Краткое содержание страницы № 1
USER’S MANUAL
MANUEL D’UTILISATION
MANUAL DEL USUARIO
Краткое содержание страницы № 2
Index Warning .................................................................................................................... 1 Contents ...................................................................................................................2 Quick Start ..............................................................................................................3 Controls ........................................................................................................
Краткое содержание страницы № 3
WARNING TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO, DO NOT USE THIS UNIT’S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS UNLESS THE PRONGS CAN BE FULLY INSERTED. REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. CAUTION CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, MAKE SURE POWER CORD IS UNPLUGGED FROM WALL SOCKET. TO FULLY DISENGAGE THE POWER TO THE UNI
Краткое содержание страницы № 4
Contents Your new NEC LCD monitor box* should contain the following: • LCD monitor • Power Cord • User’s Manual • Video Signal Cable • Base Stand • Cable Holder LCD Monitor (Stand not connected) Power Cord Video Signal Cable (15-pin mini D-SUB to 15-pin mini D-SUB male) USER’S MANUAL MANUEL D’UTILISATION MANUAL DEL USUARIO User’s Manual Cable Holder * Remember to save your original box and pa
Краткое содержание страницы № 5
Quick Start To attach the Base to the LCD Stand: 1. Insert the front of the LCD Stand into the holes in the front of the Base (Figure 1). 2. Next, position the locking tabs on the back side of the LCD Stand with the holes on the Base. Lower the Stand until locking tabs are secure. Figure 1 Stand Locking Tabs Front Base To attach the LCD monitor to your system, follow these instructions: 1. Turn off the power to your computer. 2. For the PC with Analog output: Connect the 15-pin mini D-SUB s
Краткое содержание страницы № 6
Краткое содержание страницы № 7
Quick Start –continued Tilt Grasp both sides of the monitor screen with your hands and adjust the tilt as desired (Figure TS.1). Figure TS.1 NOTE: Handle with care when tilting the monitor screen. Remove Monitor Stand for Mounting To prepare the monitor for alternate mounting purposes: 1. Disconnect all cables. 2. Place monitor face down on a nonabrasive surface (Figure R.1). 3. Remove the 3 screws connecting the monitor to the stand and slide the stand off from the LCD (Figure R.1). The moni
Краткое содержание страницы № 8
Quick Start –continued Removing the Base Note: Always remove the Base when shipping the LCD. 1. Place monitor face down on a non-abrasive sur face. 2. Using your thumbs, press the quick release button Quick release button to unlock the stand. 3. Pull the unlocked base off the stand. Connecting a Flexible Arm This LCD monitor is designed for use with a fl exible arm. Please use the attached screws (4pcs) as shown in the picture when installing. To meet the safety requirements, the monitor m
Краткое содержание страницы № 9
Краткое содержание страницы № 10
Controls –continued ADJUSTING THE PICTURE The description for function-control LEDs Main Main Sub Sub Menu Menu Menu Menu Description Item Icon Item Icon Adjust the image brightness in relation to Contrast the background. Luminance Adjust the overall image and background Brightness screen brightness. Adjust Picture Phase to reduce Horizontal- Focus Line noise. Image Setup Adjust the picture Clock to reduce Vertical- Clock Line noise. Adjust the horizontal position of the pic- H.Position ture.
