Краткое содержание страницы № 1
TFT-LCD TELEVISION
OWNER`S MANUAL
MODEL: L32H8
L40H8
L42H8
Please READ this manual carefully before
operating your TV, and retain it for future
reference.
Краткое содержание страницы № 2
C CO ON NT TE EN NT T BEFORE OPERATING Warning..............................................................................................................1 Important Safety Instructions..............................................................................2 Buttons and interface location........................................................................... 4 Remote controller...............................................................................................6
Краткое содержание страницы № 3
Warning CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL. *To avoid electric hazards, it is strongly suggested that the back cover not be opened, as there is no any accessory inside the casing. *If necessary, please contact authorized after-sales services. *A lighting flash mark in a triangle: A potentially hazardous situation, which, if not a
Краткое содержание страницы № 4
Important Safety Instructions The product should be tightly fixed to avoid To avoid fire hazards, do not use this drop damages and even fire. product under direct sunlight or closely to heat sources. Do not locate the product close to water Unplug the power supply and antenna of the product when there is a rainstorm, or oil, which may cause fire hazards. especially Thunderstorm. Do not use damaged or worn electric plugs Do not connect excessive sockets in parallel and keep electric cord
Краткое содержание страницы № 5
Important Safety Instructions Don't use or store inflammable materials Don't place the product in a humid area to near the product to avoid explosion or fire avoid fire hazards. hazards. Never touch the plug when your hand is wet The antenna of the product should be away as this might cause electric shocks. from electric cable to avoid electric shocks. Always make sure that the televisionis well When antenna is used, measures should be plugged as poor electric taken to prevent water con
Краткое содержание страницы № 6
Buttons and interface location - This is a simplified representation of front panel. - Here shown may be somewhat different from your TV. Front panel Control Side TV/AV 1 MENU 2 VOL+ 3 VOL- CH+ 4 CH- POWER 5 Side AV Remote Sensor Right audio input Indicator Left audio input Video input 1. TV/AV button 2. MENU button 3. VOL+/- : Volume decrease/increase,adjusting the menu 4. CH+/- : Channel number decrease/ increase 5. Power button 4
Краткое содержание страницы № 7
Buttons and interface location Rear panel Control ANT . PC IN VIDEO L R COMPONENT IN HDMI2 AV OUT Y Pb/Cb Pr/Cr AUDIO L R PC/DVI HDMI1 AV1 IN AUDIO IN VIDEO L R S-VEDIO IN HDMI Input Connnect a signal to HDMI PC Input Connect the monitor output connector from a PC to the jack Component Input Connect a component video/audiodevice to these jacks. AV1 Input Connect audio/video out from an audio/video device to these jacks. S-Video Input Connect S-Video out from a S-Video device to these j
Краткое содержание страницы № 8
Remote controller Battery loading 1.Slide open the cover of the battery compartment on the back of the remote controller. 2.Load two 5# (AA)alkaline batteries in the compartment. (plus and minus poles to respective mark) 3.Replace the cover of the battery compartment. 1 2 3 Precautions As strong light may interfere the Make sure that two AA alkaline batteries signals, change your position to are loaded. The batteries must be of the operate the remote controller if same type. The batt
Краткое содержание страницы № 9
Remote controller key function - The remote controller cannot be operated unless the batteries are properly loaded. - When using the remote control, aim it at the remote control sensor on the TV. Function introduction STILL I/II (NICAM) Freezes the currently-viewed Power On/Standby picture, but audio continues. MUTE STILL any other programmed equipment Press STILL button again to off. resume the normal picture. SCAN SLEEP PIP DISPLAY DISPLAY Display ON/OFF MUTE Switches the sound on or off
Краткое содержание страницы № 10
External Equipment Connections - Antenna or Cable Service without a Cable Box Connections - For optimum picture quality, adjust antenna direction if needed. outdoor antenna (not supply) Antenna input 75 standard coaxial type ANT IN 75 coaxial cable 300 twin-lead cable Plug Antenna adapter (additional purchase) (not supply) Note * It is recommended that you'd better use 75 coaxial cable to remove the disturbance caused by airwave. * Don't bind antenna cable and electric wire together. T
Краткое содержание страницы № 11
