержание страницы № 9
• Route the cords through the guides. • Place the base unit on the posts of the wall plate and push down until it is firmly seated. • USE ONLY WITH Supplied AC ADAPTOR (TAC-8001 power source AC 120V, 60Hz/DC 9V). Notes • Do not use any outlet controlled by a wall switch. • If you don’t have a standard wall plate, cut out the template on this page and use it to position 3 two screws (minimum length of 1 /8 inches) into the wall with the heads protruding about 1/4 inch. CUT CUT Wall mount template
Краткое содержание страницы № 10
CORDLESS TELEPHONE FT-8001 IN USE CHARGE PAGE 900MHz COMPANDOR NOISE REDUCTION MEM TONE MUTE CH TALK GHI 4 PQ RS7 900MHz TALK BATT LOW COMPANDOR NOISE REDUCTION 1 VOL/RING RDL/P ABC2 JKL 5 TUV 8 OPER0 FLASH DEF3 MNO6 WX YZ 9 # LOCATIONS OF CONTROLS HANDSET CONTROLS Antenna Speed Dial Index Card (back) Write down numbers stored in memory. TALK/BATT LOW LED RDL/P (Redial/Pause) button FLASH button TALK button Dialpad (Tone) button TONE/ # / PULSE button (Memory) button MEM button VOL/RING butto
Краткое содержание страницы № 11
Please see “LOCATION OF CONTROLS” for the location of each button used for the following operations. SETTING THE DIAL MODE Most phone systems use tone dialing. But, to use tone dialing, you must have a tone service dialing system supplied by your telephone company. Then you must set your telephone dial mode for the type of service you have. If you are not sure which type of service you have, do the following steps. q With the phone in the Standby mode, press and hold FLASH until you hear a c
Краткое содержание страницы № 12
MAKING A CALL 1. MAKING A CALL TALK q Press . The TALK/BATT LOW LED will light. w Listen for the dialtone. 1, 4 e Key in the phone number you are calling. TALK r To hang up, press again or place the 3 handset on the base unit. The TALK/BATT LOW LED turns off. 2. ANSWERING A CALL q Simply pick up the handset or press any key if the handset is located away from the base unit. The TALK/BATT LOW LED will light. TALK w To hang up, press or place the handset 1, 2 on the base unit. The TALK/BATT LOW
Краткое содержание страницы № 13
3. INTERFERENCE OR STATIC If you hear noise during a call, press CH to select another channel. The TALK/BATT LOW LED blinks while changing a channel. 4. CHANGING THE RINGER VOLUME VOL/RING Press to select one of four ringer tone and volume combinations during standby mode. VOL/RING Each time you press , the setting will change. 5. CHANGING THE HANDSET SPEAKER VOLUME VOL/RING During a telephone call, press to select one of three speaker volume levels; Low, Medium and High. The setting will rem
Краткое содержание страницы № 14
8. SENDING TONE SIGNAL (for Pulse service user) Even if you have Pulse service (the dial mode is set to Pulse), you can use this phone with banking and other phone services requiring touch tone signals. q Dial the service number and wait for the connection. w Press TONE/ , then enter the numbers required. You will hear the tones on the line. 9. MUTING Press MUTE to turn off the microphone during a conversation. The TALK/BATT LOW LED blinks. You may speak to someone in the room without the calle
Краткое содержание страницы № 15
MEMORY DIALING You can store up to 10 telephone numbers in memory. Notes In memory dialing operation, • If more than 20 seconds elapse between pressing buttons, the operation will be cancelled and you must start over again. • If you press a wrong button, an error tone sounds and the handset returns to standby mode. • If a call comes in, the operation will be cancelled and you will hear the ring. 1. STORING NUMBERS You can store up to 16 digits including #, and PAUSE in one memory address. TALK
Краткое содержание страницы № 16
Replacing a telephone number Just store the new number following the same steps in “1. STORING NUMBERS.” The new number will replace the previously stored one. 2. DIALING A STORED NUMBER TALK q Pick up the handset and press . The TALK/BATT LOW LED lights. MEM w Press . e Enter the memory address (0 to 9). The stored number will be dialed. Note If you enter a memory address which does not have any stored number, error beeps sound. 3. INSERTING A PAUSE IN MEMORY RDL/P Use (redial/pause) to make a
Краткое содержание страницы № 17
ACCESSORIES Rechargeable Battery pack (1) TRB-8000 Part # RC004931 AC Adaptor (1) TAC-8001 Part # RC009790 for FT-8001 TAC-8001 Part # RC009791 for FT-8001W Telephone Cord (1) Part # RC008231 Wall Mount Bracket (1) Part # RC009245 for FT-8001 Part # RC009246 for FT-8001W Owner’s Manual (1) Part # RC012151 Speed Dial Index Card (1) Part # RC005157 For the purchase of Accessories, please call 1-877-644-7373. 16
Краткое содержание страницы № 18
TROUBLESHOOTING GUIDE Should any problem occur with the set, make the following simple tests to determine whether or not servicing is required. PROBLEM SOLUTION The handset battery •The charging contacts of the handset and base are not does not charge. clean. →Clean them with a dry cloth. •The battery connector is not connected with correct polarity. →Install the battery correctly. •The battery is several years old. →Replace with a new battery. Battery becomes low •The battery was not fully char
Краткое содержание страницы № 19
PROBLEM SOLUTION The handset does •The handset is located too far away from the base or the not ring or receive a battery has been discharged. page. →Return the handset to charge when your call is finished. •The digital security code is changed. →Remove the handset from the base unit and press PAGE and hold . While the handset is emitting, return the handset to the base unit. •The battery is low. →Place the handset on the base unit to recharge. •The charging contacts of the handset and the base
Краткое содержание страницы № 20
WARRANTY/SERVICE TELEPHONE/TELEPHONE ANSWER MACHINE LIMITED WARRANTY Toshiba America Consumer Products, Inc. (“TACP”), and Toshiba Hawaii, Inc. (“THI”), make the following limited warranties. These limited warranties extend to the original consumer purchaser or any person receiving this set as a gift from the original consumer purchaser and to no other purchaser or transferee. Limited One (1) Year Warranty of Labor (3) Within the continental U.S.A., if you should find a defective product within
