Руководство по эксплуатации Human Touch HT-270

Краткое содержание страницы № 1

06/01/08

X1103
REPLACING THE FOOT AND CALF MASSAGER
HT-270
®
To ensure that Human Touch products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
SERVICE LEVEL: 3
product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
Tools Required: Nail clipper or other instrument suitable for cutting zip ties, Phillips-head screwdriver, flat-head
screwdriv

Краткое содержание страницы № 2

5. Using a Phillips-head screwdriver, remove the two screws from the two brackets on the massager frame, then remove the brackets. (Fig.3). 6. Locate Pin A, then use a flat-head screwdriver (and a vice-grip if necessary) to loosen the pin. Do not remove the pin from the bracket. It is helpful to leave it in place to hold the massager at the correct angle while removing the second pin. 7. Locate Pin B, use a flat-head screwdriver to loosen the pin, then use a vice-grip to remove the pin from

Краткое содержание страницы № 3

INSTALLING THE NEW MASSAGER 1. Place the new massager into position, then insert pin A just far enough into the left side of bracket A to hold it in place. 2. Line up the actuator bracket with the mounting point on Bracket A, then push the pin through the bracket as far as it will go by hand. 3. Line up the left side of the massager with Bracket B, then insert Pin B through the bracket as far as it will go by hand. 4. Use a small hammer to push both pins until the pin heads are flush with th