External Equipment Connections NOTE: All cables shown are not included with the TV. Choose Your Connection There are several ways to connect your television, depending on the components you want to connect and the quality of the signal you want to achieve. The following are examples of some ways to connect your TV. Choose the connection which is best for you. VCR Connection - To avoid picture noise (interference), leave an adequate distance between the VCR and TV. Connection Option 1 Set VCR
Краткое содержание страницы № 12
External Equipment Connections DVD Setup How to connect 1. Connect the DVD video outputs (Y, Pb/Cb, Pr/Cr) to the COMPONENT (Y, Pb/Cb, Pr/Cr) input jacks on the TV and connect the DVD audio outputs to the AUDIO jacks on the TV, VIDEO L R as shown in the figure. COMPONENT IN AV OUT 2. If your DVD only has an S-Video output AUDIO Y Pb/Cb Pr/Cr L R jack, connect this to the S-VIDEO input AV1 IN on the TV and Connect the DVD audio outputs to the AV IN jacks on the TV, VIDEO L R S-VED
Краткое содержание страницы № 13
External Equipment Connections PC Setup How to connect 1. Use the TV`s PC IN port for video connections. 2. Then, make the corresponding audio connection. If using a sound card, adjust the PC IN PC sound as required. HDMI2 How to use 1. Turn on the PC and the TV. PC/DVI HDMI1 2. Turn on the display by pressing the POWER AUDIO IN button on the TV's remote control. 3. Use TV/AV on the remote control to select PC source. 4. Check the image on your TV. There may be noise associated with the
Краткое содержание страницы № 14
External Equipment Connections Connecting Headphones You can connect a set of headphones to your set if you wish to watch a TV programme without disturbing the other people in the room. Plug a set of headphones into the 3.5mm mini-jack socket on the rear panel of the set. ANT. Note Prolonged use of headphones at a high volume may damage your hearing. You will not receive sound from the speakers when you connect headphones to the system. Power source TO USE AC POWER SOURCE Use the AC polar
Краткое содержание страницы № 15
Switching ON/OFF the TV set In the manual, the OSD (on screen display) may be different from your TV`s because it is just an example to help you with the TV operation. Switching ON/OFF the TV set 1 first, connect power cord correctly and the power indicator will light. 2 Press POWER button on the remote control again. 3 If you want to exchange to standing by status, please press down POWER button on the remote controller. 4 Disconnect the power supply or unplug the television if it is int
Краткое содержание страницы № 16
Searching Channel In this section, how to use the remote control to set channel is explained. You can also use buttons on the TV set to set channel. Automatic search 1 Press MENU button and then use VOL+/- button to select the Color System Auto Tuner menu. Sound System Auto Fine Tune Note : 1.the Tuner menu will be only operated in normal Auto Search TV mode; Manual Search 2. When the Tuning Lock is setting
Краткое содержание страницы № 17
Searching Channel Color System Color System Auto 1 Press MENU button and then use VOL+/- button to Sound System Auto select the Tuner menu. Fine Tune Auto Search 2 Press CH+/- button to select Color System item. Manual Search 3 Press VOL+ button to select the correct color system. In general, you can set it as "Auto". Tuner Sound System Color System Auto 1 Press MENU button and then use VOL+/- button to Sound System
Краткое содержание страницы № 18
Watching TV Program You can watch TV program in a presetting channel. To select the TV mode Before watching TV program, you may ensure your TV in TV mode. Press TV button to select TV mode. How to select the desired program 1 Using "Digits" buttons. Directly enter the channel number with the numeric keypad on the remote control. If to select channel numbers of double-digit or three-figure ,press continuously the numeric buttons in three second. 2 Using CH+/- button. Press the
Краткое содержание страницы № 19
Picture Control Functions The TV menu gives you can an overviews of the menus you can select. Note: Depending on the input signal, one or more menu items may not be selectable. How to select picture modes You can quickly select the desired picture mode from three preset modes and one customized mode. Press the P.STD button to select the desired picture quality. Four kinds of picture modes (i.e., "Standard","Bright", "Soft", "User" ) can be selected in turn. User A spare setting that ca
Краткое содержание страницы № 20
Picture Control Functions Aspect Ratio Control Press the ZOOM button the Aspect Ratio menu appearance on the screen. 4:3 mode Choose 4:3 when you want to view a picture with an original 4:3 aspect ratio, with gray bars appearing at both the left and right sides. Full Screen Choose Full Screen when you want to adjust the picture horizontally, in a linear proportion to fill the entire screen. Cinema mode Choose cinema mode when you view the film picture to be altered, the