Краткое содержание страницы № 11
Controls –continued Main Main Sub Sub Menu Menu Menu Menu Description Item Icon Item Icon H.Position Adjust the Horizontal position of the OSD. OSD Adjust the Vertical position of the OSD. Setup V.Position OSD Adjust the OSD timeout. Timeout Language Language N/A Set OSD language. Show the resolution, H/V frequency, Serial Information Information N/A No., DDC/CI Enable/Disable and input port of current input timing. Yes N/A Clear each old status of Auto-confi guration. Reset No N/A Do not e
Краткое содержание страницы № 12
Recommended Use Safety Precautions and Maintenance FOR OPTIMUM PERFORMANCE, PLEASE NOTE THE FOLLOWING WHEN SETTING UP AND USING THE LCD COLOR MONITOR: � DO NOT OPEN THE MONITOR. There are no user serviceable parts inside and opening or removing covers may expose you to dangerous shock hazards or other risks. Refer all servicing to qualifi ed service personnel. � Do not spill any liquids into the cabinet or use your monitor near water. � Do not insert objects of any kind into the cabinet slots
Краткое содержание страницы № 13
Recommended Use –continued CORRECT PLACEMENT AND ADJUSTMENT OF THE MONITOR CAN REDUCE EYE, SHOULDER AND NECK FATIGUE. CHECK THE FOLLOWING WHEN YOU POSITION THE MONITOR: � For optimum performance, allow 20 minutes for warm-up. � Adjust the monitor height so that the top of the screen is at or slightly below eye level. Your eyes should look slightly downward when viewing the middle of the screen. � Position your monitor no closer than 16 inches and no fur
Краткое содержание страницы № 14
Specifi cations Monitor LCD19WV Notes Specifi cations Monitor LCD Module Diagonal: 19.0 inch Active matrix; thin fi lm transistor (TFT) Viewable Image Size: 19.0 inch liquid crystal display (LCD); 0.285 mm dot 2 Native Resolution (Pixel Count): 1440 x 900 pitch; 300cd/m white luminence; 1000:1 contrast ratio, typical; Time 5ms response Input Signal Video: ANALOG 0.7 Vp-p/75 Ohms Sync:Separate sync TTL Level (Positive/Negtive) Display Colors Analog input: 16.7
Краткое содержание страницы № 15
Specifi cations -continued Monitor LCD22WV Notes Specifi cations Monitor LCD Module Diagonal: 21.6 inch Active matrix; thin fi lm transistor (TFT) Viewable Image Size: 21.6 inch liquid crystal display (LCD); 0.285 mm dot 2 Native Resolution (Pixel Count): 1440 x 900 pitch; 300cd/m white luminence; 1000:1 contrast ratio, typical; Time 5ms response Input Signal Video: ANALOG 0.7 Vp-p/75 Ohms Sync:Separate sync TTL Level (Positive/Negtive) Display Colors Analog
Краткое содержание страницы № 16
Features Reduced Footprint: Provides the ideal solution for environments requiring superior image quality but with size and weight limitations. The monitor’s small footprint and low weight allow it to be moved or transported easily from one location to another. No-touch Auto Adjust™: No-touch Auto Adjust automatically adjusts the monitor to opti- mal settings upon initial setup. ® ® Plug and Play: The Microsoft solution with the Windows operating system facilitates setup and installation by
Краткое содержание страницы № 17
Troubleshooting No picture � The signal cable should be completely connected to the display card/computer. � The display card should be completely seated in its slot. � Front Power Switch and computer power switch should be in the ON position. � Check to make sure that a supported mode has been selected on the display card or system being used. (Please consult display card or system manual to change graphics mode.) � Check the monitor and your display card with respect to compatibility and reco
Краткое содержание страницы № 18
References NEC Monitor Customer Service & Support Customer Service and Technical Support: (800) 632-4662 Fax: (800) 695-3044 Parts and Accessories/Macintosh Cable Adapter: (800) 632-4662 Warranty Information: www.necdisplay.com Online Technical Support www.necdisplay.com Sales and Product Information Sales Information Line: (888) 632-6487 Canadian Customers: (866) 771-0266, Ext#: 4037 Government Sales: (800) 284-6320 Government Sales email: gov@necdisplay.com Electronic Channels World Wi
Краткое содержание страницы № 19
Limited Warranty NEC Display Solutions of America, Inc. (hereinafter “NEC DISPLAY SOLUTIONS”) warrants this Product to be free from defects in material and workmanship and, subject to the conditions set forth below, agrees to repair or replace (at NEC DISPLAY SOLUTIONS’ sole option) any part of the enclosed unit which proves defective for a period of one (1) year from the date of rst consumer purchase. Spare parts are warranted for ninety (90) days. Replacement parts or unit may be new or
Краткое содержание страницы № 20
TCO’03 Congratulations! The display you have just purchased carries the TCO’03 Displays label. This means that your display is designed, manufactured and tested according to some of the strictest quality and environmental requirements in the world. This makes for a high performance product, designed with the user in focus that also minimizes the impact on our natural environment. Some of the features of the TCO’03 Display requirements: Ergonomics � Good visual ergonomics and image qualit
